Callout 1 of 3
Flat extensions, falls and what the coverings last
Few flat roofs are truly level, and none should be. Each needs a fall, a slight slope that sends water to an outlet, and a roof that has lost its fall holds a pond, which ages the covering from underneath. The standard for flat roofs with flexible coverings is BS 6229:2025, and it replaced the 2018 edition, which was withdrawn on 16 December 2025. It applies to membranes on roofs of ten degrees or less, and it does not cover lead. The NFRC, the roofing trade body, reads the standard as asking for "a minimum 1:80 finished fall for general roof areas and internal gutters". IKO, a membrane manufacturer, recommends drawing the roof at 1:40.
The covering decides how long a flat roof lasts, and the published ranges disagree. For EPDM, a rubber membrane, HomeBuilding gives 25-30 years and Less gives 30 to 50 years. GRP, glass-reinforced plastic, is given 25-30 years by HomeBuilding and 25 to 40 years by Less. Felt is shorter: HomeBuilding says 10-15 years and Less says 10 to 20. Treat them as typical ranges, not promises; the survey tells you which covering you actually have.
On an extension or garage roof, a straight edge shows the fall, and then we work through the upstands (the upturned lips of membrane that climb a wall), the laps and seams, and each outlet. Blisters and splits get photographed. A pond that dries within a day or two may point to a slight dip, and one that stays points to a failed fall. A small split in a sound membrane can be repaired. Membrane that has turned brittle over the entire roof will not be rescued by patching.
Laying new waterproofing over a flat roof is treated as renovation by AD L 2021, so the insulation figures in Table 4.3 come into play. That is a Building Regulations question, so building control should hear about a full recovering. A flat roof also tends to be reached from a ladder at a single point, so we note where the access is, because a hatch or a tight side return changes how the covering is delivered and laid. Our flat roofing page describes each covering, and the price we send afterwards is one total in writing.
Flat covering terms on a Redhill extension
- Fall
- The slope that carries water to an outlet
- Upstand
- The upturned edge where the membrane climbs a wall
- Lap
- Where one sheet overlaps the next
- Outlet
- The drain where the roof discharges
- Membrane
- The waterproof sheet over the deck
Standing water points first to the fall of the deck, and only then to the membrane.















