01432 610152 Get a quote Call 01432 610152

Roofers in Newton Farm

Valley lead, roof windows and gutters for homes in Newton Farm, south of the centre.

A Newton Farm survey ends with photographs of every fault found and one total price set out in writing.

Get a free quoteCall 01432 610152

Where a Newton Farm roof gives way

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Valleys that collect leavesThe inside angle between two slopes carries the most rain and clogs first.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Roof windows and their sealsA window set into the slope needs flashing that still lies flat and tight.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Gutters running out of fallA sagging run overflows at the joints and wets the wall below.

Where we reach Newton Farm

Newton Farm on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Newton Farm: valleys, windows and gutters

Valley, window, gutter: how we read a Newton Farm roof in order

The Newton Farm survey follows the drainage of the roof: first the valley that forms where two slopes come together, then any roof window cut into the slope, and last the gutter that carries the water away from the house.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Valley; 2 Roof window; 3 Gutter run.

Fig. 1 The roof of one house in section, with the three Newton Farm callouts marked.

Callout 1 of 3

The valley where two Newton Farm slopes meet

A valley is the inward-angled join where the roof's two slopes come together, and the runoff from both of them pours down that single line. No other joint on a pitched roof drains so much water in one place. Some valleys are lined with lead, laid in a channel between the tiles. Others are formed from tiles cut to meet along a line, with a lead or plastic liner hidden below. We look at which kind you have before anything else, because the two fail in different ways.

On a lead valley we check for splits along the folds, for edges that have lifted and for a build-up of leaves and moss that dams the channel. Royston Lead's table lists Codes 4, 5, 6, 7 and 8 for a pitched valley gutter, and each step up the codes is a thicker sheet, heavier per square metre. Which code we propose follows from how long the channel is and how steep the slopes beside it are. Code 3 is "Recommended for lead soakers only", so it is never used in a valley, and a hurried patch in the wrong gauge is one of the things the survey photographs are there to catch. On a tiled valley we lift the cut tiles at the edge and look at the liner beneath, because a torn liner shows nowhere on the surface.

Valleys collect what the roof sheds: leaves, moss, the odd tile fragment. A choked valley pushes water out sideways beneath the tiles, and the first sign inside the house can be a stain on a ceiling below a spot that looks dry from the garden. We clear the channel by hand, photograph the metal or liner before and after, and show you the pictures. A jet wash is not part of the clean: Marley, the tile maker, warns against jet washes of high power because the force can mark slate and tile and shorten their life.

MyJobQuote says correctly installed lead flashing "can last for over 80 years", which tells you lead in good order is worth keeping. When a valley is past saving, we strip the affected stretch, renew the underlay and battens beneath, and fit new lead. Our lead roofing page explains the codes and the dressing in more depth, and the price you receive after the survey is one total, sent in writing before any work starts.

A valley channel on a Newton Farm roof

SoundChannel clear, lead flat at the edges, no splits
Needs workLeaves dam the channel, lead split along a fold

Everything draining off both slopes ends up in the valley, which makes it our first stop.

Callout 2 of 3

Roof windows and what the rules ask of them

Lying flush with the slope, a roof window is framed in timber and sealed by flashing on all four sides. Skylights come in other forms too, and a rooflight can be a glazed unit that stands up from a flat roof. The difference matters because the energy rules treat them differently. For an existing dwelling in England, AD L 2021 Table 4.2 asks for a roof window of 1.4 or Window Energy Rating Band B, with the same table setting a rooflight apart at 2.2 of its own.

Newton Farm is in England, so those English tables apply here. A new roof is covered by Table 4.2, but a loft being converted falls under Table 4.3, where the roof threshold is 0.35 and the improved figure is 0.16. From 24 March 2027, AD L 2026 Tables 3.2 and 3.3 take over. Our survey notes which table your job falls under, so the glazing you buy meets the right figure.

Fitting a window is a structural operation as well as a watertight one. An opening cuts through rafters, and the timber around it is trimmed to carry the load that the cut rafters used to share. We set that framing out on site and flash the frame in a stepped sequence, working from the bottom edge up. If the existing window leaks, the usual suspects are a perished seal, a flashing that has lifted at a corner, or a frame that has dropped slightly. A like for like swap, taking out the old unit and fitting a new one in the same opening, is simpler than cutting a new opening. It also leaves the rafters as they were. When the old frame is rotten at the sill, you are shown the timber, and the new unit comes with fresh flashing in every case, since old lead dressed round a previous frame may not sit properly against a new one. Our Velux and skylight installation page covers both.

Planning permission for a new window turns on the property and its surroundings. Several conservation areas lie near Newton Farm, including Aylestone Hill, Hafod Road and Hampton Park, and flats do not have the rights that houses have. Rather than summarise the conditions here, we point you to our planning guide for roof windows, which sets them out. Before you order a window, ask Herefordshire Council whether an Article 4 direction applies to your street.

A question we answer on site

Does a roof window count as a rooflight?

No. Building Regulations treat a roof window, set in the plane of the slope, as a window, and a rooflight as a glazed unit on a flat or low roof. They carry different energy figures, so the survey records which one you have.

Fig. 3 Roof windows, drawn close

Callout 3 of 3

Gutters, nests and the wall below the eaves

The last callout is the gutter, which collects the water from the whole roof and takes it to the downpipes. A gutter has to lie at a slight fall toward its outlet, and Brett Martin, a gutter maker, gives the figure as "1mm for every 600mm". Where a length has dropped between two brackets it keeps a puddle, and that puddle spills over at the nearest joint. We sight along the gutter with a level, then check the brackets, the joints, the stop ends and the outlets.

Beyond the gutter lie the fascia, the board that holds it, and the soffit, the underside lining of the eaves overhang. A rotten fascia cannot hold a bracket, so a new gutter fitted to bad timber fails again. Work along the eaves can also disturb wildlife. Section 1 of the Wildlife and Countryside Act 1981 makes the offence one of acting intentionally against a nest at a time when birds occupy it or are still putting it together, so a nest tucked into the end of a gutter can hold up a job for a while. The law also shields bats and the places they roost, with any English licence issued by Natural England. Should we come across signs of either, work pauses and we ring you before anything else is done.

Newton Farm sits south of the city centre, 1.8 road miles from the city's centre. Grafton Bank, Grade II (list entry 1280105, first listed 27 July 1994), is a listing on the national register close to Newton Farm. The conservation areas nearby on Herefordshire Council's list are Widemarsh Common, Hampton Park, Aylestone Hill and Hafod Road. If your own house turns out to be listed, section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 requires consent before works affecting its character, while the Historic England list shows whether an address carries a grade.

Working at the eaves can mean scaffold. We arrange the licence with our scaffolder when it stands on the highway, and the details are in the questions below. Building control is Herefordshire Council Building Control, on 01432 261938. Our guttering, soffits and fascias page sets out the options in more detail.

Eaves words in plain English

Fascia
The board along the eaves that carries the gutter
Soffit
The panel closing the underside of the overhang
Stop end
The cap that closes the end of a gutter run
Outlet
The opening where the gutter feeds the downpipe

Newton Farm roofs: valleys, windows, gutters and cost

How do you check the valleys on a Newton Farm roof?

We first work out whether the valley is lead-lined or built from cut tiles over a hidden liner. On a lead valley we look for splits, lifted edges and blocked channels. On a tiled one we lift the edge tiles and inspect the liner. Both get photographed before and after cleaning, and the pictures arrive with the written price. Only the stretch that has failed is renewed.

Which conservation areas lie close to Newton Farm?

Four lie close by, namely Hafod Road, Widemarsh Common, Aylestone Hill and Hampton Park. Herefordshire Council holds the boundaries, so look at its map for your own street before deciding whether your house is inside one. Herefordshire has 64 conservation areas in all. Ask the council, too, whether an Article 4 direction applies, before you change anything visible from the street.

What do you do if there are nesting birds or bats at the eaves?

We stop and tell you. Under the Wildlife and Countryside Act 1981 the offence is acting intentionally against a nest that is occupied or being built, so a live nest changes the plan. Bats are protected too, and in England any licence comes from Natural England. We reschedule the job around what we find and note it in the report.

What does a new roof cost for a Newton Farm home?

Which? put a full re-roof, for an average three-bedroom property, at "£7,000-£21,000" in its November 2025 survey, ex VAT. HomeBuilding, on 30 September 2025, gave £10,000 to £15,000 for a 65 m² semi-detached house in plain concrete tiles. Your own figure depends on the size, the covering and the access. When the survey has been completed you get a single written total, with the scaffold allowed for.

Do I need Building Regulations approval to re-roof in Newton Farm?

England has the Planning Portal test: keep below 25 per cent of the building envelope and below 50 per cent of the roof, and normally you need not apply at all. A larger re-roof is a question for building control. Herefordshire Council Building Control can be reached on 01432 261938, and a registered building control approver is the private route. Either will tell you how Part L applies to the job.

Who licenses scaffold on a Newton Farm street?

Herefordshire Council is the highway authority for Newton Farm streets. Herefordshire Council charges £167 for a licence that lasts a maximum of one month, then £123 for each further month, and asks for at least 10 days' notice. We arrange the licence with our scaffolder, and the price you are given allows for the scaffold. The Highways Licensing team at the council takes calls on 01432 261800 and can tell a Newton Farm owner who runs the road outside.

Get a Newton Farm roof surveyed

Describe the roof or attach a photo, and we will trace its drainage from valley to gutter and put the price in writing.

10-year workmanship guarantee, in writing