Callout 1 of 3
Ridge capping on tile, slate and thatched houses
The ridge runs along the crown of the roof, where the two slopes come together, and the ladder check starts there. Capping tiles lie along it, bedded on mortar or else secured with clips and screws as a dry-fix arrangement, a method BS 8612 covers. In 1932 the Royal Commission on Historical Monuments went through the houses of Hampton Bishop parish (monuments 3 to 24) and wrote that their roofs were covered with "tiles, slate or thatch". That sentence is a good warning that neighbouring ridges cannot be assumed to match: a clay cap on one house, a concrete one on the next, and on a thatched roof a ridge that belongs to a specialist thatcher.
Tap a capping tile and feel for movement: one that shifts under a gloved hand has lost its bed. Cracked or crumbling mortar between the caps lets damp creep down to the top course and the battens below. We also check the end of each run, meaning the last cap at each gable and the junction with any hip. A hip is the angled edge that runs down from the ridge at an external corner, and its caps have to stay tight where the run turns. At the point where the ridge ends against a stack or a taller wall, the lead tucked in is checked as well. Marley's guidance is plain that "Installing to BS 5534 isn't required by law" and that "mortar could no longer be relied upon as the only means of securing the roof covering". Each cap we refix therefore gets a mechanical fixing, and the bedded appearance stays wherever the house was built that way.
Look along the ridge from the lane. A line that dips or waves may have nothing wrong with the caps at all; the cause can sit in the timbers underneath, and the loft inspection confirms that before a cap is touched. Should the loft show a covering past saving, a heavier replacement is a separate matter: according to the Planning Portal, approval and a structural check are needed once a new covering weighs 15 per cent or more over the old. Our pitched roofing page explains a complete re-covering, battens upward, with every stage photographed for you.
Ridge parts on a Hampton Bishop house
- Capping tile
- The cap that sits over the top joint
- Bedding
- Mortar under the cap, tapped for hollow patches
- Dry-fix clip
- Holds the cap without mortar, under BS 8612
- Hip end
- Where a ridge meets the sloping outside corner
- Gable end
- The last cap, checked for slip and open joints
On this ridge each cap is looked at singly, because neighbours differ.















