01432 610152 Get a quote Call 01432 610152

Roofers in Bromyard

Roof repairs and re-roofs for Bromyard's old centre and the homes that surround it.

We start on the tiles, show you photographs of what we find and give one price for the whole job in writing.

Get a free quoteCall 01432 610152

Three weak points on a Bromyard roof

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Tiled slopes over rubble wallsA 1932 survey of the town's almshouse recorded rubble walls under a tiled roof.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Lead beside listed wallsValleys and flashings on listed buildings need careful lead and the right consent.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Eaves, fascias and guttersA blocked ventilation gap at the eaves lets damp build up in the loft.

Around and about Bromyard

Bromyard on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Bromyard roofs, tile to eaves

Three checks on a Bromyard roof: the tiled slope, the lead and the eaves

We take the roof in the order of a survey: the tiled slope first, then the lead at valleys and abutments, then the eaves, with the listed buildings and the conservation area noted where they matter.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Tiled slope; 2 Valleys and lead; 3 Eaves and church.

Fig. 1 A border house in section, with Bromyard's three callouts numbered.

Callout 1 of 3

Tiles on rubble walls: reading the Bromyard slope

A survey in Bromyard starts on the main slope, the broad area of covering between the ridge and the eaves. The Royal Commission's 1932 inventory of Herefordshire recorded of the Almshouse in the parish that "the walls are of rubble and the roofs are tiled." One building cannot describe a town, and that entry says nothing about the tiles on your house. It does show a pairing worth keeping in mind, a stone wall carrying a tiled roof, where the slope and the masonry beneath it are read as one structure.

On the slope we look for tiles that have slipped, cracked or lifted at the edge. Each tile hangs from a timber batten on a small projecting nib, and when the nib snaps or the nail rusts through, the tile slides and leaves a gap. A gap matters because the underlay, the membrane laid over the rafters beneath the battens, then takes the rain the tile should have shed. We check the batten and the underlay at every gap, and a photograph of each puts the fault in front of you before any decision is made. Age is a range and not a deadline: Marley expects roof tiles to last around 60 years, while HomeBuilding gives plain concrete tiles 40 to 50 years. The survey names the tile on your roof, so the right range applies, and a clay tile is the only kind to which the BRE's 60-year minimum belongs.

A replacement tile should match its neighbours in size, thickness and colour, because one odd tile shows from the lane for years. The gable end gets the same attention. There the covering stops short of the wall, and that finishing line is the verge. Where mortar has dropped out, the end tiles are left loose in a strong gust. A rebed is one repair, a mechanical fix at each end tile is another, and we say which the roof needs. BS 8612 covers dry-fix verge and ridge systems for houses that suit them, while an older house may keep a mortared edge with fixings added beneath it.

A slope that has worn out is a different question. On English ground, the Planning Portal sets its cut-off for a re-roof at under 25 per cent of the building envelope together with under 50 per cent of the roof, and below both figures no application is normally needed. A covering that is 15 per cent or more heavier brings in Building Regulations approval and a structural check, because the rafters were sized for the first covering. Our pitched roofing page covers re-covering a whole slope.

Checked across a Bromyard slope

  • Tiles with snapped nibs or rusted nails
  • Cracked or lifted edges along the verge
  • Battens and underlay at every gap
  • Replacement tiles matched in size and colour

A tile that has slid is a small repair until the batten beneath it rots.

Fig. 2 The slopes, drawn close

Callout 2 of 3

Valleys, flashings and the lead beside listed walls

Run two slopes into each other and the inside corner between them is a valley, carrying the run-off of both. On an old building it can be lined with lead, a sheet metal dressed into the shape of the joint. The Bay Horse Inn and Tower Hill House are both listed Grade II* in Bromyard (list entries 1349643 and 1349646, each first listed 25 October 1951), and the Church of St Peter is Grade I. Those entries do not tell us what lies in their valleys. They do show that roof work in the town can fall under listed building rules, and that changes how a lead valley is replaced.

From the slope we look for torn lead, fatigue cracks along the folds and leaves or moss lodged in the channel. From the loft we look for stained rafters beneath the valley, because a leak there shows inside before it shows outside. Royston Lead lists its sheet by thickness, with a code number and a use against each. Code 4 and Code 5 are both listed for pitched valley gutters, Code 5 is listed for parapet and box gutters as well, and Code 3 is "Recommended for lead soakers only". A soaker is the little folded sheet that tucks beneath each course beside a wall or chimney. We pick the code for the position, then lay the sheet loosely enough that it can move in the heat without tearing.

Lead flashings, the strips turned into a wall and lapped over the tiles, fail at the top edge, where the joint they sit in has opened. MyJobQuote says correctly installed lead flashing "can last for over 80 years", which is a reason to repair a flashing that has lifted and not to cover it. We lift the lead, check the mortar joint beneath it and refix it into fresh pointing. Sealant smeared over a split hides the fault and leaves it growing. Once the new lead is in, we photograph the finished valley and the flashings from the same angles as the before pictures, so you can compare the two.

Under section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990, a listed house needs consent before any work that affects its character. Its permitted development rights stay in place, with listed building consent added as a further step, so a new valley or flashing is agreed with Herefordshire Council first. Our lead roofing page covers valleys and flashings, and the listed and heritage roofing page covers work on protected houses.

Lead at a Bromyard valley

Valley liner
Lead sheet dressed into the angle between two slopes
Soakers
Small folded pieces under each course beside a wall
Flashings
Strips turned into the wall and lapped over the tiles
Pointing
Fresh mortar in the joint that holds the flashing

Sealant over split lead hides the fault and leaves it growing.

Fig. 3 The valley, drawn close

Callout 3 of 3

The eaves, St Peter's and Bromyard's conservation area

Our third stop on a Bromyard roof is down at the eaves, where the slope ends over the wall and the gutter hangs. We check the eaves from the ground and from inside the loft: the timber ends, the fascia (the board across the rafter ends) and the gap that lets air into the roof space. Marley's guidance for a cold roof beneath high-resistance underlay is a 25mm gap along the eaves at pitches of 15° or less and 10mm above that, since air has to move through a roof space that the underlay itself will not ventilate. Insulation pushed hard into the eaves blocks that path and lets condensation settle on the timbers. Brett Martin advises "1mm for every 600mm" of fall along a gutter, and a run that has dipped between its brackets holds standing water and spills it onto the wall below.

The Church of St Peter is Grade I (list entry 1307758, first listed 25 October 1951). Which consent route a church follows depends on its denomination and on whether services still take place there, so before anything is planned we put the question to the body that looks after the church. Listed building consent from the council is the route for a closed church and for Quaker and Unitarian meeting houses, and the same is true of a church held by the Churches Conservation Trust.

Herefordshire has 64 conservation areas, and its council's list gives the Bromyard one a designation date of 1997. Whether an Article 4 direction applies to your street is a question for Herefordshire Council, best asked before you plan any change to a roof that faces the road. New openings in a roof slope raise the sharpest questions, and our planning guide for roof windows works through them.

Building control for a Bromyard address is Herefordshire Council Building Control, on 01432 261938, or a registered building control approver if you prefer a private route. Bromyard is 14 road miles north-east of Hereford, about 24 minutes by road, so eaves, gutters and the roof above them can be surveyed in one visit.

The loft can show what the eaves are doing before the ceiling does.

An eaves on a Bromyard house

SoundVentilation gap open, fascia firm, gutter falling to its outlet
Needs workGap choked with insulation, fascia soft, gutter holding standing water

Bromyard roofs: tiles, lead and listed buildings

What does a survey look for on a tiled roof in Bromyard?

We start on the slope for slipped, cracked or lifted tiles and snapped nibs, then check the battens and underlay under each gap. Next come the verge mortar, the ridge, the valleys and the lead at any wall or chimney. Inside the loft we look for daylight, stained rafters and a blocked eaves gap. Each fault is photographed, so the report shows you what we found and where.

Does the Bromyard conservation area change how a roof is repaired?

Herefordshire Council's list gives the Bromyard conservation area a designation date of 1997. Whether your address sits inside the boundary is a question for the council, which also holds the answer on any Article 4 direction. Mending what is there in the same material is a smaller question for the council than a new opening. Roof windows and dormers are covered in our planning guide, which is worth reading first.

Do the listed buildings in Bromyard mean a repair needs consent?

Only a listed building itself needs it. The Bay Horse Inn and Tower Hill House are Grade II*, and the Church of St Peter is Grade I. For a listed house, section 7 of the 1990 Act requires listed building consent where works affect its character, and its permitted development rights stay in place beside that. We settle the materials and method with Herefordshire Council before any covering comes off.

Does re-roofing a Bromyard house need Building Regulations approval?

Bromyard is in England, so the Planning Portal's two-part test is the starting point: under 25 per cent of the building envelope and under 50 per cent of the roof, and normally nothing needs to be applied for. Insulating the roof brings in Part L, where AD L 2021 Table 4.3 sets a threshold of 0.35 and an improved figure of 0.16 until the 2026 edition takes over on 24 March 2027.

How does a scaffold licence work for a Bromyard street?

Highways Act 1980 section 169 makes a licence necessary for any scaffold that obstructs the road or pavement. Herefordshire Council's fee is £167 for a maximum of one month, £123 for each month added after that. The application must reach the council at least 10 days before the scaffold is erected. We arrange the licence with our scaffolder. Herefordshire Council Highways Licensing takes calls on 01432 261800, and National Highways deals with trunk roads and motorways.

Can work on the Church of St Peter in Bromyard go ahead without listed building consent?

That depends on the church's denomination and on how the building is used, and the church's own governing body can say. An Anglican church still in use works through the faculty jurisdiction. Once worship has stopped, a church comes under the council's listed building consent, as Quaker and Unitarian buildings always do, so the answer on St Peter's starts with its denomination.

Have a Bromyard roof surveyed, tile to eaves

Tell us about the roof or attach some photos, and we will survey from slope to eaves and write one price for the job.

10-year workmanship guarantee, in writing