01432 610152 Get a quote Call 01432 610152

Roofers in Milkwall

Flat roofs, conservatory roofs and wall junctions put right in Milkwall, in Coleford parish.

Our survey photographs the problem on your own house, and we write the whole job up as one total price.

Get a free quoteCall 01432 610152

Three weak spots on Milkwall extensions and lean-tos

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Flat roofs that pondWater standing after rain means the fall has gone, and the membrane suffers.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Ageing conservatory roofsA conservatory roof ages faster than the house, and replacing one has rules.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Lead at the wall edgeLead along a wall can split or lift, and rain gets behind it.

Placing Milkwall

Milkwall on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Milkwall roofs, flat to wall

Milkwall in three parts: the flat roof, the conservatory roof and the wall junction

Milkwall surveys here turn on the add-ons to a house: the flat roof over an extension, a conservatory roof, and the lead strip along a house wall. Each has its own failure points and its own rules, and the survey takes them in that order.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Flat roof; 2 Conservatory roof; 3 Wall junction.

Fig. 1 A Milkwall house in section: flat roof, conservatory glazing and wall junction, numbered 1 to 3.

Callout 1 of 3

The flat roof: fall, membrane and ponding

Nobody's flat roof is truly level. It needs a gentle slope so rain runs to the outlet or gutter, and when that slope is lost, water stands on the surface. NFRC reports that BS 6229:2025 sets "a minimum 1:80 finished fall for general roof areas and internal gutters", while IKO, a membrane maker, advises designing for 1:40 so that a finished 1:80 is reached. That standard is current (the 2018 edition was withdrawn on 16 December 2025), and it covers waterproof membranes, not lead. After rain we look for ponds, and for the stained rings left where a pond dried out.

What covers the deck matters as much as the fall. Sources give a spread of lifespans, so we pass on both ends. For EPDM, a synthetic rubber sheet, HomeBuilding says 25-30 years while Less says 30 to 50. GRP, glass-reinforced plastic laid as one moulded skin, runs 25-30 years in HomeBuilding and 25 to 40 in Less. Torch-on felt is shorter: HomeBuilding gives 10-15 years and Less 10 to 20. None of these is a promise, and a poor detail at an outlet or an upstand can shorten any of them. A split or a lifted edge is repaired where the rest of the roof is sound, and the report says so.

A full replacement drags the energy rules in with it. Under AD L 2021, stripping and re-laying the weatherproof layer of a flat roof counts as renovation, so Table 4.3 applies, with a threshold of 0.35 and an improved figure of 0.16. The Planning Portal adds a threshold of its own for England: an application is normally avoided while the work stays under 25 per cent of the building envelope and under 50 per cent of the roof. Where the flat roof belongs to a flat in a block, the permitted development picture is different, because flats carry no householder rights.

The survey report lays the choices out with photographs of the deck, the upstands and the outlets, so you can see what each option answers. An upstand is the short upturned edge of the membrane against a wall, and a flat roof can fail there, so we press along it with a gloved hand to feel for lifting. The outlet gets the same attention: debris in the outlet, a cracked collar or a cover that has gone will each send water the wrong way. Our flat roofing page explains the coverings one at a time.

What moves the figure on a flat roof job

Roof area and shape
Larger or more broken roofs need more material and time
Deck condition
Rotten boards must be replaced before any covering
Chosen covering
EPDM, GRP and felt each carry a different cost
Insulation
Part L may require a thicker build-up
Access and scaffold
Height and site layout change the access needed

One written total price, never itemised.

A pond that dries leaves a ring, and the ring shows where the fall has gone.

Fig. 2 Flat roofs, drawn close

Callout 2 of 3

Replacing a conservatory roof, and the rules for it

A conservatory roof sits in more heat, cold and sun than the house behind it, and that exposure shows up in its life. HomeBuilding puts polycarbonate at a typical 10 years, while a retailer it quotes, Roofing Megastore's MD, puts glass at more than 30, which he calls likely, and a tiled roof in excess of 50. Those are hedged figures from one source, and they explain why an owner whose polycarbonate sheets have clouded or cracked may look at a different type of roof altogether.

The Planning Portal's line on this is short: a new roof "must comply with building regulations", so it has to be sound in structure, thermally efficient and ventilated. We therefore never assume a roof swap is exempt. Building control is asked first, before the design is fixed, and the answer goes into your report.

AD L paragraph 0.14 can place a conservatory outside the energy rules, but only while every one of its conditions holds. The room has to be at ground level, and its floor area must stay at or under 30m2. The glazing has to be to Part K. Whatever separated it from the house, whether wall, door or window, has to have been retained or, if removed, replaced. Finally, the heating system of the dwelling must not be extended into the conservatory or porch. Fail any single one and the exemption is lost, so extending the home's radiators into the room, for example, would end it.

A tiled roof brings a load the old frame may never have carried. The existing walls and foundations must be able to carry it, so the structure is checked before any order is placed, and a covering that adds 15 per cent or more in weight brings approval into the picture. Where the new roof meets the house wall, we look closely at the lead, because a junction like that is built to move and needs a proper flashing.

For roof windows or rooflights in the new roof, read the planning guide for roof windows first. Our conservatory roofs page describes the main types.

Exemption test for a conservatory

  • Built at ground level
  • Floor area not above 30m2
  • Glazing to the Part K standard
  • Separating wall, door or window kept or replaced
  • House heating not extended into it
Fig. 3 Roof windows, drawn close

Callout 3 of 3

Wall-edge lead and Milkwall's rules

A roof that butts against a house wall is sealed at the joint with a strip of lead. The top edge is tucked into a groove cut in the masonry and the lower edge is dressed over the covering. Royston Lead's table lists Codes 4, 5 and 6 for flashings, and MyJobQuote says correctly installed lead flashing "can last for over 80 years". That is a hedge from one source, so we study each length for splits at the folds, lifted edges, and pointing that has fallen from the groove. A leak here can run down the inner face of the wall, so the stain on the plaster may sit well away from the fault.

When the wall belongs next door, section 2(2)(j) of the Party Wall etc. Act 1996 allows the building owner to cut into the neighbouring owner's building to set in a flashing or weather-proofing. Notice goes from the owner to the neighbour; surveyors are appointed if the neighbour objects, or stays quiet for 14 days. Our lead roofing page covers abutments, valleys and lead flats. When we repair a run we also look at the first course of covering beside the wall, because water that has got behind the lead can lift the course beside it, and the photographs show the lead from above and the covering beneath it so you can judge the extent of the repair.

Milkwall lies in Coleford parish, to the south of central Hereford: 27.2 road miles, or about 42 minutes by car. Clearwell Conservation Area and Coleford Conservation Area are the closest. Planning sits with Forest of Dean District Council, which can say whether your address falls within either, and whether an Article 4 direction applies. Get that answer before you change a slope that faces the street.

Building control for a Milkwall address is the district council's own team, on 01594 812315, or a registered building control approver. Any scaffold on the road or footway falls under section 169 of the Highways Act 1980, which requires a licence; we arrange the licence with our scaffolder. The railway station nearest to the village is Lydney, 5.5 miles away as the crow flies.

Lead along a wall edge

SoundLead dressed flat over the covering, groove pointed tight
Needs workLead split at a fold, lifted edge, mortar gone from the groove

Milkwall roofs: flat roofs, conservatories and wall junctions

Why does a Milkwall flat roof hold water after rain?

The fall has probably gone, or an outlet is blocked. NFRC reports that BS 6229:2025 sets a minimum 1:80 finished fall, and IKO advises designing for 1:40 to achieve it. A pond that dries leaves a stained ring, which we photograph. Sometimes the deck can be reshaped, and sometimes a new covering is the better answer, so the report sets out what we find.

How many years can a flat roof covering at Milkwall be expected to last?

The sources disagree. For EPDM, HomeBuilding says 25-30 years and Less says 30 to 50. GRP is 25-30 in HomeBuilding and 25 to 40 in Less, and torch-on felt is 10-15 against 10 to 20. These are ranges and not promises, so what we see on your own deck counts for more than any table, and the survey says where yours sits.

Does a new conservatory roof in Milkwall need Building Regulations approval?

Ask building control first. The Planning Portal says a new conservatory roof "must comply with building regulations", so the body checking your job should hear about it before you order. Another point is the energy exemption that AD L paragraph 0.14 allows: every condition has to be met, and one is a floor area within 30m2. Forest of Dean District Council Building Control answers on 01594 812315, and we copy you on what it says.

Which conservation areas are close to Milkwall?

The nearest are Clearwell Conservation Area and Coleford Conservation Area, both bounded on the council's maps. The council can tell you whether your address lies inside either, and whether an Article 4 direction covers your street. The question comes up on the day of the visit, and the council's reply is written into your report so that it stays on file.

Who deals with a scaffold licence in Milkwall?

We arrange the licence with our scaffolder. Gloucestershire County Council charges £145 for a minimum of 28 days, then £36 per 7 days to extend if the scaffold stays longer, and expects the application at least 12 calendar days beforehand, and that wait is built into every date we give you for the work. Any access snag on the road, from parked cars to a narrow footway, is flagged at the survey, before a start is promised.

Can lead be fitted into a neighbour's wall at Milkwall?

Section 2(2)(j) of the Party Wall etc. Act 1996 allows a building owner to cut into the wall of an adjoining owner's building for a flashing. The owner serves the notice; a surveyor is needed only when the neighbour dissents, or does not answer inside 14 days. Written consent from the neighbour can avoid a dispute altogether, and the notice should be served before the date we agree for the work.

Book a Milkwall survey, flat roof first

Describe the extension, the conservatory or the wall junction, and the survey will cover it, with the price put in writing.

10-year workmanship guarantee, in writing