01432 610152 Get a quote Call 01432 610152

Roofers in Broadwell

Roof repairs and re-roofs for Broadwell, 24.1 road miles south of Hereford.

We follow the ridge line first, then the eaves, and report back with photographs and a single written price.

Get a free quoteCall 01432 610152

Ridge lines, soffits and outbuilding sheets

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Ridge and hip cappingCapping tiles shift when their bedding fails, so we press the whole line.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Soffits and guttersOlder soffit boards can contain asbestos, so they are identified before any are cut.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Whitehill FarmhouseThe nearest listed building is Grade II, so changes there need consent.

Roads into Broadwell

Broadwell on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Broadwell, ridge to roofline

Ridge, roofline and outbuilding: three checks on a Broadwell roof

We start on the ridge where the roof meets the sky, follow the run-off down to the soffit and gutter, and finish on the outbuilding sheets where asbestos questions arise.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Ridge and hips; 2 Roofline; 3 Sheet roofs.

Fig. 1 A Broadwell house in section: ridge, eaves and outbuilding roof.

Callout 1 of 3

Ridge lines, hips and Whitehill Farmhouse

The ridge is the top line of the roof, and a Broadwell survey starts there. Capping tiles run along it, bedded on mortar, and a hip, the sloping outside corner where two slopes meet, is finished in the same way. We press each capping tile for movement, look for mortar joints that have opened, and check the junction where the ridge meets each hip, since two lines of weather end at that point. Photographs of the ridge taken from above go into the report, because the view from the ground hides most of it.

BS 5534:2014+A2:2018 sets out how slates and tiles are fixed, and BS 8612 is the specification for dry-fix units on ridges, hips and verges, in which clips and screws hold the capping. Marley's line is that fitting to BS 5534 is not a legal requirement. Its point about mortar is narrower: since the 2015 amendments, it says, mortar cannot be the only thing holding the covering on. So every capping tile on a rebedded ridge is also screwed or clipped down, and we tell you which fixing was used and where.

The nearest listed building to Broadwell is Whitehill Farmhouse, Grade II (list entry 1299280, first listed 14 December 1983). Historic England's list entry is the place to check what is protected. For a listed house, section 7 of the 1990 Act asks for consent before work that affects its character, so Forest of Dean District Council hears about a ridge rebed, a different capping or a new covering before it is done. A house that is not listed needs none of that for a plain rebed. Our roof repairs page covers ridge and verge repairs in more depth.

After the ridge we look down both slopes from the top. Slipped tiles near the ridge line are visible from above even where the ground shows nothing, and so are cracked units, moss banks and a sagging line along the ridge board. Each is photographed where it lies.

Where ridge and hips meet, capping from three lines comes together, and that joint is the hardest on the roof to keep closed. We bed and fix those units first and work outward along each run, so that the awkward joint is not left to the end of the day. A ridge that has been rebedded properly carries a clean, straight line, and we photograph the finished ridge from the same positions as the first set so the two can be laid side by side.

On the Broadwell ridge line

  • Capping tiles that rock under a hand
  • Open or crumbling mortar between units
  • A mechanical fixing on every capping tile
  • The junction where ridge meets hip
  • A true line from end to end

From the ground you see the front of a ridge. From above you see all of it.

Fig. 2 The ridge, drawn close

Callout 2 of 3

Soffits, fascias and gutters along a Broadwell roofline

Callout two is the eaves, the lower edge where the roof overhangs the wall. The soffit is the board closing the underside of the overhang, the fascia is the board facing outward that carries the gutter, and the gutter takes the run-off from the slope. We check them in that order from a ladder, pressing each board for softness and sighting along each run for sag.

Brett Martin sets 1mm for every 600mm as the fall for a gutter. Between two drooped brackets a run holds standing water, and standing water can freeze, overflow or stain the wall beneath it. Re-hanging a run to its fall may be all it needs, and we say when new lengths are called for instead. A uPVC retailer puts board life at between 20 and 40 years, which is a seller's figure and not a promise, so we judge each board by how it feels under the blade.

Soffits need a second kind of care. HSE's list of places where asbestos turns up includes "AIB white soffit panels to underside of roof eaves", AIB being asbestos insulating board. HSE's advice for a building put up or refurbished before 2000 is to presume that asbestos is present in it. Most removal of AIB is licensed work, and licensed work is passed to a licensed firm. A soffit board that might be AIB is therefore identified before any saw or drill touches it, and you are told what it is.

Soffits also let the roof breathe. Marley's figures apply where the underlay is the high-resistance (HR) kind, which is not vapour-permeable: 25mm of ventilation along the eaves for a cold roof on a pitch of 15 degrees or less, and 10mm on a steeper one. New insulation pushed into the eaves can block that gap, so we check it before any is laid. When a fascia has gone soft we also look at the rafter feet behind it, the ends of the timbers that carry the roof, because a leak that has rotted a board can reach them. Capping, which is new boards fitted over sound old ones, suits timber that is still firm; where the timber behind is soft it is cut out first. Our guttering, soffits and fascias page covers the whole roofline.

Eaves checks on a Broadwell house

Fascia
Pressed along its length for soft timber
Soffit
Looked at for staining, gaps and a possible asbestos board
Gutter fall
Sighted from the high end to the outlet
Brackets
Tested for movement at every fixing
Eaves vent gap
Kept clear of insulation
Fig. 3 Eaves and gutters, drawn close

Callout 3 of 3

Garage and outbuilding sheet roofs in Broadwell

The third callout is a garage or outbuilding roof made of large sheets, a different job from a tiled house. HSE says AC roofs are always fragile, and that a building built or refurbished before 2000 should be assumed to contain asbestos. The first point decides how we work, because nobody should walk on those sheets and access is planned before anyone goes near the roof.

HSE's list of non-licensed work covers the careful removal of asbestos cement sheeting without breaking it up, including weathered cement that is otherwise in one piece. Sheets that are broken or substantially damaged, or removal that would break them up, such as dropping a roof, fall under notifiable non-licensed work instead. Sheets are not dropped, snapped or washed down, and each one comes off whole.

The waste is the next question. EM9, HSE's waste guidance, wants a lockable skip, and sheeting laid across an ordinary skip is no substitute. In England, the exemption from hazardous waste consignment notes for household waste leaves out asbestos waste, so a load from a roof job travels on a consignment note. We arrange both, and you see the paperwork.

When the sheets have reached the end of their life, the replacement is a decision about the building. A new covering might be profiled metal, fibre cement or a built-up flat roof, depending on the span, the pitch and what the garage is used for. Our roof replacement page covers the choice. The band below names what sets the price, and our written price comes after the survey.

Before any quote, the survey records what is up there: how many sheets, how they are fixed, whether any are translucent rooflight sheets, and what carries them. The purlins, the horizontal timbers or steel members beneath the sheets, are checked for rot or rust, and so are the fixings through the sheet crowns. Gutters on a sheet roof are looked at as well, since broken sheet edges can end up in them. Every finding is photographed, so the decision to keep, repair or replace can be made from the pictures.

What sets the price of a sheet roof

Roof area
The number of sheets and the length of every edge
Access
Safe working positions for fragile sheeting
Condition
Whole sheets or broken ones decide the method
Waste route
A lockable skip and the paperwork that travels with it
New covering
The material chosen for the span and the pitch

One written total price, never itemised.

Broadwell roofs: ridges, soffits, sheets and paperwork

Can a Broadwell ridge be rebedded without lifting the tiles around it?

Yes, where the neighbouring tiles are sound. The capping is lifted, the old mortar is cleared from the line and the ridge is bedded again with a mechanical fixing on each unit. The tiles on either side are pressed for slips before the new bedding goes on. If they are cracked or loose they are replaced in the same visit, and you see photographs of both.

Which conservation area is closest to Broadwell?

Coleford Conservation Area is the nearest to the village. The boundary map sits with Forest of Dean District Council, which can tell you if your address is inside and also whether an Article 4 direction applies. Like-for-like repairs raise fewer questions than a new covering or a new window, and our planning guide for roof windows covers the second of those in detail.

What should I do about Broadwell soffit boards that might contain asbestos?

Leave them alone, with no drilling, scraping or breaking. HSE's advice for a building put up or refurbished before 2000 is to presume asbestos is present, and its location list names AIB white soffit panels. Tell us, and the board is identified before any work begins. Removal of AIB is usually licensed work, and licensed work is passed to a licensed firm.

What do UK cost guides say about replacing ridge tiles on a Broadwell house?

The guides differ. Which?, in a November 2025 survey excluding VAT, gives £80 to £300 for putting in a new ridge tile. MyJobQuote gives an average of £225 to £550 for ridge tile replacement in 2026, with no VAT basis stated. Checkatrade lists ridge tile repairs at £50 to £70 per metre, excluding VAT. Those are UK ranges; our own price comes after the survey, as a single written total.

What is special about the joint where a Broadwell ridge meets its hips?

Capping from three lines meets there, so there are more cut edges and more places for mortar to open than anywhere else on the ridge. We bed and fix those units first, press every neighbouring tile, and check from above that no gap has been left between the last hip unit and the ridge. The finished joint is photographed from two sides, so you can see it closed.

Who checks a re-roof near Broadwell against the Building Regulations?

Building control is done by the council or by a registered building control approver. Forest of Dean District Council runs a building control service of its own, and private approvers register with the Building Safety Regulator, a requirement that began in England on 6 April 2024. Private building control existed before that date; only the registration is new. Ask the body you choose to confirm what the Planning Portal's test means for your roof.

Arrange a ridge-first survey in Broadwell

Send a note about the ridge, the eaves or the outbuilding roof, and we will survey it and write the price as one figure.

10-year workmanship guarantee, in writing