01432 610152 Get a quote Call 01432 610152

Roofers in St Briavels

Roof edges, roof windows and listed buildings in St Briavels, near the Wye Valley National Landscape.

We survey the verges first, photograph each fault, then write up one total price for the work.

Get a free quoteCall 01432 610152

St Briavels roofs: three things to settle first

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Gable vergesA verge held by crumbling mortar lets wind and rain in at the gable.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Roof windows and dormersNational Landscape land changes the rules for dormers, so plans need checking.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Listed roofsListed buildings here need consent for works that touch their character.

Finding St Briavels

St Briavels on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

St Briavels roofs, verge to window

Gable verges, roof windows and listed buildings across St Briavels

Our survey reads the gable verges first, then looks at roof windows and dormers in light of the National Landscape nearby, and ends with the listed buildings and the conservation area.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Gable verge; 2 Window openings; 3 Listed walls.

Fig. 1 St Briavels roof drawn in section, with the verge, the roof window and the wall numbered.

Callout 1 of 3

Gable verges and the stonework beneath them

A verge is the edge of the covering where it runs over a gable wall. It is the part of a roof that wind reaches first, and it depends on two things working together: the units that finish the edge, and the wall head beneath them. The Victoria County History's 1996 account of St Briavels describes the older parts of the village as "modest, two-storeyed, stone-built dwellings of the late 18th century and the early 19th". On a stone gable of that age, the wall head under the verge is masonry laid two centuries ago, and its state decides what a verge repair can rest on.

Edge units may sit on mortar or be held by clips and screws instead. Slating and tiling fall under BS 5534:2014+A2:2018, and dry-fix verge kits have their own specification, BS 8612. A dry verge can follow a wall that has shifted, because it does not rely on mortar staying put. A mortar-bedded verge suits a building whose appearance depends on it, and then the mortar has to be sound.

On the survey we press along the edge units and note any that rock. We check the course tucked under them, called the undercloak, and the mortar between the undercloak and the wall. Where mortar has crumbled, wind gets under the covering and lifts it, and rain follows. At the wall head we look for loose stones, because a verge fixed to a moving wall will not hold, however well it is made.

Photographs of the whole verge go in the report, taken from above, so that you see the open joint or the rocking unit yourself. The choice between rebedding and a dry system is explained against the house, not against a catalogue. A repair that can follow the wall can be better than one that fights it. If the wall head itself needs rebuilding, that is separate masonry, and the report states it. Rebedding a verge means lifting the loose units, cleaning off the old bedding, laying the units again on fresh mortar or clipping them dry, and photographing the finished edge for your records.

Our roof repairs page covers verge work alongside the other smaller jobs.

What the verge survey records

Edge units
Sound, loose or missing along the gable
Bedding
Mortar crumbled, or a dry system clipped on
Fixings
Clips and screws, present and tight
Undercloak
The course tucked beneath the edge units
Wall head
Stones firm, or loose and open

A verge fixed to a wall that is moving will not hold, however well it is made.

Fig. 2 The verge, drawn close

Callout 2 of 3

Dormers, roof windows and the nearby National Landscape

Part of the land round St Briavels falls within the Wye Valley National Landscape (until November 2023, an AONB). Here planning applications are decided by Forest of Dean District Council, and the designation does not decide them. On a dormer the designation matters under English rules; re-covering goes ahead as before. If you are thinking about a dormer, ask Forest of Dean District Council first, and read the planning guide for roof windows before you commission drawings.

Roof windows sit flush with the slope, and they have their own energy figures. For a roof window in a new fabric element, Table 4.2 of AD L 2021 gives "1.4 or Window Energy Rating Band B minimum". A rooflight has its own figure, 2.2 W/(m²·K). From 24 March 2027 AD L 2026 applies, with the same values in Table 3.2.

A loft conversion brings fire safety into the picture. For a storey more than 4.5 m up, paragraph 2.5 of AD B (England) gives two answers, protecting the stairway or giving the top storey its own alternative escape route, and the escape window rules in paragraph 2.10 reach only storeys within 4.5 m of the ground. A roof window can be part of the answer, but it is not the whole of it, and the council's building control team judges the whole arrangement. Forest of Dean District Council Building Control is on 01594 812315.

Position matters as much as size. A roof window high in a slope brings in light but sits where it is harder to reach, and one low in a slope is easier to open but sits nearer the eaves and the gutter. We mark the intended position on the rafters up in the loft, before the saw comes out, so you can see where the opening will fall.

Fitting a roof window means cutting a rafter, and that changes how the load travels. We look at the size of the opening against the rafter spacing, at how the flashing will be dressed round the frame, and at what lies beneath. Flashing round a roof window is the weak point of the installation, so it is photographed before the covering is closed up around it.

Our skylights page covers supply and fitting.

A common question about dormers

Is a dormer possible on a house within the National Landscape?

On this designated land a St Briavels dormer goes to the council before anyone draws it. Whether a roof window needs an application needs its own answer, which the planning guide gives.

Fig. 3 Roof windows, drawn close

Callout 3 of 3

Listed houses, St Mary's church and the conservation area

Several buildings in St Briavels are on the national list. St Mary's church, Grade I, has list entry 1299118 and was first listed on 7 August 1954. St Mary's Chantry is Grade II (1299125, first listed 7 August 1954), the Moat House is Grade II (1186636, first listed 7 March 1988) and Oak House is Grade II (1299123). Forest of Dean District Council also lists the St Briavels Conservation Area, and a house in or beside it needs a council check before any visible change to the roof.

A listed building cannot have works done that alter its special character unless consent is granted first (section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990). Listing alone does not remove permitted development, but consent comes on top. Check whether an Article 4 direction applies to your street; Forest of Dean District Council can say.

On a listed roof, the order of work matters. The existing covering is photographed slope by slope before anything is lifted, so the council and the owner can see what was there. Sound slates, tiles or stone slates are set aside for reuse, damaged ones are replaced like for like, and any lead is renewed in the same code and pattern as the old. Where the work faces the street, the visible slope gets the most care, since that is the face the street sees.

For the parish church, or any chapel in the village, ask the governing body of that church before roof work is planned. While worship continues, a Church of England building goes through the faculty system rather than listed building consent, while a church that has closed, and the meeting houses of Quakers and Unitarians, need the council's consent. Until the denomination and use are confirmed, the route stays open.

On an old house, the covering can matter as much as the structure. SPAB observes of stone slate roofs that "many are changed to different stones or even to slates or fake stone slates", and we would rather match what is there than add to that list. For scaffold on the road side: we arrange the licence with our scaffolder.

Our listed and heritage roofing page sets out the approach to protected buildings.

Pointing at a St Briavels wall head

SoundStones firm, joints full, covering sitting tight
Needs workJoints open, stones loose, covering lifting

St Briavels roofs: verges, windows and listed buildings

How is a gable verge checked and repaired on an older St Briavels house?

We climb up and press along the edge units, look at the undercloak beneath them, and read the wall head for loose stones. A rocking unit or crumbled bedding is rebedded, or the verge is converted to a dry system if the wall allows. If the stones themselves have shifted, the masonry is dealt with first, since a verge cannot hold on a moving wall. The report shows each stage in pictures, so the order of work is clear before you agree to it, and the quote follows the survey.

Who decides on a roof window in St Briavels, given the Wye Valley National Landscape?

Forest of Dean District Council, not the National Landscape, decides planning applications here. Here the dormer, not the window, is what prompts the planning point. Whether a roof window needs one is a separate matter, which the planning guide linked above sets out. Ask the council before ordering any window, and keep the answer in writing, because a supplier's brochure does not settle a planning question.

Can a loft in St Briavels be converted using a roof window as the escape route?

Possibly, but check the rule. AD B paragraph 2.5 sets out two options, a protected stairway or an alternative escape route, and the escape window provisions apply only to storeys within 4.5 m of the ground. Building control judges the whole arrangement, so show them the plans before you build. We can describe the roof side, but the escape design belongs to the person drawing the conversion, and the plans should reach building control before any timber is cut.

Does the St Briavels Conservation Area limit roof alterations?

It can. Forest of Dean District Council lists the St Briavels Conservation Area, and houses in or beside it may face extra control over visible changes, including how the roof reads from the street. Check whether an Article 4 direction applies to your street by asking the council. In England a conservation area alters the position for a dormer; repairs that match the existing roof are another matter, and the planning guide gives the detail.

Which energy figure must a new St Briavels roof window reach?

For a roof window in an existing home, Table 4.2 of AD L 2021 gives WER Band B or 1.4. A rooflight is rated on its own, at 2.2 W/(m²·K), so check which type your product is before comparing it with a figure. AD L 2026 takes effect from 24 March 2027, with the same values in Table 3.2.

What happens if bats are found behind a verge in St Briavels?

Work on that part stops. Under the Wildlife and Countryside Act 1981, disturbing a bat in its roost intentionally or recklessly is an offence, and a separate rule in the Habitats Regulations covers a roost used to breed or rest, where intent does not come into it. Natural England issues bat licences for English sites. We photograph what we see and leave the next step to the licensing process.

Book a verge-first survey in St Briavels

Name the street and the fault, and the survey will photograph each problem before one total is quoted.

10-year workmanship guarantee, in writing