Callout 1 of 3
Where Redbrook's sandstone walls meet the roof
Redbrook sits in Newland parish, and the Victoria County History's 1996 account of that parish says the character of the riverside hamlets of Upper and Lower Redbrook, as it survived in 1992, "was mainly set by building in the dark Forest sandstone during the 19th century". That describes walls, not roofs, but it matters to a roofer. Where a slope stops against a stone gable, a parapet or a stack, the covering relies on pointing and lead, and weathered mortar can open that seam. So our survey spends its first minutes there, because a junction that was snug when it was laid can open up once the joints have eroded.
Inside the roof space the first timber we look for is the wall plate, bedded along the wall head to take the rafter feet. We look at each rafter foot for stains, softness or insect holes, and at the underside of the boarding or battens for dark tide marks. Outside, we look at the verge beside each gable, at the point where a slope butts against a stone wall or stack, and at the pointing above every flashing. A gap there is mended in the way the house was built, never with a bead of sealant across it.
Changing the weight of the covering is a structural question as much as a weather one. The Planning Portal's trigger for a heavier covering is a rise in weight of "15 per cent or more", while AD A, paragraph 4.4, speaks of loading "increased by more than 15%". Swapping thin slates for heavy concrete tiles on an old roof is the kind of change both have in mind, so we check the timbers before a quote is written. The survey photographs show the timbers that would have to carry the new load, and the choice of covering follows from what is actually there. Redbrook is in England, so these are the English rules.
Where the job is a repair and the structure is sound, the work stays small: a few tiles reset, a verge rebedded, a flashing replaced. If a gable does need its covering renewed, the new verge is bedded to follow the line of the stone, and the junction with the wall is flashed and repointed in one visit. Our listed and heritage roofing page sets out how we handle older houses of this kind.
Read at a framed junction
- Wall plate and rafter feet from the loft
- Stains or softness on timber ends
- The roof edge beside each stone gable
- Pointing and flashing where slope meets wall
- Tiles lifted by movement in the wall below
Where a slope meets stone, the mortar and the lead decide the roof, so that join is read first.















