Callout 1 of 3
Ridge and hips on a hipped Welsh slate roof
The Shire Hall is the easiest roof in Monmouth to describe, because Cadw's listing description of it records a "hipped Welsh slate roof". A hipped roof slopes on all four sides, so instead of a gable it has hips: the sloping lines on the outside corners, where two slopes meet and the courses have to be cut and capped. Every hip is a long joint exposed to the weather, and our survey follows each one from eaves to ridge. At the top, the ridge closes the apex, and we test the pieces for movement and the joints for gaps. Photographs of each hip go into the report, because a hip cannot be judged from the ground. Beneath the slates we also look at the battens and at the underlay, the membrane that backs the slates against wind-driven rain. If the underlay has perished or the battens are soft where the nails sit, the survey tells you whether it is a patch or a full strip and relay of that slope.
Slate asks for care in how it is hung. Cupa says BS 5534 indicates a minimum pitch of 20 degrees for natural slate where the exposure is moderate, the slate is 500 mm long and the overlap is 115 mm. Below that, or when conditions differ, the maker's data sheet decides. HomeBuilding puts Welsh slate at "100+ years", which is a reason to repair a good roof and not replace it, and SPAB calls a well-slated roof "likely to be more than 100 years". Slipped slates are re-hung with fresh fixings, and any slate that has split along its grain is exchanged for a matching one. The old slates that come off are sorted on the ground, so the sound ones go back and nothing is thrown away by habit.
Scope follows the share of roof touched. The Welsh Government says re-roofing "In most situations" needs Building Regulations approval, and the same guidance puts the threshold for upgrading the thermal insulation at work on more than 25 per cent of the roof area. For a renovated roof, Table 11.1 of the Welsh Approved Document L gives 0.16 W/m²K, with 0.35 as the limit where 0.16 is not feasible, and a 15-year payback test. A hip repair or a handful of slipped slates is nowhere near that line. Our slate roofing page explains how a roof is sorted into repair and replacement.
Parts of a hipped slate roof
- Ridge
- The cap line closing the apex between slopes
- Hip
- Sloping outside corner where two slopes meet
- Slates
- Hung in overlapping rows, fixed to battens
- Battens
- Timber strips that carry each course
- Eaves
- The lowest edge, where water leaves the slope
A hip is a long joint in the weather, and we walk every foot of it.















