01432 610152 Get a quote Call 01432 610152

Roofers in Oakridge

Flat roof, gutter and loft-roof work for Oakridge houses, sorted by what the survey finds.

Flat roofs and gutters get checked first; the report shows each fault in a photo and names one total in writing.

Get a free quoteCall 01432 610152

Flat roofs, gutters and loft rooms

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Flat roofs beside the houseStanding water after rain points to a lost fall and a worn membrane.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Gutters and roofline boardsA gutter out of level overflows at the front and wets the fascia board.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Loft conversionsTurning a loft into a room brings energy and fire rules into the roof.

Oakridge in our area

Oakridge on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Oakridge roofs from flat roof to loft

Flat roofs, gutters and loft rooms: three checks on an Oakridge roof

We begin on the flat roofs of extensions and garages, follow the rain into the gutters and roofline boards, and finish in the loft, where roof windows, insulation and escape routes meet the rules.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Flat roofs; 2 Gutters; 3 Loft rooms.

Fig. 1 An Oakridge house in section, with flat roof, gutter and loft window each keyed to a chapter.

Callout 1 of 3

Flat roofs over Oakridge extensions and garages

Look at a flat roof an hour after rain and the surface tells its own story. Dry and drained means the fall is working; pools mean it is not. The fall is the slight slope that sends rain towards the outlet. BS 6229:2025 covers membrane roofs on continuous support, and the NFRC reports a minimum finished fall of 1:80. IKO, a membrane manufacturer, advises designing for 1:40. The finished roof still has to reach 1:80, and a pool that outlasts the rain shows it has not.

Lifespan figures come from sources that disagree, which is why we name both. HomeBuilding gives EPDM, a single-sheet synthetic rubber, "25-30" years where Less gives "30 to 50". GRP, glass-reinforced plastic laid in resin, is "25-30" for HomeBuilding and "25 to 40" for Less. Torch-on felt is "10-15" years to HomeBuilding and "10 to 20" to Less. None of those is a promise, and the seams say more about your own roof than any table.

On the roof we work along each seam and lap, then turn to the upstands, where the covering rises against a wall, and to the edge trims, the outlets and any rooflight kerb. A kerb is the low frame a rooflight sits on. Pressing the surface by hand finds soft patches that point to a wet deck beneath, and any wet insulation we find is pictured where it lies, with a ruler beside it for scale.

Re-covering is energy-rule work as well as weatherproofing. AD L 2021 lists the replacement of a flat roof's waterproof membrane among renovation work, and under regulation 2 of the Building Regulations 2010 the roof falls in the thermal element class, so the insulation under a new membrane comes into the plan.

Edges matter as much as the middle. Rain leaving the roof at its edge should drip clear of the wall, so we check the edge trim for lifted laps and the wall below for streaking. At the line where the extension joins the main house, the upstand and the masonry are checked for a gap, because a gap there lets water slip behind the covering and into the wall. Cracks in the render above are noted, since they point to the same entry, and so are stains on the ceiling inside the extension, which show where water has already arrived. Our flat roofing hub lists the coverings and the details each one needs.

Checked on an Oakridge flat roof

  • Standing water a day after rain
  • Seams and laps along the membrane
  • Upstands where the roof meets a wall
  • Outlets and the fall towards them
  • Edge trims and drip details

A flat roof still holding a pond a day after rain has told you where its fall went.

Fig. 2 Flat roofs, drawn close

Callout 2 of 3

Gutters, fascias and soffits on Oakridge houses

A gutter earns its keep only if it drains. Brett Martin, a gutter manufacturer, gives the fall as "1mm for every 600mm". We sight along each run from the ground and from the ladder, check the brackets and joints, and send water down every downpipe. Water pooling in a sagging section overtops the front lip and runs down the fascia, the board the gutter is screwed to, then onto the wall beneath.

The timber behind comes next. Push a bradawl into the fascia, then into the soffit, the board that lines the underside of the overhanging eaves, shows where the wood has gone soft, and from the loft hatch we examine the ends of the rafters, which carry the weight of the overhang. Soft rafter ends cost more to put right than a weeping joint, and replacing a short length of board early is a smaller job than waiting for the damp to reach the brickwork, so the photographs mark how far along the board the damage runs.

The HSE tells owners: "If the building was built or refurbished before 2000, assume that there is asbestos in it." White soffit boards from that era can be asbestos insulating board, and that board is usually licensed work to take down. A licensed firm takes over any job in that category, and our part is to recognise a suspect board, stop and report. Asbestos cement sheet that is lifted carefully, unbroken, falls on the non-licensed side, and asbestos waste goes into a lockable skip, which HSE asks for.

Renewed fascias and soffits give the gutter a firm, straight line, and the gutter goes back up to its fall during that visit. Where a downpipe empties at ground level, we check that the water runs clear of the footing instead of back against the wall, because a blocked gully undoes the work above it. Boards, brackets, stop ends and outlets are all pictured before and after, so the report shows what changed. Our gutters, soffits and fascias hub covers the systems we fit, the repairs we make and the materials we compare.

A gutter run in two conditions

SoundJoints dry, fall towards the outlet, brackets firm
Needs workSagging run, stained wall below, joints weeping at the seam

Callout 3 of 3

Converting an Oakridge loft: energy, escape and windows

When a loft becomes a room, the roof over it is renovated, and in England AD L 2021 Table 4.3 sets 0.35 as the threshold figure and 0.16 W/m²K as the improved one. If 0.16 is out of reach, paragraph 4.13 looks for the best figure that is feasible and repays itself within 15 years, and an upgraded thermal element should generally not be worse than 0.7. The roof windows themselves come under Table 4.2, at 1.4 or WER Band B, with 2.2 reserved for rooflights. AD L 2026 replaces these tables from 24 March 2027, as Tables 3.2 and 3.3.

A loft conversion starts with the timbers. From the hatch we take in the rafter sections and their spacing, the horizontal timbers under them, any bracing, and the chimney breast if there is one. The clear height from the floor joists to the ridge decides where a stair can land and how large a roof window can be, so those measurements go into the report before any drawing is started. A loft that is too low under the ridge may suit storage better than a bedroom, and we say that when the figures show it.

On fire, AD B for England deals with a new storey more than 4.5 m above the ground. Paragraph 2.5 allows two solutions for the dwelling: a protected stairway, or an alternative escape route, meaning a top storey sealed off by fire-resisting construction, with its own way out to a final exit. Paragraph 2.23 allows sprinklers in open-plan layouts as a substitute. Building control checks the drawings, and our survey notes where the stair, the landing and the slope of the roof will have to sit.

Roof windows and dormers need planning thought as well. Our planning guide for roof windows compares the cases in England, and our skylights hub covers fitting and flashing. The nearest conservation area, The Docks, is Gloucester City Council's, across the city boundary. For a house in Oakridge, Tewkesbury Borough Council's own conservation area list is where to look your address up, and ask that council whether an Article 4 direction applies, too.

Building control for a conversion comes from Cheltenham and Tewkesbury Building Control, while a registered building control approver is the route you may choose instead. Should the scaffold footing land on the public road, a highway licence has to be in place, and we arrange the licence with our scaffolder. By road, Oakridge lies 26.2 miles south-east of central Hereford, a journey of around 46 minutes, and Gloucester has the nearest station.

Words on a loft-conversion drawing

Protected stairway
A stair enclosed in fire-resisting construction at every storey
Alternative escape route
A separated top storey with its own way to a final exit
WER Band B
A window energy rating accepted in place of a 1.4 figure
Thermal element
A wall, floor or roof, but not windows, doors or rooflights

Oakridge roofs: falls, lifespans and loft rules

What fall does a flat roof on an Oakridge extension need?

BS 6229:2025 applies to membrane flat roofs, and the NFRC reports a minimum finished fall of 1:80. IKO advises designing for 1:40. Pools lingering a full day after the rain suggest the fall has gone, and the survey measures that before we suggest a patch or a new membrane. On a garage roof, the line from the far edge to the gutter is checked first.

What lifespans do EPDM, GRP and felt flat roofs have?

Two sources disagree, so we name both. For EPDM, HomeBuilding gives 25-30 years and Less gives 30 to 50. For GRP, HomeBuilding gives 25-30 and Less gives 25 to 40. For torch-on felt, HomeBuilding gives 10-15 and Less gives 10 to 20. Nothing in those ranges is assured for any roof, so the seams and the deck say more than its age.

Does a loft conversion in Oakridge need an escape window?

AD B paragraph 2.10 describes an escape window for a storey up to 4.5 m above the ground: an openable area of at least 0.33m2, 450mm high and 450mm wide, with its lower edge no more than 1100mm above the floor. A storey higher than that follows the escape routes in paragraph 2.5 instead. Building control confirms which applies to your conversion.

Is Oakridge near a conservation area?

The Docks lies nearest, and it is a Gloucester City Council area, not one of Tewkesbury Borough's. Oakridge itself is in Tewkesbury Borough, so that council's list and map answer whether your house is inside a conservation area, and the same council answers on Article 4 directions. Dormers are the change most affected, while repairs in matching material are a separate matter, covered in the planning guide alongside roof windows.

Does scaffold on an Oakridge road need a licence?

Yes. Section 169 of the Highways Act 1980 requires a licence for scaffolding on a highway, and in this area Gloucestershire County Council charges £145 for a minimum of 28 days, then £36 per 7 days for each extension (prices from 1 April 2025). Applications need no fewer than twelve calendar days of notice, which we build into the start date. We arrange the licence with our scaffolder.

Do I need approval to replace an Oakridge flat roof covering?

In England the Planning Portal's tests are less than 25 per cent of the building envelope and less than 50 per cent of the roof, and a re-cover inside both normally needs no application. Replacing a flat roof's waterproof membrane is renovation under AD L 2021, so insulation joins the plan. Cheltenham and Tewkesbury Building Control, or a registered building control approver, confirms what applies.

Book a flat-roof survey in Oakridge

Send a photo of the flat roof, the gutters or the loft hatch, and we will set a date for the survey.

10-year workmanship guarantee, in writing