01432 610152 Get a quote Call 01432 610152

Roofers in Breinton

Roof repairs, gutter work and re-roofs for Breinton's cottages and newer houses west of Hereford.

We begin at the verges and the eaves, photograph each fault and put a single total in writing after the survey.

Get a free quoteCall 01432 610152

Edges that need care on a Breinton roof

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Gable vergesVerge mortar can crack and drop, leaving the end of the covering loose.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Eaves and guttersA gutter that sags or leaks soaks the fascia and the wall beneath.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Listed cottagesListed cottages need matching materials and consent before any work begins.

Roads into Breinton

Breinton on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Breinton roofs, edge by edge

Verges, eaves and a listed row: reading a Breinton roof from its edges

Here the survey begins at the edges of the roof: the gable verges first, then the eaves and gutters, then the listed cottages and conservation questions around Breinton, with a photograph record at each stop.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Gable verges; 2 Eaves and gutters; 3 Listed walls.

Fig. 1 Breinton's three callouts, numbered around the edge of the drawn house.

Callout 1 of 3

Gable verges on Breinton cottages and houses

The verge runs up the side of a gable wall as the finished edge of the covering, and it is the first part of the roof that sideways weather meets. On a Breinton cottage the verge may be finished with mortar, with tiles set to overhang the wall or with a dry-fix verge held down by screws and clips. Each finish ages differently. Mortar cracks and drops away from the gable, a tile at the very end can lift when its fixing loosens, and a dry verge unit can slip if a screw has backed out. On a house with two or three gables, each verge is checked on its own, because the sun, the wind and the shelter of trees differ from one end of a house to the other.

Breinton parish appears in the 1932 Herefordshire inventory compiled by the Royal Commission on Historical Monuments. For the buildings numbered 3 to 8, it recorded two-storey houses of the seventeenth century, timber-framed, under tiled or slate-covered roofs. A frame of that age moves a little with the seasons, and the verge beside it moves too. We look for a hairline gap between the covering and the gable, and for staining on the wall below that shows where water has been running behind it.

Marley states that "Installing to BS 5534 isn't required by law", although it adds that mortar "could no longer be relied upon as the only means of securing the roof covering". BS 8612 is the standard covering dry-fix systems. When a verge is rebuilt, the end tiles are fixed mechanically and the mortar, where we use it, is a finish and not the only thing holding the edge down. On older cottages the bedded look of a verge is worth keeping where the building suits it.

We photograph the whole length of each gable from a ladder, including the end tile at the ridge, the point where the verge meets the eaves and any pointing that has gone. A cracked verge calls for a repair and not a new roof, and the report says that plainly. Our pitched roofing page covers the larger jobs, from re-covering a single slope to a full strip.

Photographed along every verge

  • The end tile at the ridge
  • Mortar joints along the gable
  • Fixings on a dry-fix unit
  • The meeting point with the eaves
  • Staining on the gable wall below

A gable verge, sound and failing

SoundEnd tiles fixed, mortar whole, no stain on the gable wall
Needs workCracked mortar, a lifted end tile, water marks below

A verge takes weather from the side as well as above, so it is checked along its whole length.

Callout 2 of 3

Eaves, gutters and the fall that drains them

At the foot of each slope sit the eaves, where the covering overhangs the wall and the gutter takes over. A gutter has to carry water sideways to a downpipe, so it is laid to a slight fall. Brett Martin, the gutter maker, gives the figure as "1mm for every 600mm". A length that has sagged between brackets holds a pool of water, and the pool overflows at the joint or soaks the fascia board behind the gutter. We run a hand along the fascia and look for soft timber, then check the brackets for rust and the joints for drips.

The eaves also hold part of the roof's ventilation. Marley's guidance for a cold roof with an HR underlay asks for "25mm along the length of the eaves for pitches of 15° or less" and "10mm along the length of the eaves for pitches of more than 15°". HR, or high resistance, underlay is not vapour-permeable, so it relies on that air gap. An eaves vent that has been blocked by insulation or a painted-over strip is easy to miss from the ground, and we look for it from the loft.

The downpipe carries the water down to a drain or a soakaway, and a pipe that is blocked or cracked low down sends it into the wall instead. We follow each downpipe to its shoe at ground level, check the joint at the first bend, and photograph any stain or green growth on the brickwork behind it.

Soffits are the boards under the overhang of the eaves, and fascias are the boards that face outward, carrying the gutter. Replacing them means the gutter comes off, and scaffold is needed for a safe working height, so it makes sense to survey the gutter, fascia and soffit together. Our guttering, soffits and fascias page explains the work.

Where a roof is being re-covered, the eaves course is the first row to be laid, and a drip edge or eaves tray at the foot of the slope takes the water into the gutter. We check how the bottom row of the old covering sits over the gutter, because a tile that stops short lets water run behind it, and a tile that overhangs too far drips beyond it. Photographs go to you for each section.

Eaves figures from the makers

Gutter fall
1mm for every 600mm, says Brett Martin
Eaves gap, 15° or less
25mm along the length, says Marley
Eaves gap, over 15°
10mm along the length, says Marley
HR underlay
Not vapour-permeable

Gutters on an older cottage

Should a leaking gutter on a Breinton cottage be replaced or refitted?

It depends on what the survey finds. A sound run with failed joints or tired brackets can be refitted to the right fall. A cracked or distorted run, or one that sits against rotten fascia, is replaced, and the photographs behind whichever answer we give come to you with the report.

Fig. 3 Gutters and downpipes, drawn close

Callout 3 of 3

A listed row, Huntington's conservation area and building control

Breinton has a listed building close to its centre: 3 Manor Cottages and South View, Grade II (list entry 1167905, first listed 19 January 1987). Under section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990, works that would affect "its character as a building of special architectural or historic interest" must be authorised. Re-covering a listed roof therefore starts with a conversation with Herefordshire Council, and the materials and fixings are agreed before the first tile is lifted. A listed house keeps its permitted development rights, with consent needed in addition. Read the list entry before you plan anything, because it describes the building and shows what the council will be weighing up, and we photograph the roof as found for your consent file. Our listed and heritage roofing page sets out the approach.

The conservation area nearest to Breinton is Huntington. Herefordshire has 64 conservation areas in all, and the council's published list shows the extent of each, so check your address against it. Whether an Article 4 direction applies is another point to check with Herefordshire Council, because a direction can withdraw permitted development rights across a defined area. Do not assume an answer from a neighbour's experience.

A church or chapel in use for worship may sit outside listed building consent, and the answer turns on its denomination. Parish churches of the Church of England go through the faculty jurisdiction. Catholic, Methodist and URC congregations each have a scheme of their own; for a Baptist Union congregation, exemption depends on a Schedule 1 trust corporation holding its building. Unitarian and Quaker buildings are not exempt, and neither is a closed chapel, so those go to Herefordshire Council for listed building consent if they are listed.

For building control, Herefordshire Council runs its own service, Herefordshire Council Building Control, on 01432 261938 or at bce@herefordshire.gov.uk, and a registered building control approver can be appointed instead. A new roof window or dormer adds planning questions, which our planning guide for roof windows works through.

Asked before work on a listed roof

  • Is the house listed, and at what grade?
  • Will the work affect its character?
  • Do the materials match the old covering?
  • Does a conservation area or Article 4 apply?
  • Is consent in place before the scaffold goes up?

Breinton roofs: edges, foam and licences

How is a cracked gable verge on a Breinton cottage repaired?

We cut out the failed mortar, check the end tiles and the fixings behind them, and rebuild the verge with each tile fixed mechanically, or refit a dry-fix unit with new screws where that is what the house carries. You receive photographs before and after. A verge repair is priced as a repair, and the one written total price comes after the survey, with the waste cleared away and the site left tidy once the work is done.

Is there a conservation area near Breinton that affects roof work?

The nearest is Huntington. Herefordshire has 64 conservation areas, and Herefordshire Council publishes the list with their boundaries, so check where your address falls. Ask the council whether an Article 4 direction applies, as that can change what needs permission before any work starts. Re-covering like for like is a different matter from a dormer or a new roof window, and the planning guide on this site covers both in full.

Does foam sprayed under a Breinton roof matter when the house is sold?

It can. RICS reported in March 2023 that some lenders, in equity release mortgages for instance, had raised concern, and its consumer guide advises asking your mortgage provider whether its policy allows the installation. The Energy Saving Trust describes closed-cell foam as "not vapour permeable", and puts the rot risk to roof timbers as one that "should be much lower" with open-cell foam. Foam that has to come out needs a specialist survey first.

How is scaffold on the road outside a Breinton house licensed?

Section 169 of the Highways Act 1980 is the basis for a scaffold licence wherever poles stand on a public pavement or road. Herefordshire Council charges £167 per licence, running a maximum of 1 month, with extensions at £123 per month, and wants 10 days' notice. We arrange the licence with our scaffolder. National Highways, not the council, handles trunk roads and motorways.

What does replacing the gutters on a Breinton house cost?

MyJobQuote averages gutter replacement at £1,000 to £1,600, with uPVC at £40 to £50 per metre, and fascia capping at around £800. Those are third-party ranges and not our prices. The covering, the length of the run and the height of the eaves set the figure on your house, and scaffold is part of the single written quote that follows the survey.

Can the roof be insulated when a Breinton house is re-covered?

Yes, and Part L applies. For existing elements, AD L 2021 Table 4.3 sets a threshold of 0.35 and an improved figure of 0.16, with a 15-year payback relaxation in paragraph 4.13. AD L 2026 takes over from 24 March 2027, with Table 3.3. Roof windows take 1.4 or WER Band B. Your building control body confirms the route for your job.

Arrange a Breinton edge-to-edge survey

Tell us about the gutters, the gables and anything dripping, and we will look at the roof from its edges inward.

10-year workmanship guarantee, in writing