Callout 1 of 3
The verge on a Huntington gable
A verge is the side edge of a roof, where the slope runs out past a gable wall. The tiles or slates stop short of the wall face, so that edge has to be sealed and held down. On older work it is a bed of mortar laid on an undercloak, a thin course of tile or slate that carries the mortar. Newer work may use a dry-fix verge system of clips and screws, which BS 8612 covers. Marley, the tile maker, notes that following BS 5534 is no legal duty, but that mortar on its own cannot be trusted to hold a covering on. A verge we repair is held by mechanical fixings as well as by its bedding mortar.
From the ground a verge looks like a thin line, so we go up and test it by hand along its whole length. We look for hairline cracks in the mortar, an undercloak that has slipped, and a gap between the covering and the top of the gable wall. Where a gable carries bargeboards, the timber boards fixed along its sloping edge, we check the board ends for rot, because a verge that lets rain in soaks them from behind. You receive the photographs along with the price, so every fault is visible before you agree to anything. From the loft, where there is access, we also look at the rafter ends below the verge, since a damp line there can show an edge letting rain in before a bedroom ceiling stains.
Huntington has several protected buildings. Huntington Court Farm and Attached Granary is listed Grade II (list entry 1297409, first listed 23 September 1985). Huntington House is Grade II (list entry 1298843, first listed 22 October 1973), and Huntington Court is Grade II as well (list entry 1024992). Section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 makes listed building consent a requirement for any work touching a listed building's special architectural or historic interest, so on a listed house the verge is agreed with Herefordshire Council before a single tile moves. A listed house keeps its permitted development rights, with consent needed as well.
Herefordshire Council's own list dates the Huntington conservation area to 1975. Inside the Huntington area a dormer brings planning questions that mending in kind avoids, and our planning guide for roof windows gives the conditions, so read it first. For protected houses in general, see our listed and heritage roofing service.
Tested along a Huntington verge
- Mortar bed for hairline cracks
- Undercloak for slipped or broken pieces
- Gap between covering and gable wall
- Bargeboard ends for softness
- Mechanical fixing on the edge course
A verge is a line you cannot judge from the lawn, so we climb to it.















