In brief
Checkatrade's repair guide, last updated in June 2026, puts natural slate repairs at £150 to £220 per m², excluding VAT, on rates worked out for no more than 3 m². It describes a patch and was never meant to price a roof, so it should not be multiplied by an area. What applies to your slates depends on how many are involved, the way the roof is reached and what sits beneath.
Slate set against the other coverings
Of the five coverings from Checkatrade's June 2026 repair guide in the table below, natural slate, at £150 to £220 per m², sits at the top. Each rate is per m² and excludes VAT, which has to be added. The guide's other rates are in the table.
| Covering | Repair rate |
|---|---|
| Concrete tiles | £90 to £120 per m² |
| Clay tiles | £110 to £160 per m² |
| Natural slate | £150 to £220 per m² |
| EPDM rubber | £120 to £170 per m² |
| GRP fibreglass | £130 to £180 per m² |
A slate repair is evidently priced as a different job from a tile repair, which is a good reason to ask which covering a quote assumes. The table is a range of published rates. It says nothing about the cost of repairing your own roof, because the number of slates, the access and the condition underneath are all missing from it. Two roofs with the same slate can need very different visits, one for a few loose slates low on a slope and one for a high gable that needs scaffold before anything else is done.
Why the rate stops at 3 m², never multiplied
The £150 to £220 per m² slate rate is worked up to a maximum of 3 m². It is a way of describing a small patch. Once a repair reaches across a slope the job changes and the rate no longer describes it. Checkatrade itself limits the £150 to £220 per m² slate rate to 3 m².
That is why we never multiply a per-m² rate by a roof area and quote the result. Three things break the arithmetic, and each shows up only once the slope is open:
- a wider area suggests the nails are failing generally, so the job becomes a re-slate
- reaching the area may need scaffold that a small patch would not
- a larger area uncovers battens, underlay and lead that a patch never reaches
The page on repairing a slate roof explains where a patch ends and a re-slate begins. The answer on nail sickness shows the usual reason a patch grows into something larger. Where the survey finds that, we say what the photographs show, and where a patch is the right answer we price the patch.
Other published figures that sit beside the slate rate
A repair may not be slate alone, so other published figures help a reader judge a written quote. Each is third-party, with its own unit:
- Checkatrade puts ridge tile repairs and lead flashing repairs at £50 to £70 per metre, and rooflight replacement from £1,000.
- Which? surveyed Trusted Traders in November 2025 and gives £75 to £400, excluding VAT, for swapping a handful of broken tiles, one to six of them, and £80 to £300 for a new ridge tile.
- MyJobQuote gives around £650 as the average roof repair in 2026, and an average of £225 to £550 for replacing ridge tiles.
These sources use different units and different bases, so they are read one at a time and never added together. The Which? figures are about tiles rather than slate, and the per-metre rates describe a length of ridge or flashing, not an area.
For a whole slate roof rather than a repair, MyJobQuote's average for fitting one is around £7,800. That figure belongs with the guide to what a new slate roof costs, not with any per-m² rate.
From a published rate to one written price
None of these rates is a price for your slates. The route from a rate to a price runs through the survey: we count what has failed, photograph it and look at what lies beneath. That is how a repair becomes a single written total, with scaffold included in it. The photographs go with the quote, so each finding can be matched to a picture of your own roof.
Compare any quote with a published figure only after checking whether VAT is in each. A patch repair may not trigger the border-specific tests, but they are worth knowing:
- England: the Planning Portal sets the Building Regulations test for roofwork at under 25 per cent of the building envelope and under 50 per cent of the roof, below which no application is normally needed.
- Wales: on the Welsh Government's roof page, a repair or re-cover touching less than a quarter of a pitched or flat roof, measured by area, would not normally need an application.
The slate roofing page covers the wider subject, and the survey is where a figure becomes specific to your house.
