01432 610152 Get a quote Call 01432 610152

Repointing signs

When does a chimney need repointing?

A chimney needs repointing when its mortar has crumbled, receded or washed out, leaving joints that let rain into the stack.

In brief

When the mortar joints have failed. The signs are joints that look hollow or crumbling, mortar crumbs lying on the slope or in the downpipe shoe, loose bricks or stones, and damp showing on the chimney breast inside. Repointing rakes out the weak mortar and fills the joints again, and it is best done before bricks start to loosen. A survey from roof level shows how much of the stack needs it.

The signs that the mortar has failed

Pointing is the mortar finish in the joints between bricks or stones. It keeps rain out of the joint and holds the units in place. A stack has weather on every face, so its mortar wears faster than the mortar lower in the wall.

Binoculars from the lawn, or a landing window, will show the first few signs:

  • joints that look hollow, recessed or dark, with each brick edge standing proud
  • grit or crumbs of mortar in the downpipe, on the slope or lying below the stack
  • a brick that has shifted, or a corner that looks rounded or open
  • green growth, small plants or moss rooted in the joints
  • damp, staining or lifting paint on the chimney breast in a bedroom or the loft

None of these alone proves the whole stack needs work, and several together point to a wider fault. The survey from roof level settles it, because up there a probe shows how deep the decay goes. We photograph each face so you can see the same joints we see, and a joint that is sound is left alone.

Why waiting makes the job bigger

Mortar is the sacrificial part of a wall. It is meant to wear before the brick does. Once the joints open, rain soaks the masonry directly, and a frost can then break the face off a brick. At that point repointing is no longer enough, and bricks must be cut out and replaced as well, as described in why chimney bricks crumble.

The stack also leans on its mortar for stability. A tall, thin column of masonry with weak joints is more likely to shift in wind, and a stack that shifts can loosen the lead flashing at its base. The page on chimney flashing leaks explains that second fault, which can run alongside the first.

The aim is to repoint while the bricks are sound. That keeps the work to the joints and keeps the stack in its original form. If the stack already leans or has opened up, the better repair may be a rebuild when the stack has to come down to a sound course. We tell you when the lesser repair is the better buy, and when it is not.

What repointing involves and which mortar to use

Repointing is not a coat of fresh mortar over old. The weak mortar is raked out to a depth that suits the joint, the gaps are cleaned, and new mortar is pressed in and finished to match the character of the old work. The new joint should look like the one it replaced, in colour, width and finish.

The mortar choice matters. Old brick and stone were laid in lime, and a hard cement mix can hold moisture against a softer unit. The decision gets its own page, lime or cement mortar on a chimney, and the mix we use follows the age of the masonry.

Access is part of the job, because the stack is out of reach without a scaffold or a tower. A scaffold standing on the pavement or road falls under section 169 of the Highways Act 1980, which requires a licence for it. We arrange the licence with our scaffolder. The scaffold sits inside the quote, so the price is one figure, set down after the survey. When the last joint is finished, the slope below is cleared of mortar dust and the waste leaves with us.

Listed houses, shared stacks and the law

Repointing repairs a chimney and does not replace it, but a listed house still needs care. In England, section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 asks for consent when a listed building's character is at stake. In Wales, the Historic Environment (Wales) Act 2023 section 88 applies the same test. A new mortar colour or joint style can change a stack's look, so ask the council first.

A conservation area may carry an Article 4 direction. Your council can say whether one covers your road, and the National Park Authority answers for a house inside the Bannau Brycheiniog National Park.

A stack that rises from a shared wall involves the neighbour. The Party Wall etc. Act 1996 covers both countries, and a notice is needed for some work to a party wall, as set out in chimneys on a party wall.

Bats and nesting birds matter at the stack head. Section 1 of the 1981 Act protects a nest "while that nest is in use or being built" from anyone acting intentionally, and bat work is licensed by Natural England in England and Natural Resources Wales in Wales. The other jobs at the top of the house are gathered under chimney repairs.

Related questions

How long can a chimney go before it is repointed?

Condition matters more than age. Look at the joints, at the debris below the stack and at the breast inside. If joints are hollow or bricks have moved, book a survey. We photograph every face of the stack, and the written figure covers the stack as it stands.

What does repointing a chimney cost?

Four things set the price: how tall the stack is, how many faces need work, what access it takes and how much mortar must come out. The survey comes first, then a single written figure with the scaffold inside it, covering everything from setting up to the final clear-up.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing