01432 610152 Get a quote Call 01432 610152

Roofers in Whitecross

Roofing in Whitecross, on the west side of Hereford, from the ridge down to the gutter.

Whitecross sits 1.4 road miles west of Hereford city centre. Each fault is photographed, and one written total gives the price.

Get a free quoteCall 01432 610152

Whitecross roofs and the places we look first

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Ridge tiles on the skylineA rocking capping tile has lost its bed and lets weather onto the battens.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Gutters along the eavesA sagging run or a loose joint drops rainwater down the wall face.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Listed walls and abutmentsProtected buildings need consent ahead of any change to the covering or the lead.

Whitecross from Hereford

Whitecross on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

A Whitecross roof, ridge to wall

A Whitecross roof read in three stops, ridge to listed wall

The visit follows the roof downwards: the ridge, then the gutter with the board behind it, then the wall where a slope ends and the listed buildings nearby set conditions.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Ridge line; 2 Gutter run; 3 Wall and abutment.

Fig. 1 Section through a border house, with this survey's three Whitecross stops numbered.

Callout 1 of 3

Capping tiles, mortar beds and the Whitecross ridge

Whitecross roofs are read from the top, so the survey begins at the apex, on the ridge, where capping tiles cover the seam between the two slopes. A Whitecross capping tile is either bedded in mortar or carried by dry-fix, which holds each tile with clips and screws, not mortar. We follow the ridge from gable to gable and rock each tile by hand. A tile that gives has lost its bed. Rain then enters through the gap beneath, reaching the top course of tiles and the timber laths below them, called battens.

Marley, a tile manufacturer, writes that installing to BS 5534 "isn't required by law". It adds that after the 2015 amendments mortar no longer stands alone as the fixing for a covering. That does not ban mortar. It means a bedded ridge needs a mechanical fixing as well. The standard for the dry-fix alternative, with its clips and screws, is BS 8612. On a rebed we fix every capping tile mechanically, and the photographs show the old bed we took out, so you can see what had given way.

Each end of the ridge gets its own check. The tile at the gable takes the first push of a gust, so we want it fixed down and not resting on its mortar. Where a hip rafter, the angled timber at a roof's outside corner, runs up to the ridge, three runs of covering converge, and we inspect that junction from both sides. Cracked or slipped tiles beside the ridge are logged on the same visit, because they open the top of the slope to the weather. A chimney stack that rises through the ridge line gets the same treatment, and its lead is looked at from the roof, not from the ground.

A loose ridge belongs in the repair category, and the quote treats it so. Replacing the whole covering is a different decision. For England the Planning Portal sets its test at less than 25 per cent of the building envelope and less than 50 per cent of the roof; keep under both, and in the Portal's view the work would not normally need one. A new covering whose weight is 15 per cent or more above the old one's brings in Building Regulations approval, once a structural engineer or surveyor has looked at the rafters. Our roof repairs page describes the smaller jobs that begin at the ridge.

Checked along the Whitecross ridge

  • Capping tiles that rock under a hand
  • Mortar joints that have opened or crumbled
  • A mechanical fixing on every capping tile
  • The end tile at each gable
  • The junction where a hip meets the ridge

A loose cap has lost its bed; the photograph shows exactly where.

Fig. 2 The ridge, drawn close

Callout 2 of 3

Falls, brackets and the fascia behind a Whitecross gutter

Next is the gutter, the channel that carries roof water to the downpipes. Brett Martin, a guttering manufacturer, advises a fall of "1mm for every 600mm" towards the outlet. With a slope that shallow, one dropped bracket or one saggy length is enough to hold a pool. The pool overtops at the lowest joint and sheets down the wall, and the first sign indoors may be a stain high in a bedroom corner.

From a ladder or from the scaffold we photograph the fixing of each bracket, the state of every joint and stop end, and the outlet over each downpipe, and clear moss and leaf litter from the channel. The fascia, the board that the brackets screw into, gets a probe with a screwdriver, and so does the soffit, the underside of the eaves overhang. Soft timber will not hold a bracket, so a gutter put back onto it holds only until the next hard shower.

Sometimes refixing is the better buy. If the lengths are sound and the brackets or joints are at fault, we refix and leave the rest alone. When a run is cracked, warped or bowed beyond saving, new lengths are the answer, and the written quote states which of the two it covers. Clearing a gutter of leaves is a separate and smaller job than renewing it, and you can ask for either on its own. Downpipes get a look too: a bend packed with silt sends the overflow back up to the joints above it.

If scaffold poles will land on the public footway or the carriageway, section 169 of the Highways Act 1980 calls for a scaffold licence from the council, here Herefordshire Council. The fee, the extension charge and the notice needed are given in the FAQ section. We arrange the licence with our scaffolder before the first pole goes up, and the written total already covers the scaffold. Our guttering, soffits and fascias page covers renewing a whole run.

The rainwater path at a Whitecross eaves

Bracket
Fixed to sound timber and spaced to stop sagging
Fall
Set towards the outlet, measured from the downpipe end
Joint
Sealed and clipped so the seam stays dry
Stop end
Fitted so the run cannot spill at its end
Outlet
Clear, with the downpipe running free below it
Fig. 3 Gutters and downpipes, drawn close

Callout 3 of 3

Where slope meets wall, and the listed buildings nearby

Our third callout is the wall, the place where a slope ends against brick or stone, and lead is dressed in to seal the junction. Historic England's list records buildings near the middle of Whitecross, including 1, Three Elms Road and Cheslyn, both Grade II (list entries 1297412 and 1196891, first listed 27 July 1994). Flashing, as that lead strip is called, is wedged at the top into a joint we have raked clean, with the lower edge dressed over the slope. If it lifts or splits, rain gets behind it and the damp shows up inside the wall.

On a listed building, section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 means consent has to be sought before any work that alters its character. Listed houses keep their permitted development rights, yet that consent still comes first, and Herefordshire Council is where the application goes. The photographs from our survey can be attached to it. Our practice on a listed wall is to repair lead in lead and to match the new mortar to the masonry beside it, so the repair does not announce itself from the street. When a listed roof calls for more than a patch, the question goes to the council before the written total is final, so the price reflects what it will accept.

For the conservation area question on your own street, Herefordshire Council's list and boundary maps are the place to look. The county has 64, and the ones near Whitecross include Aylestone Hill, Huntington and Widemarsh Common. Ask the council too whether an Article 4 direction applies. A roof window or a dormer comes with planning questions, and our planning guide for roof windows goes through the conditions so that you can read them before you plan one.

For building control, Whitecross addresses use Herefordshire Council Building Control at Plough Lane, Hereford (01432 261938, bce@herefordshire.gov.uk), or a registered building control approver. We can work with either one, and the choice is settled before a larger job begins. Our listed and heritage roofing page follows a protected roof through every stage, ending with the last dressing of lead.

A lead abutment against a wall

SoundLead wedged into the joint and dressed close to the slope
Needs workLead lifted, mortar fillet cracked, a stain below on the wall

Ridges, gutters and listed walls in Whitecross

What does a rocking ridge tile on a Whitecross house tell you?

Should a capping tile shift under a hand, it has lost its mortar bed or its fixing, and rain gets through the open joint down to the top course, battens included. We lift the loose tiles, clear the old bed, rebed them and give every one its own mechanical fixing, since Marley notes that mortar cannot be the sole fixing any more. The photographs show you the old bed before the new one goes on.

Does a listed Whitecross house still have permitted development rights?

Yes, a listed house keeps its permitted development rights for roof work, but it needs listed building consent as well for any work touching its character. Historic England's list records Cheslyn, and 1, Three Elms Road, as Grade II. Herefordshire Council decides the consent, so the council settles the approach and the materials before any tile comes off the roof, and we photograph the roof beforehand for the application.

Which conservation areas lie close to Whitecross?

Herefordshire Council's conservation areas near Whitecross include Aylestone Hill, Huntington and Widemarsh Common, and the county has 64 in all. The council's map draws each boundary, so measure your own street against it before you alter how a roof looks. Ask Herefordshire Council as well whether your road falls under an Article 4 direction; a direction removes specified permitted development rights in a defined area.

When does a Whitecross re-roof go to building control?

Whitecross is in England, so the Planning Portal's test is two-part: under 25 per cent of the building envelope and under 50 per cent of the roof affected; stay under both limits and the Portal expects no application. Above them the job goes through building control, so we ask the council or an approver before the work starts. A bigger job, or a covering whose weight rises by 15 per cent or more, goes to Herefordshire Council Building Control or to a registered building control approver for approval.

Does a scaffold on the pavement outside a Whitecross house need a licence?

Yes. Section 169 of the Highways Act 1980 bars scaffolding that obstructs the highway unless it is licensed. Herefordshire Council charges £167 for a maximum of one month (£123 per month extensions), and the application is due at least 10 days before the scaffold is wanted. We arrange the licence with our scaffolder, and your single written price already carries the cost. Mention at the Whitecross survey if the house faces a main road.

Should a sagging Whitecross gutter be refixed or replaced?

If the brackets have dropped or a few joints have opened, refixing is the better buy, because the lengths themselves are sound. If the channel is cracked or warped, or fixed to a soft fascia, new lengths and a repaired board are the honest answer. Which? (November 2025 survey, ex VAT) puts a full gutter clear-out for one house at £75 to £350, so ask for the work you want priced on its own.

Book a ridge-to-wall survey in Whitecross

Describe the roof as it looks to you, attach a photo where possible, and we will set a survey date.

10-year workmanship guarantee, in writing