01432 610152 Get a quote Call 01432 610152

Roofers in Rocks Green

Roof work at Rocks Green, beside Ludlow and 23.8 road miles north of Hereford.

Every fault on your roof is photographed during the survey, and the price that follows is one total, in writing.

Get a free quoteCall 01432 610152

Gravel Hill, a listed well and Ludlow's edge

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Next to Gravel HillLudlow Gravel Hill is a conservation area on Shropshire Council's list, close by.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    St Julian's Well, Grade IIAny listed house near it needs consent before its roof changes.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Valleys, ridges and eavesLines where slopes meet need lead and fixings that are in good order.

The way to Rocks Green

Rocks Green on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Three survey stops above Rocks Green

Ridge fixings, valley lead and eaves airflow on a Rocks Green roof

The survey runs from the top line downwards: how the ridge is fixed, how the lead in a valley carries water, and how the eaves breathe and drain, with the English rules for Rocks Green set out at the end.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Ridge line; 2 Valley lead; 3 Eaves and rules.

Fig. 1 Ridge, valley and eaves numbered on a drawn house, as they apply at Rocks Green.

Callout 1 of 3

Ridge tiles at Rocks Green: bedding and fixings

We begin at the highest line on the house. Capping along the peak, where the two slopes come together, makes up the ridge. On a pitched house that capping is a row of ridge tiles, set on a bed of mortar or secured with dry-fix clips and screws. Each unit gets a push from a gloved hand as we walk the line from gable to gable, and any that moves has lost its bed. Cracked or open joints let rain onto the battens, the cross-timbers laid under the covering. Hips, the outward-sloping corners where slopes meet, get the same check, and so do the end tiles at each gable.

Marley, the tile maker, says "Installing to BS 5534 isn't required by law", and adds that the 2015 amendments made it clear that mortar "could no longer be relied upon as the only means of securing the roof covering". Mortar has not been banned. The standard for slating and tiling is BS 5534:2014+A2:2018, and ridge and verge systems fixed dry fall under BS 8612. When we rebed a ridge at Rocks Green, every unit gets a mechanical fixing as well, and the mortar line is dressed to suit the house.

Ridge units that have worked loose are a repair job and nothing larger, and the price reflects that. Photographs of the open joints and the rocking units go in the report. That lets you judge the fault before you commit to anything. Where the covering underneath is worn out, that goes in the report as well, with pictures beside it. Access to a ridge, whether by ladder or scaffold, sits inside the written total.

Look along a ridge from the gable end and the whole roof shows in outline. A line that sags points to a rafter or purlin that has moved. A ridge patched in three different mortars points to leaks that have come back. Both observations are noted for you. Marley notes that the 2015 amendments assumed higher wind loads and called for more fixings generally, so the Rocks Green ridge is not left to mortar alone. Gable ends, where the verge meets the ridge, are checked at the same visit, and each end unit is tried by hand in the same way. Our pitched roofing page covers how ridges, hips and the slopes between them are put right on tiled and slated houses.

Pressed and photographed along a Rocks Green ridge

  • Units that rock or have lifted
  • Open or crumbling joints
  • A clip or screw on every unit
  • Hip corners and the end tiles
  • Any dip in the line of the ridge

Walk a ridge with a gloved hand and the loose units announce themselves.

Fig. 2 The ridge, drawn close

Callout 2 of 3

Valleys, where two slopes drain into one channel

Slopes that run towards one another meet in a valley, which gathers the run-off of both and delivers it to the gutter at the foot. Its lining carries the run-off of both slopes every time it rains. In an open valley the lead shows between the two edges of the covering. In a closed valley the covering is cut to a line and lapped over it. Either way the lead underneath carries the load, so its thickness has to suit the job. Royston Lead's brochure lists Codes 4, 5, 6, 7 and 8 against a pitched valley gutter, and Code 3 only as "Recommended for lead soakers only". We pick the code for the valley in front of us.

Faults hide in valleys because the covering overlaps the channel edges. A tile or slate that has slipped at the edge lets debris pack in beside the lead. Leaves and moss hold water against the laps, and in a sudden downpour the channel can overtop and send water in beneath the covering. From inside, the sign is a brown stain on a ceiling, in line with the valley above it.

Cleaning a valley is a hand job. Silt, leaves and moss are lifted out and the lead is checked as it comes clear, fold by fold and lap by lap. A leaking valley is not always a worn-out one. The cause can be a blockage or a fixing, and the survey tells those apart from plain wear before any lead is cut.

A split along a fold is cut out and a new length is lapped in and dressed to the same line, with the covering relaid either side. You receive photographs from before and after. If a valley has been patched with sealant, the sealant comes off first, because it hides how far the lead has failed. The edges of the covering are then relaid on sound battens, and a final check follows with the lead clean and the channel clear, so that the first heavy rain does not find a gap. Our lead roofing page explains the codes, the folds and the way each flashing and valley is dressed.

A valley question

Why does a valley leak when the tiles around it look fine?

The tiles are not the barrier there; the lead underneath is. Debris packed beside it, a split fold or a slipped edge unit can let water past while the surface looks tidy from the ground.

Fig. 3 The valley, drawn close

Callout 3 of 3

Eaves, gutters and what England asks of a re-roof

At the foot of each slope the roof meets the wall, and air has to get in. Ventilation at the eaves is set out by Marley for HR underlay in a cold roof as "25mm along the length of the eaves for pitches of 15° or less; 10mm along the length of the eaves for pitches of more than 15°." HR (high resistance) underlay does not pass moisture vapour, so that gap is the only route by which damp air leaves the loft. Loose insulation packed into the eaves will choke it. We look for that from inside the loft, and for vents closed up by paint.

The gutter below needs a fall. Brett Martin, the manufacturer, advises "1mm for every 600mm" towards the outlet, and a run that holds water along its length has either sagged on its brackets or been fixed level. Brackets, joints and stopped ends are looked at together with the board behind, since a rotten fascia board lets down the gutter that hangs from it. Downpipes are traced from the outlet to the drain as well, since a blocked pipe sends water back over the gutter edge and down the wall face.

On an English address such as Rocks Green, the Planning Portal draws its line at 25 per cent of the building envelope and 50 per cent of the roof: below both, re-covering normally goes ahead with no application. A heavier covering is judged separately: the Portal's trigger is 15 per cent or more of extra weight, and AD A calls more than 15% a significant change. Adding insulation in the same job brings Part L in, and AD L 2021 Table 4.3 gives a retained roof a threshold of 0.35 and an improved figure of 0.16.

Ludlow Gravel Hill is a conservation area on Shropshire Council's list and lies close to Rocks Green. The nearest listed entry in the village area is St Julian's Well, Grade II (list entry 1202883, first listed 9 August 1993). Check whether an Article 4 direction applies with Shropshire Council, and read our planning guide for roof windows before planning a dormer. Building control is Shropshire Council Building Control on 01743 258710, or a registered building control approver.

Eaves and gutter, sound and failing

SoundGutter falls to the outlet and the eaves vents are clear
Needs workWater standing in the run, vents blocked or painted shut

Rocks Green roofs: Gravel Hill, valleys and venting

Do I need to ask anyone before repairing a Rocks Green roof near the Ludlow Gravel Hill conservation area?

Shropshire Council lists Ludlow Gravel Hill as a conservation area close to Rocks Green, and Shropshire Council can confirm whether a particular house stands inside it. The designation comes into play when you want to add something, a dormer for instance. Before you plan anything beyond repairs, check whether an Article 4 direction applies with Shropshire Council, and read the planning guide on our site.

How can I find out whether my Rocks Green house is listed?

Search the National Heritage List for England by address. The nearest entry for the village area is St Julian's Well, Grade II, list entry 1202883, first listed 9 August 1993. If your house has an entry of its own, section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 means consent is needed for work that changes its character, and Shropshire Council decides it.

What does a failing valley look like from inside a Rocks Green house?

A brown stain on a ceiling or an upstairs wall that follows the line of the valley outside. In the loft there may be darkened rafters or damp underlay beneath the channel. A stain tells us roughly where to look, but the cause is found from the roof, where we photograph the lead, the edge units and any packed debris, then explain the repair.

Why does underlay type matter when I insulate a Rocks Green loft?

HR underlay lets no moisture vapour through, so Marley asks for 25mm of ventilation along the eaves of a cold roof at pitches of 15° or less, and 10mm above that. Insulation pushed into the eaves blocks that air path and can leave the loft damp. We check the vents and the underlay first, and tell you what we found before any new insulation goes in.

Does a re-roof at Rocks Green go through Shropshire's building control?

The Planning Portal's rule for England is that re-covering under 25 per cent of the building envelope and under 50 per cent of the roof sits inside both limits and needs no application in the ordinary way. Larger jobs, heavier coverings and insulation upgrades go to building control instead. Call Shropshire Council Building Control on 01743 258710, or use a registered building control approver, and ask before the work starts.

How far should a gutter fall along a Rocks Green house?

Brett Martin advises 1mm for every 600mm towards the outlet. On a ten-metre run that is under 17mm of drop in total, so a gutter can look level and still be wrong. We sight along each run and check the brackets and fascia, because a bracket that has dropped or a board that has rotted will leave water lying in the run.

Book a ridge-first survey near Ludlow

Describe the Rocks Green roof as it stands, and we will go over it from the peak downwards and quote in writing.

10-year workmanship guarantee, in writing