Callout 1 of 3
Flat roofs: coverings, lifespans and metal
A flat roof on a rear extension, a porch or a garage fails in a different way from a pitched one. Water has no slope to run down, so it stands on the surface, finds the weakest seam and tests every upstand. The covering can be one of a handful: torch-on felt, EPDM rubber, GRP, lead or zinc. Each has a published lifespan, and the published ranges overlap rather than match.
| Covering | HomeBuilding | Less |
|---|---|---|
| EPDM | 25 to 30 years | 30 to 50 years |
| GRP | 25 to 30 years | 25 to 40 years |
| Felt | 10 to 15 years | 10 to 20 years |
For a lead flat roof, HomeBuilding gives 60 to 100 years and Less gives 50 to 100. VMZinc, which makes zinc roofing, says a correctly designed and installed zinc roof can last in excess of 100 years; because a maker has an interest in that figure, it is read as the maker's claim and not as a forecast. Treat them as ranges that someone measured, not as promises, since a roof is judged on its present state.
BS 6229:2025 is the current standard for flexible membranes laid continuously over a flat deck, such as felt, EPDM and GRP. It leaves lead out, and Approved Document C points to BS 6915 for lead. The earlier edition, BS 6229:2018, was withdrawn on 16 December 2025, so any specification that still cites it is out of date.
A roof called flat still needs a fall toward its outlets, which is why ponding is the first sign we look for. On the roof we look for water standing after rain, blisters, splits at laps and upstands, blocked or loose outlets, and soft patches in the deck. A patch is offered when it will hold, and where the membrane has failed over the whole roof, a new covering is offered in its place. A single written total comes after the survey, and the photographs show which case your roof is. Upstands and flashings along the flat roof's edge against a wall are photographed too, since a seam that fails there lets water down the wall. Where a flat roof sits beside a pitched one, the junction between them is traced for staining on the ceilings below. Our flat roofing page covers repair and replacement.
Falls on a Malvern Link flat roof
- Standard
- BS 6229:2025, for flexible membranes only
- Minimum finished fall
- 1:80, according to NFRC
- Design fall
- IKO advises designing for 1:40 to achieve it
- Lead
- Outside BS 6229, which AD C refers to BS 6915
A patch is offered when it will hold, and renewal when the whole membrane has failed.















