Callout 1 of 3
Ridge and hip capping on a Malvern roof
A Malvern survey begins at the top of the roof. The ridge is the crest of the roof, and capping tiles run along it, either mortar-bedded or fixed without mortar, using clips and screws (BS 8612 sets the specification for dry-fix). Hips, the angled outer corners, are capped the same way. Every capping unit is pressed by hand. One that wobbles has no mortar left beneath it, and open joints give rain a route down to the battens under the covering. The same walk covers the verges and the gable ends, so that no edge is skipped. We also sight along the line from each gable, because a ridge that dips shows that the timbers under it have moved.
Marley, a tile maker, says "Installing to BS 5534 isn't required by law", while noting that the 2015 amendments meant mortar "could no longer be relied upon" as the sole fixing. BS 5534:2014+A2:2018 is the current standard for slating and tiling work. Mortar is not banned, so where a bedded ridge belongs to the look of a building, the bedding stays and each unit is backed with its own clip or screw.
Malvern is in England, so for a larger job the Planning Portal supplies the test: no application is normally needed if "Less than 25 per cent of the total 'building envelope'" is affected and "Less than 50 per cent of the roof is affected." Re-bedding a ridge counts as a repair, and the price says so. A heavier covering is another question. The Portal requires approval when the covering added is heavier by 15 per cent or more, AD A phrases its threshold as "more than 15%", and either way the matter is Building Regulations, not planning, with a structural check of the rafters behind it.
Building control for a Malvern address is South Worcestershire Building Control, which Malvern Hills District Council runs with Worcester City Council and Wychavon District Council. A registered building control approver is the private alternative. Your report carries a photo of every loose capping unit, each open joint and each hip end, so you see the state of your own ridge before deciding anything. For re-covering a whole slope, our pitched roofing page has the detail.
Checked along a Malvern ridge and hips
- Capping that moves under a gloved hand
- Cracks between the capping and its bed
- Clips or screws holding each ridge tile
- Hip ends where the capping stops
- Mortar fallen into the loft below
The faults on a ridge are shown to you before any price is set.















