01432 610152 Get a quote Call 01432 610152

Roofers in Kempley

Roof repairs and re-roofs for Kempley homes, from the ridge and hips down to the valleys.

From Hereford, Kempley is 16.4 road miles to the south-east, about 31 minutes' drive. Photographs of each fault come first.

Get a free quoteCall 01432 610152

Hips, gables and valleys in Kempley

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Hipped stone-slate roofsThe Victoria County History records a hipped, stone-slated roof at Kempley Court.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Three gables and their valleysA tiled rear range in three gabled sections has valleys between the gables.
  • Newer homes with grey concrete tile roofs along a curving estate road
    A Grade II* churchThe Church of St Edward the Confessor is Grade II*, so listing matters here.

Our map of Kempley

Kempley on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Kempley roofs, hip to valley

Hips, valleys and a listed church: the Kempley survey in three callouts

We take a Kempley roof apart in the order a survey meets it: the hip and its stone slates first, then the valleys between gabled sections, then the verges and the listing rules that govern any change.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Hips and stone slates; 2 Gabled sections; 3 Verge and church.

Fig. 1 A roof drawn in section, with three Kempley callouts numbered from the hip outward.

Callout 1 of 3

A hipped roof under stone slates

The Victoria County History's 2010 account of Kempley says of Kempley Court, rebuilt by Thomas Pyndar after 1686, that "The roof over the front pile is hipped and covered with stone slates". That is one house, not a pattern for Kempley as a whole, but it names three things any survey of such a roof has to handle: a hip, a stone slate and the ridge they run into. A hip is the rib that runs down an outward corner of the roof, from the ridge to the eaves. Stone slates are thin slabs of stone laid in courses on battens, and they are heavy.

Weight is the first question when a covering changes. The Planning Portal gives the weight test as a new covering that "increases the weight of the roof covering by 15 per cent or more", which brings in approval and a structural check. SPAB, which advises on old roofs, has written that "many are changed to different stones or even to slates or fake stone slates", and that "Claims of unavailability or long delivery times should always be checked with the quarries". That check comes before we suggest replacing any stone, and we photograph the slabs that are cracked or have slid. Each loose unit is shot from above, and the pictures go into the report with a note of which are repairs and which, if any, are replacements.

Along the hip and the ridge we press every capping unit and check the bedding below it. Marley, a tile maker, says that "Installing to BS 5534 isn't required by law" but that mortar "could no longer be relied upon as the only means of securing the roof covering", so a rebedded hip carries a mechanical fixing beside the mortar. BS 8612 covers dry-fix systems.

The paperwork for a Kempley house is English. The Planning Portal draws the line here: "Less than 25 per cent of the total 'building envelope'" is affected and "Less than 50 per cent of the roof is affected". Insulation follows: AD L 2021 Table 4.3 sets a threshold of 0.35 and an improved figure of 0.16 for a roof being renovated, until AD L 2026 Table 3.3 takes over on 24 March 2027. Our roof repairs page covers a hip that needs rebedding, from a few capping units to a full relay.

Checked along a Kempley hip

  • Capping units that rock or have slid
  • Bedding below each hip and the ridge
  • A mechanical fixing beside the mortar
  • Cracked or slipped slabs on the slope
  • The hip foot where it meets the eaves

Weight decides what a hipped roof can carry, so the covering is never swapped on a guess.

Fig. 2 The ridge, drawn close

Callout 2 of 3

Three gables and the valleys between them

The same account says the roof over the rear pile "is in three gabled sections and tiled". Gables side by side leave valleys between them, the V-shaped channels where the sloping sides of neighbouring roofs meet. Each valley drains two slopes at once, and where a ridge runs into it the water arrives from three directions. The foot of each valley, where the flow leaves into the gutter, is the point we look at longest.

A valley can be lined in lead, built of tiles cut to follow it, or finished with an open channel of sheet metal. Lead is sold by thickness, and Royston Lead's table gives each a code. Codes 4 to 8, from 1.80mm to 3.55mm, are all marked for a pitched valley gutter, while Code 3 is "Recommended for lead soakers only". Soakers are small folded lead pieces slid under every course alongside a wall or at a valley edge. Code choice follows how long the run is and what load it takes, and the sheet goes down with room to swell and shrink.

What goes wrong is easy to see once you know where to look. Moss and leaf litter pack the channel and tip water over the edge of the sheet; lead laid too thin for its width creases and splits along its folds; and the tiles that bank up against the channel can crack or slide. The gutter at the foot matters as well. Brett Martin's guidance on fitting gutters is a fall of "1mm for every 600mm", so a run that sits level holds water that a valley then has nowhere to send. Where the gutter at the valley foot is blocked, we clear it before judging the fall, because a blocked run may look worse than the lead beneath it.

In the loft we trace any stain upward along a rafter to the valley above, because a ceiling stain can appear some distance from where the water got in. MyJobQuote says correctly installed lead flashing "can last for over 80 years", which is a hedge about flashings and no promise about a valley. Our lead roofing page explains how a valley is cut out and relaid.

A valley leak, from indoors

Where does a valley leak show inside the house?

As a stain on a ceiling or wall below the line where two slopes meet. Water can run along a rafter before it drops, so the mark may sit away from the fault, and we trace it from the loft.

Fig. 3 The valley, drawn close

Callout 3 of 3

Verges, the church and the Forest of Dean rules

Each gabled section ends in a verge, where the roof stops at the gable wall and hangs a little beyond it. The verge is either set in a mortar bed or clipped on with dry-fix units; the fault we look for is a crack where wall and covering part, letting wind get beneath the last row. A cracked mortar bed, a lifted end tile or daylight seen from the loft along the gable all point to it. A verge is cheaper to repair on the day it is found than after the battens below have rotted.

The Church of St Edward the Confessor is listed Grade II* (list entry 1156349, first listed 17 March 1987), as Historic England's list records. Section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 turns on whether the work alters "its character as a building of special architectural or historic interest". A listed house keeps its permitted development rights, with consent on top. For the church roof, begin with the body that governs the church. At the 2021 Census, Kempley parish had 283 usual residents.

Forest of Dean District Council is the planning authority for Kempley. The nearby Much Marcle conservation area lies over the county line and belongs to Herefordshire Council, which dates it to 1976; for your own Kempley address, check Forest of Dean District Council's conservation area list. Forest of Dean District Council publishes two Article 4 directions in its district, at Newnham and English Bicknor, so ask the council if you are unsure about your street. Forest of Dean Building Control answers on 01594 812315, and a registered building control approver is the alternative. Planning a roof window or dormer? Read our planning guide for roof windows first. Our listed and heritage roofing page covers protected houses in more detail.

A gable end is also where bats and nesting birds use a roof. Bat work in England is licensed by Natural England, and section 1 of the Wildlife and Countryside Act 1981 shields a bird's nest, occupied or under construction, from being intentionally taken, damaged or destroyed. If either is found, we pause that section and get advice before going on.

Daylight along a gable is the plainest sign that a verge has let go.

A gable verge, sound and tired

SoundMortar bed whole, end tiles tight, no daylight along the gable
Needs workCracked bed, lifted end tiles, daylight visible from the loft

Kempley roofs: stone slates, valleys and listing

What does a survey check on a hipped stone-slate roof in Kempley?

We press the hip and ridge units, check the bedding beneath them, and look across the slope for cracked or slipped slabs. Stone is heavy, so swapping to a covering of another weight brings a structural check first. The rafters and battens under the slabs are checked from the loft too. The report describes what we see, with photographs, and says whether repair or replacement is the honest answer for your slabs.

Does a gabled Kempley roof need lead in its valleys?

Not necessarily; valleys are also formed with purpose-made tiles or another sheet metal, as well as lead. Where lead is used, Royston Lead's table lists Codes 4 to 8 for a pitched valley gutter, and the code depends on the length and the load. We inspect the existing valley before recommending anything, and a split in sound-looking lead is cut out and joined, not covered over.

Would a Kempley re-roof need building control sign-off?

Kempley is in England, so the Planning Portal's two-part test is the guide: "Less than 25 per cent of the total 'building envelope'" affected, and "Less than 50 per cent of the roof". A job that clears both limits stays, normally, outside the need to apply. A bigger job, or a heavier covering, goes to building control: Forest of Dean District Council runs a building control service of its own, or a registered building control approver can take the work instead.

What is the scaffold licence position for a Kempley house?

Any scaffold placed on the public highway or its footway needs permission under section 169 of the Highways Act 1980, and we arrange the licence with our scaffolder. Gloucestershire County Council lists its licence at £145 for a minimum of 28 days, then £36 per 7 days, and requires a minimum of twelve calendar days' notice before erection. A scaffold kept entirely inside the garden, away from the public highway, needs no county licence. The scaffold is carried in our written quote.

What consent does work to a listed building in Kempley need?

Listed building consent, under section 7 of the 1990 Act, for any work that alters a listed building's special character, and Historic England's list gives the grade and the entry. A listed house keeps its permitted development rights and needs consent on top. For the church, start with the body that governs it. Forest of Dean District Council can tell you whether a house is listed or sits inside a conservation area.

Which conservation area lies near Kempley?

Much Marcle is the nearby one, and it is a Herefordshire Council area, not one of Forest of Dean's. For your own Kempley address, check Forest of Dean District Council's conservation area list. That council's Article 4 page names two directions, at Newnham and English Bicknor, and a direction withdraws specified rights. Conservation areas are designated by the council, and inside one, some works need permission where the same works elsewhere would not.

A hip-to-valley survey in Kempley

Mention the leak, the slipped slabs or the plan for a new roof, and a survey visit follows with the written total.

10-year workmanship guarantee, in writing