01432 610152 Get a quote Call 01432 610152

Roofers in Aston Ingham

Slate and tile repairs for Aston Ingham, a village south-east of Hereford.

We climb to the ridge first, photograph each fault we find and set one total price down in writing.

Get a free quoteCall 01432 610152

Slate, tile and a Grade II* church

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    A slated parish churchThe 1932 inventory recorded the roofs of St John the Baptist as slate-covered.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    A tiled rectoryThe same inventory described the rectory as brick-walled with tiled roofs.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Linton conservation area nearbyHerefordshire Council's list shows whether a boundary reaches your lane or your house.

Around and about Aston Ingham

Aston Ingham on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Aston Ingham roofs, ridge to eaves

Aston Ingham in three callouts: a tiled ridge, a slate slope, church eaves

The survey runs from the top down: capping on a tiled house first, then a slate slope of the kind recorded on the parish church, then the eaves, where gutters, consent and road access begin to matter.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Ridge; 2 Slate slope; 3 Eaves and gutter.

Fig. 1 Border house in section, the three Aston Ingham callouts numbered from the top.

Callout 1 of 3

The crest of a tiled village house

Every survey of ours opens at the crest, where the two slopes meet and a row of capping tiles shuts the gap. The Royal Commission on the Historical Monuments of England surveyed Herefordshire in the early 1930s, and its 1932 volume says of the rectory in Aston Ingham that "The walls are of brick and the roofs are tiled." A brick house under a tiled roof is the picture we begin with. The covering on your own house may have been renewed since then, so the survey reads what is actually up there.

Capping tiles are bedded in mortar, or clamped down by dry-fix clips and screws that need no mortar at all. We test each tile with a hand. One that shifts has lost its bed, and an open joint lets rain run onto the top course and through to the battens, the thin timber laths that carry the tiles. At a hip, the angled join where two slopes meet at an outside corner, two lines of capping finish on one spot, so that junction is checked twice and photographed on its own.

Marley, the tile maker, says "Installing to BS 5534 isn't required by law", and adds that after the 2015 amendments mortar "could no longer be relied upon as the only means of securing the roof covering". BS 8612 is the specification for dry-fix ridge and verge parts. Nothing has been banned, so a mortared ridge can stay mortared, but each capping tile also takes a mechanical fixing. At a gable wall we look along the verge, the roof's overhanging edge, for loose bedding and for cracks against the brickwork.

The crest cannot be judged from the lane, so we reach it by ladder or scaffold tower and photograph the whole line in close-up. A loose ridge is a repair and is treated as one. If the survey finds a covering that has run its course, the Planning Portal gives two tests for England, and a job touching less than 25 per cent of the building envelope and less than 50 per cent of the roof normally needs no application. A heavier new covering, 15 per cent or more above the old weight, needs Building Regulations approval and a structural check first. The verge is the part people forget, since mortar there cracks as the wall behind it moves a little each winter and summer. Our roof repairs page covers the smaller jobs, from a handful of slipped tiles to a rebedded ridge.

Checked along an Aston Ingham ridge

  • Capping tiles that shift under the hand
  • Mortar joints that have opened or crumbled
  • A mechanical fixing on each capping tile
  • The hip junction, where two lines meet
  • The verge and end tile at each gable

A cap tile that shifts under a gloved hand needs rebedding, and a close photograph shows which.

Fig. 2 The ridge, drawn close

Callout 2 of 3

A slate slope, as recorded on the parish church

The second callout drops from the crest onto the slope. That 1932 inventory records the roofs of the Parish Church of St John the Baptist in Aston Ingham as "covered with slate". The church is listed Grade II*, list entry 1099646, first listed on 17 March 1987. Slate goes on in overlapping courses, each slate fixed at its head and shielding the joint below. When one slips, its neighbours lose their cover, and the first sign indoors can be a brown ring on a ceiling.

We work along each course looking for slipped, cracked or flaking slates, for fixings that have rusted through, and for lead where the slope meets a wall. Royston Lead's table lists Codes 4, 5 and 6 for flashings, and Code 3 is marked as "Recommended for lead soakers only", so the thickness is matched to the job. Cupa, the slate supplier, reports that BS 5534:2014+A2:2018 gives natural slate a minimum roof pitch of 20 degrees in moderate exposure, with a slate 500mm long and a 115mm overlap, and puts no slate hooks on any pitch under 25 degrees. The pitch, the slate length and the fixing method all feed into a repair. A slate pushed in without those checks can slip again within a season.

Slate lasts when it is kept in order. HomeBuilding gives Welsh slate as "100+ years", and SPAB says the life of a well-slated roof is "likely to be more than 100 years". Neither figure is a promise, but together they explain why sound slates are worth stripping, sorting and refixing, with new slate making up the shortfall in matching size and colour. If a supplier tells you a slate cannot be had, SPAB's advice is to put the question to the quarries direct, and we do that before we suggest another covering.

Swapping slate for something heavier or lighter is a bigger decision than a repair, and it brings in Building Regulations. Our slate roofing page sets out how a slope is stripped, sorted and relaid, and how we photograph the underside of the slates for you.

A slate slope at an Aston Ingham house

SoundCourses lie flat, every slate fixed, laps unbroken
Needs workSlipped slates, rusted fixings, stained battens beneath

Callout 3 of 3

Gutters, listed walls and the lane outside the gate

The last callout is the eaves, where the roof stops and the gutter begins. Brett Martin, the guttering maker, advises a fall of "1mm for every 600mm" towards the outlet. A run that sags holds water, and a brimming gutter soaks the wall beneath it and the rafter feet above. We look for sagging brackets, open joints, loose downpipes and a stained wall. A gutter is also where birds nest. Section 1 of the Wildlife and Countryside Act 1981 makes it an offence to intentionally damage or destroy a nest that is being built or is occupied, so a nest at the eaves changes the order of the work. Our guttering, soffits and fascias page covers renewal and the roofline boards behind it.

Aston Ingham has a Grade II* church, and listing changes who must agree to what. For a listed house, section 7 of the 1990 Planning (Listed Buildings and Conservation Areas) Act asks for consent before any work that changes what makes the building worth listing. A listed house keeps its permitted development rights, though consent is required in addition. The church is a separate case. St John the Baptist is Church of England property, and during its use for worship the roof sits under the faculty jurisdiction and no listed building application goes to the council.

Linton, close by, has a conservation area, designated by Herefordshire Council in 1978, and the council's list shows whether a boundary reaches your house. Herefordshire has 64 conservation areas in all. Herefordshire Council can also confirm whether an Article 4 direction applies. Roof windows and dormers meet the strictest planning rules, so read our planning guide for roof windows before drawing one.

Herefordshire Council Building Control, the council's own team at Plough Lane in Hereford, answers on 01432 261938 and at bce@herefordshire.gov.uk. You may instead appoint a registered building control approver. Work that touches the structure, the weight of the covering or the insulation goes to one or the other, and we tell you which parts of a job those are before it starts.

Gutter and eaves lines at an Aston Ingham house

Fall
A slope towards the outlet, set to Brett Martin's advice
Brackets
Spaced to carry a full gutter, fixed into sound timber
Joints
Sealed and dry, with no drip marks on the wall
Downpipe
Clear, secure and discharging away from the footing

Aston Ingham roofs, slate and consent questions

What do the old records say Aston Ingham's church and rectory were roofed with?

The 1932 Royal Commission inventory of Herefordshire describes the roofs of St John the Baptist as covered with slate, and the rectory as brick-walled with tiled roofs. A roof can be recovered more than once in ninety years, so the covering on a house today may differ from either. The survey records what is on yours, and any old slate or tile that has survived is repaired in kind where matching stock can be found.

Does re-covering an Aston Ingham roof need Building Regulations approval?

Aston Ingham is in England, so the Planning Portal tests apply: work affecting less than 25 per cent of the building envelope and less than 50 per cent of the roof normally needs no application. A bigger job goes to building control for a decision. New insulation brings in Part L: AD L 2021 Table 4.3 sets a threshold of 0.35 and an improved figure of 0.16, until AD L 2026 Table 3.3 takes over on 24 March 2027.

Which conservation area is near Aston Ingham, and does it matter for my roof?

Herefordshire Council's list includes Linton, a conservation area near the village. It matters only if its boundary takes in your house, and the council can settle that for your address. Within a conservation area a dormer at Aston Ingham goes to Herefordshire Council first, while mending in matching tile does not. Check whether an Article 4 direction applies with Herefordshire Council too, because a direction can remove rights a house would otherwise keep.

Who gives consent for roof work on St John the Baptist's church in Aston Ingham?

The church is listed Grade II* and is a Church of England building; for as long as services continue, the faculty route authorises its roof work, and the council does not. A closed chapel, or a Unitarian or Quaker meeting house, would need listed building consent from Herefordshire Council instead. Nobody should start on a church roof until the route has been confirmed in writing.

How long does a scaffold licence for an Aston Ingham lane last?

Herefordshire Council charges £167 for a licence covering a maximum of one month, £123 for each month after that. Applications go in at least 10 days ahead of erection. We arrange the licence with our scaffolder, and the cost sits inside the one price in your quote. Herefordshire Council Highways Licensing answers licence calls on 01432 261800. A busy road outside an Aston Ingham house is raised with the council before booking.

How long can a slate roof last above an Aston Ingham house?

HomeBuilding gives Welsh slate as "100+ years" and Spanish slate as "75-100 years", while SPAB says a well-slated roof is "likely to be more than 100 years". Treat each as a guide for sound, properly fixed slate rather than a promise. A slope with rusted fixings or slipped slates can need repair long before the slate itself has worn out, which is why the survey looks at both.

Ask for a survey of your Aston Ingham roof

Tell us the address and what you can see from the ground, and we will arrange the survey and the photographs.

10-year workmanship guarantee, in writing