Callout 1 of 3
Reading the ridge on a Newent house
Every Newent survey of ours opens on the ridge, the top line where the roof meets the sky. Capping tiles run along it, set in a mortar bed or, in a dry-fix system, locked down by clips and screws. All the slopes drain away from this line, so a fault here sends water into the course below and onto the battens, the thin timber strips the tiles hang from. We press each capping tile in turn, because one that moves has lost the mortar beneath it.
A look from inside the loft adds what the street cannot show. Light showing along the ridge, or pale grit scattered on the underlay, means a bed has crumbled, whether or not a ceiling has stained yet. A hip is the sloping corner that juts outward between two slopes. Three runs of tile come together there, and that junction is checked on its own. The tile at the end of each gable has no neighbour to lean on, so it is tested separately and photographed from the ladder, which means the picture you receive shows your own roof and nobody else's.
Marley, the tile maker, writes that "Installing to BS 5534 isn't required by law" and that after the 2015 amendments mortar "could no longer be relied upon as the only means of securing the roof covering". BS 8612 is the standard for dry-fix. In practice a ridge rebedded in Newent receives a mechanical fixing under or beside each tile, and a house that suits a mortar finish keeps its bedded look.
A tired ridge is priced as a repair. Whether the slopes need more is a separate finding, shown to you in photographs. Should the covering be spent, the Planning Portal's England test is the guide: normally nothing has to be applied for while under 25 per cent of the building envelope and under 50 per cent of the roof is affected. The Planning Portal also says a new covering that weighs 15 per cent or more beyond what is there now needs Building Regulations approval, with an engineer's look at the structure beforehand. Smaller ridge and flashing jobs are described on our roof repairs page.
What we press, pull and photograph on the ridge
- Each capping tile, pressed by hand
- Mortar joints, cracked or missing
- Light or grit seen from the loft
- The hip junction, where three runs meet
- The end tile at each gable
A ridge that has lost its mortar can be rebedded without touching a single slope.















