Callout 1 of 3
Seventeenth-century frames under tile and slate
Start with the frame. Volume 3 of the Royal Commission's Herefordshire inventory (1934) describes its monuments 2 to 7 in Humber parish as buildings that "are of the 17th century and of two storeys, timber-framed and with tiled or slate-covered roofs". The wording covers one group of buildings and says nothing about every house in the parish, so we take it as a prompt to look and never as a rule about your roof. A framed house in Humber may carry clay tile, concrete tile or slate today, and the survey records which.
We begin where the covering meets the timber. The wall plate is the length of oak or softwood laid on the wall head to take the rafters, and the rafter feet are the lower ends of the sloping timbers. From the loft we look at both for staining. Outside, we look at the verge, the end of the roof at a gable, for any opening between timber and covering. We open up one sound area to see whether the battens, the cross-timbers that the tiles are hung on, and the underlay have kept their condition. A slipped tile beside a post can mean the timber has shifted, so the photographs show where the fault sits as well as what it is.
Timber needs to stay dry, so we aim the repair at the cause. A few courses laid again properly beat a sealed gap with the cause still behind it. Where a whole slope has worn out, approval comes next. The Planning Portal gives two limits for England, and while the work stays under both the normal outcome is no application: less than 25 per cent of the building envelope, and less than 50 per cent of the roof. Humber is in England, so that is the test for a Humber address, and Herefordshire Council Building Control can confirm how it applies to yours.
A heavier covering loads a frame differently. In the Planning Portal's guidance, a new covering that adds 15 per cent or more to the weight on the roof is the point where Building Regulations approval applies, and the rafters are assessed structurally before anything is ordered. Lifespans are ranges and never promises: Marley expects roof tiles to last "around 60 years", while HomeBuilding gives plain concrete tiles "40-50 years". Our pitched roofing page lists the coverings we fit.
Checked where a Humber covering meets the frame
- Wall plate and rafter feet from the loft
- Verge mortar and the gap to the frame
- Batten condition at a sound spot
- Underlay laps under the lifted units
- The first courses at the eaves
Where tile meets timber is where we start, and where most of the photographs are taken.















