Callout 1 of 3
Capping, mortar and clips along a Bodenham ridge
Our climb begins at the highest line of any Bodenham house: the ridge, where two slopes meet under a run of capping tiles. Those tiles are either bedded in mortar or held down with dry-fix clips and screws. When the Royal Commission on the Historical Monuments of England surveyed the parish for its 1932 Herefordshire inventory, it described the monuments it listed here as "of the 17th century" and "timber-framed", with roofs that were "tile or slate-covered". Houses of that age may since have had a new covering, or several, so the ridge you see today could cap clay tile, natural slate or something laid since, and each of them is finished in its own way.
We go along the line from one gable to the other and press down on every capping tile. A tile that rocks has lost the mortar under it. Where a joint has crumbled, rain gets in to the top course and to the battens, thin timber laths over which the tiles are hooked. A hip is the angled corner that runs down from the ridge to the eaves, and at the point where it joins the ridge three lines of tile meet, so we look at that junction twice.
Marley, the tile maker, says "Installing to BS 5534 isn't required by law", and states that the 2015 amendments made it clear mortar "could no longer be relied upon as the only means of securing the roof covering". BS 5534:2014+A2:2018 is the standard behind slating and tiling work, and BS 8612 deals with dry-fix systems at ridges and verges. Mortar is not outlawed. On a ridge we reset, each tile gets a mechanical fixing beside its bed, and on an older house the bedded appearance can stay where it suits the building.
A ridge that has come loose is a repair, and it is priced as one. A re-roof enters the conversation only when the whole covering turns out to be spent, and for an English address the Planning Portal gives a test: an application is normally unnecessary if less than 25 per cent of the building envelope is touched and less than 50 per cent of the roof is touched. Weight is a separate question. The Planning Portal puts the trigger for approval at 15 per cent or more, and the first step is a structural check. Our roof repairs page covers the smaller jobs, and roof replacement covers the larger ones.
Along the Bodenham ridge line
- Capping tiles that rock under a hand
- Mortar joints that have crumbled or opened
- Clips or screws holding each capping tile
- The meeting point of ridge and hip
- End tiles at both gables
Press every capping tile along the line, because the one that rocks is the one that has lost its bed.















