01432 610152 Get a quote Call 01432 610152

Roofers in Guarlford

Guarlford roofing, from the ridge line to a listed church and Court.

We read the ridge first, show you photographs of what is wrong, and price the repair as a single written total.

Get a free quoteCall 01432 610152

Guarlford roofs between ridge, church and Court

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Ridge tiles bedded or clippedRidge tiles are bedded, clipped or both, and we check every fixing.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Listed church and CourtSt Mary's and Guarlford Court are Grade II, so consent precedes any new covering.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Gutters that carry the lotA blocked or sagging gutter soaks the wall face as well as the fascia.

Guarlford in our service area

Guarlford on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Guarlford roofs, ridge to gutter

Ridge, listed walls and gutter: a Guarlford roof in three stops

Our first stop is the ridge and whatever holds it down; next come the church and the Court, where listing sets the pace; last are the gutters, with the licences, approvals and paperwork a roof job brings.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Ridge; 2 Listed walls; 3 Gutters.

Fig. 1 Ridge, wall and gutter marked on one section through a house.

Callout 1 of 3

The ridge, and what actually holds it down

A Guarlford survey starts at the highest line of the house, under the capping tiles of the ridge. Capping sits on a mortar bed, is clipped and screwed, or has both. Marley, a tile maker, notes that "Installing to BS 5534 isn't required by law", yet since the 2015 amendments "mortar could no longer be relied upon as the only means of securing the roof covering". BS 8612 is the British Standard behind dry-fix systems, where mechanical clips and screws replace the bed of mortar. Nothing bans mortar. A mortar bed on its own is simply not what holds a repaired ridge, so every capping tile we reset is fixed mechanically as well as bedded.

Our check follows the ridge line from gable to gable, with a knuckle rapped on each capping tile. A tile that moves underfoot is sitting on bedding that has gone. Gaps in the mortar open a path for rain to the first full course and to the battens beneath, which are the timber laths that carry the tiles. The end tile at each gable takes weather from two sides, so its bedding gets a second look, and from the loft we search for daylight along the ridge and for timber that has gone dark with damp.

Age comes up early in any ridge discussion. Marley expects roof tiles "to last for around 60 years", while HomeBuilding gives plain concrete tiles "40-50 years" (approx), so the two sources differ and neither is a promise. For clay tiles, the BRE determined a minimum life expectancy of 60 years. A tile near the end of its life flakes, breaks at its nibs or soaks up water, and no ridge repair can cure a covering that has failed.

If the slopes are worn, the survey shows you the evidence on your own roof. If only the ridge has failed, the ridge is repaired and the rest left alone. A full re-cover is quoted only when the slopes themselves have given up. Our roof repairs page sets out how a small job is done, from lifting the capping to resetting the end tiles, and the photographs before and after go into the report.

A ridge repair, step by step

Capping tiles
Rocking, lifted or cracked ones taken off
Bed
Fresh mortar where the old has gone
Fixing
Mechanical, as well as bedded
End tiles
Last tile at each gable re-set
Report
Photographs before and after the work

When only the ridge has failed, only the ridge is touched.

Fig. 2 The ridge, drawn close

Callout 2 of 3

St Mary's church, Guarlford Court and the consent question

St Mary's church (list entry 1098842) and Guarlford Court (list entry 1157129) are both listed Grade II, and each was first listed on 23 February 1987. The parish had 261 usual residents at the 2021 Census, according to the ONS. Work on either begins with the question of who has to say yes.

For the Court, or any listed house, section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990 requires consent for works that affect "its character as a building of special architectural or historic interest". A listed house keeps its permitted development rights, and consent is added on top. Re-covering in a new material is the sort of change that tests it. If the roof is slate, SPAB advises that a claim of slate being unavailable, or slow to arrive, "should always be checked with the quarries". We make that call before suggesting a different covering, and the report records the pitch, because the pitch limits what can go back on the rafters.

For the church, the faculty system covers Church of England churches that are in use. Catholic dioceses and Methodist and URC congregations each run a scheme, and Baptist Union members are exempt where a Schedule 1 trust corporation holds the chapel. Churches no longer in use, plus Unitarian and Quaker buildings, fall back on listed building consent from Malvern Hills District Council. St Mary's describes itself as a small rural church on a sharp bend of the B4211; it is Anglican, its service times published by the benefice, and that puts it on the faculty route while it stays in use. The first call still goes to the people who run it.

Whatever the route, the first thing we produce is a written record of the roof in its present state: covering, pitch, fixings, lead and gutters, each photographed, with the ridge and the eaves shown from the ladder. That is the paper a council or a church architect works from. If lead is in poor order, the report says which flashing or valley and gives the position of the fault, so nobody has to climb up to be told it exists. Our listed and heritage roofing page sets out our survey of a protected roof, done before any price is given.

Before anyone lifts a tile

What does the council need to see for a listed Guarlford roof?

The list entry number, a description of the existing covering, and what is proposed in its place. Our report names the tile or slate, the pitch and the fixings, with photographs of the underside, so the council sees what we see before it decides.

Fig. 3 Wall abutments, drawn close

Callout 3 of 3

Gutters, licences and what comes with a quote

The last stop is the gutter. A run that has sagged holds water and spills it over the front lip onto the wall face. Brett Martin advises a fall of "1mm for every 600mm", so we check the brackets, the joints between lengths and the downpipe connections, and clear them by hand. A seller of uPVC fascia boards says they "can typically maintain reliable performance for between 20 and 40 years", a retailer's figure and not an independent one. Our guttering, soffits and fascias page covers renewal.

Before any plan alters the look of the roof from the lane, check Malvern Hills District Council's conservation area list and map to see whether your house is covered, and ask the council about any Article 4 direction; the council states that none is in force at present. A new roof window or dormer follows other rules again, set out in our roof window planning guide.

Whether a re-roof in England needs an application is a Planning Portal test with two limbs. The work must affect under 25 per cent of the building envelope and under 50 per cent of the roof, and then no application is normally needed. Beyond that, South Worcestershire Building Control, run in partnership by Malvern Hills District Council, Worcester City Council and Wychavon District Council, or a registered building control approver, takes the application. We tell you after the survey where your own job lands.

New insulation at rafter level is a Part L matter. Table 4.3 of AD L 2021 gives a threshold of 0.35 and an improved figure of 0.16, and AD L 2026 replaces it from 24 March 2027. A chimney breast that comes out always needs Building Regulations approval, and a shared one means notice under the Party Wall etc. Act 1996, at least two months before the cutting.

Section 169 of the Highways Act 1980 is the law behind any scaffold licence, and in this part of Worcestershire the licensing body is Worcestershire County Council. A scaffold that stays on your side of the boundary needs no licence. The scaffold is built into the one written total, so you are not handed a separate bill for it, and you see the whole price before anything starts.

What sets the price of a Guarlford roof job

Roof size and pitch
Area to be covered and how steep it is
Covering chosen
Clay, concrete, slate or reused tiles
Height and access
How the roof is reached and the scaffold it needs
Timber underneath
Battens or rafters found rotten once the covering is off

One written total price, never itemised.

Ridge, church and gutter questions in Guarlford

What holds the ridge tiles on a Guarlford roof, and when do they need re-fixing?

Capping tiles are bedded in mortar, clipped and screwed, or both. Any capping tile that shifts when pressed is loose on its mortar, and where the joints have opened, rain runs in under the top course. Marley's reading of the 2015 amendments is that a mortar bed alone no longer secures a covering, so we give each tile on a repaired ridge a mechanical fixing too. The whole line is tapped, and every loose tile is photographed for you.

Who signs off roof work on Guarlford's listed church?

St Mary's is Grade II under list entry 1098842. Because it is an Anglican church with services still running, roof work there needs a faculty, not the council's consent. If it ever closed, listed building consent from Malvern Hills District Council would apply instead. Ask the church's governing body before booking any work, and have the list entry number ready when you do.

Can a listed house in Guarlford be re-roofed in a different material?

Only if the council agrees, because a covering is part of a listed building's character. Guarlford Court, list entry 1157129, is an example of a listing where the question could arise. The report describes the existing tile or slate in detail, and we match size and colour. As SPAB advises, we also check with the quarries before suggesting any change of material.

Is there a conservation area around my Guarlford house?

Malvern Hills District Council keeps the conservation area list and map, so look your address up there and ask the council if a boundary is unclear. Do that before changing the roof's appearance from the lane. The council has stated that no Article 4(2) Directions are in force at present, which is a separate question from whether a conservation area covers your street.

What does a ridge repair cost near Guarlford?

Third-party guides give a range, and they differ. Which? (November 2025, excluding VAT) lists a new ridge tile at £80-£300. MyJobQuote gives £225 to £550 as the 2026 average for ridge tile replacement. Checkatrade (June 2026, excluding VAT) puts ridge repairs at £50-£70 per metre. Your own roof is priced from the survey, as a single written figure, and never from a guide. Reach, the covering chosen and how sound the timber is below move the number more than the length of the ridge does.

Does a heavier tile on a Guarlford roof need approval?

Yes, if the new covering is heavy enough. The Planning Portal says approval is needed if the swap raises the covering's weight by 15 per cent or more, while AD A's own wording is a load increase of more than 15%. That is a Building Regulations matter with a structural check, not a planning one. We tell you the old and new weights before the order is placed.

Start a Guarlford quote at the ridge

Say what has gone wrong, and we fix a survey date, then write down one price after we have been up.

10-year workmanship guarantee, in writing