01432 610152 Get a quote Call 01432 610152

Velux and conservation areas

Can I fit a Velux in an English conservation area?

Yes. What the designation takes is the dormer right; the roof window right stays, although an Article 4 direction can take more away.

In brief

Yes, unless an Article 4 direction says otherwise. A Velux is a roof window, which falls under Class C of the 2015 Order, and Class C stays intact on article 2(3) land. Class B, the dormer right, is the one that goes. A conservation area therefore does not by itself stop a roof window. An Article 4 direction can: a council makes it to withdraw specified rights across a defined area. Ask the council whether one covers your address.

What a conservation area takes away and what it leaves

Planning permission can be granted by an Order in advance, which is what permitted development means. Part 1 of Schedule 2 to the General Permitted Development Order 2015 sets out the classes for houses. Class C is "any other alteration to the roof of a dwellinghouse", and it is the class a Velux belongs to. Class B is the enlargement of a roof, which is where dormers sit.

Schedule 1 of the Order lists article 2(3) land: "an area designated as a conservation area", an area of outstanding natural beauty, a National Park and a World Heritage Site. On that land the Order removes Class B. Nothing in Class C mentions article 2(3) land, so a roof window keeps its right there.

A conservation area can be described as restricting roof alterations, and that can sound as if every alteration is caught. In England the restriction falls on the dormer, a box built out from the slope, and not on the window set into the slope. The difference is the whole answer to the question, and the roof window or dormer page works through it.

What an Article 4 direction can change

The GOV.UK planning guidance defines the tool: "An article 4 direction is a direction under article 4 of the General Permitted Development Order which enables the Secretary of State or the local planning authority to withdraw specified permitted development rights across a defined area."

The word "specified" matters, because a direction removes named rights over a defined area, perhaps a street or only part of one. A direction names the rights it removes, and the area it covers. One that removes Class C would bring a Velux back under the normal planning application. Another may remove rights over something else entirely. Nobody can say what a direction covers without reading it, so read the wording itself.

Herefordshire has 64 conservation areas, and the list includes the central area of Hereford. Check whether an Article 4 direction applies to your address with the council that owns the area. Where the council confirms there is none, Class C stands and the work can go ahead on the usual conditions. Keep the council's reply with your papers. If the council confirms a direction, the next step is a planning application, and we hold the quote until the council has replied.

The conditions the window still has to meet

Class C is a permission with limits, and they apply inside a conservation area just as outside one:

  • the window may not protrude more than 0.15 metres beyond the plane of the slope of the original roof
  • the top edge may not climb past the original roof's highest point
  • glazing in a slope on the side elevation has to be obscure, whatever its height
  • that side window must also be non-opening, except for any part that opens more than 1.7 metres up from the floor

The obscure-glazing rule is not relaxed by the 1.7 metre height; only the non-opening part of it is. On a conservation-area roof that neighbours and passers-by can see, it is worth holding a straight edge across the slope to check the 0.15 metre projection on site. Listing is a separate matter. A listed house keeps Class C, but any work affecting its special character needs listed building consent under section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990. The roof window planning guide gives the conditions in full.

Checking before you order a unit

A short sequence keeps a conservation-area job clean. Ask the council in writing whether an Article 4 direction covers the address and slope. Find out whether the house is listed. If it is a flat, remember that the 2015 Order gives householder rights to a dwellinghouse and a flat is excluded from that word, so a flat needs a planning application.

Some details help the council answer quickly: the full address, a photograph of the slope from the road, the size of the unit, and whether the house is listed or divided into flats. Send those with the question and keep the reply.

On our side, we survey the slope, photograph the rafters and the covering, and mark the position on the photographs so the council sees what is proposed. The window itself must reach 1.4 or WER Band B under Approved Document L. The listed house page deals with consent, and roof window or dormer sets the two classes side by side. After the survey you receive one written total. The wider range is under Velux and skylights.

Related questions

Can a council refuse a Velux in an English conservation area?

Only through an Article 4 direction that removes Class C, or where a listing needs consent. Without either, the Class C right stands on article 2(3) land, subject to its limits. Check with the council whether a direction covers your address before you order the unit.

Is a Velux on the front slope allowed in an English conservation area?

Class C has no front-slope bar, and a conservation area does not add one. The limits are the 0.15 metre projection and the height of the original roof. An Article 4 direction or a listing can still change the answer, so confirm both with the council before ordering.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing