01432 610152 Get a quote Call 01432 610152

Sagging roof line

Why is my roof line sagging?

A roof line that dips or bows is telling you about the timbers underneath. The tiles follow whatever the structure does, so the cause lies beneath them.

In brief

A sagging roof line means the structure under the covering has moved or weakened: rafters bowing, a purlin deflecting, supports removed, or timber softened by years of damp. It can also follow a heavier covering laid on a roof built for a lighter one. The tiles are passengers. A dip is a structural question, so we record it with photographs and measurements and say when a structural engineer should look before any re-covering is priced.

What a sag is, and what it is not

Stand across the road and look along the ridge. It should run straight, or follow a deliberate line. A sag shows as a dip in the ridge, a bow in a slope, or an eaves line that is no longer level. Old houses may not be perfectly true, and some waviness has been there for generations without causing harm. What matters is change: a dip that is new, or growing, or accompanied by cracks and slipped tiles.

A sag is not the same as a slipped tile. Tiles slip because their fixings fail, whatever the roof is doing. A sag means the frame has moved, and the courses of tiles are dragged out of true because the battens they hang on have moved with it.

It also helps to separate a sag from poor workmanship. A roof that was built with a slight wave still holds together, and the line sits at rest. A roof that is moving shows fresh cracks where tiles meet the ridge, gaps at verges, and daylight where there was none.

What lies behind a dip

Several causes produce the same visible dip, which is why the loft matters more than the view from the street.

  • Rafters that bow under load, or whose feet have slipped on the wall plate
  • A purlin, the horizontal timber that props rafters part-way up the slope, that has deflected or lost a support beneath it
  • Timber softened by rot after a long leak or persistent condensation
  • A heavier covering laid on a frame built for a lighter one, after a change of material
  • Alterations below the roof, since a chimney breast or wall that carried load may have been taken out

On chimney breasts, the Planning Portal says that Building Regulations approval "will always apply when removing chimney breasts as they are part of the building's structure". If someone has altered the house, a sag can follow years later.

Our guide on rafters, purlins and trusses shows what each timber does. A sag can have more than one cause, and the survey is there to find which of these applies to your roof, and whether more than one does.

What the survey records, and what it costs

We begin on the skyline, sighting along the ridge and the eaves from the ground, then go into the loft hatch with a torch, a tape and a camera. There we photograph the rafters, purlins and ties, any staining or soft timber, and the way each timber meets the wall. We measure the dip against a straight edge so the figure is on record, and we compare it on a later visit if you want to know whether it is growing.

If the evidence points to a structural fault, we tell you in plain words and suggest a structural engineer, because working out a load path is their job and not a roofer's guess. We do not cover a movement problem with new tiles.

On survey cost, MyJobQuote gives around £300 as the average for a roof survey: £100 to £200 for a basic visual inspection, £250 to £400 for a full survey and £200 to £350 by drone. Those are typical UK numbers, not ours. A repair that follows is priced as a single written sum, and the warning signs on a tiled roof guide lists what else to watch for.

Rules that apply to a roof that has moved

Fixing a sagging roof can mean structural work, and structural work has its own rules, which differ between England and Wales.

  • For England, the Planning Portal draws the line at a covering 15 per cent or more heavier, which needs approval, and Approved Document A counts any rise in roof load above 15% as significant.
  • For Wales, gov.wales lists structural alterations among the works that need Building Regulations approval, and re-roofing in most situations needs it anyway.

A terrace or semi can add another layer, because the roof timbers may bear on a wall shared with the neighbour. Party wall questions go to a party wall surveyor and not to building control, so we raise them early with you.

Until someone has looked, keep heavy stored items away from the part of the loft under the dip, and note any new cracks in the ceilings or walls below it, with dates. Photographs taken now give a baseline to compare against. Before any structural repair, we check with the council's building control service or a registered building control approver. See the pitched roofing page for the wider work.

Related questions

Is a sagging roof dangerous?

It can be, which is why a growing dip should be looked at promptly. A slight old wave that has not changed is different from a fresh sag with cracks, gaps or sagging ceilings below. If you see sudden movement, keep people out from under that part of the house and ask a structural engineer or building control for advice.

Will new tiles straighten a sagging roof?

No. New tiles follow the frame beneath them, so a dip stays unless the timbers are corrected. Fresh tiles can even add weight to a frame that is already struggling. That is why we survey the structure first and recommend a structural engineer when the loft shows more than a roofer should decide.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing