In brief
Tiles slip because their fixing has failed or the thing they hang from has moved. The common routes are corroded nails, a decayed batten, wind working at an exposed edge, damage from a ladder or boot, and a roof that has shifted underneath. One slipped tile can be put back with a new fixing. Several slipping across a slope point to a cause that will keep releasing tiles, so we find the cause before pricing the repair.
Failing nails and decaying battens
The first place to look is the fixing itself. A tile hangs from a batten, and it is held there by a nail, a clip or its own nib and weight. Over decades the nails corrode, which is the fault roofers call nail sickness. When the nail goes, the tile has nothing to stop it sliding down the slope.
The batten is the second candidate. These are the timber laths that run across the rafters, and they sit under the tiles in the dark, where a slow leak or condensation can keep them damp for years. Once a batten has gone soft it cannot grip a nail, so a tile can slip while its nail is still intact, pulled out of the wood instead of failing in itself.
The difference shows up when a slipped tile is lifted. A rusted nail stump points to the nail, while a nail that is clean and bright but loose in a dark, soft batten points to the timber. The survey photographs record which one you have, because the repair differs: new fixings in one case, new battens in the other.
Wind, edges and storm days
Wind need not start the slip, but it finishes it. A tile whose fixing is already weak is lifted by a gust, and once one is gone its neighbours lose their cover and go in turn. Ridge, hips and verges are the exposed lines, and a tile that is going to lift tends to do so there first, which is why the survey begins on the skyline. A tile mid-slope is sheltered by the courses either side.
Wind damage can also be an insurance question. The Financial Ombudsman Service states that "Rain, hail or snowfall by itself can constitute a storm", and that its usual evidence is an expert's report plus photos. A dated photograph of the gap and of any fallen tile helps. Sensible steps: contact your insurer before anything permanent is done, make the area safe, and keep the receipts for that work.
The claim and its outcome rest with your insurer. What we can give you is the set of photographs from the survey and a plain written account of what was found.
Boots, ladders, washing and movement
Some slips are caused by what has happened to the roof, not by age.
- Walking on tiles breaks or shifts them, and a tile that has been trodden on may slip months later. See whether it is safe to walk on roof tiles.
- A ladder leaned on the gutter or on the edge tiles can nudge a tile off its course, and a cleaner's pole or a television aerial fixing can do the same.
- Marley says a powerful jet wash is not recommended on slate or tile, because the damage it can do to the face of the covering cuts its expected life, so cleaning is done another way.
- A roof that has moved, with rafters that have sunk or a wall that has shifted, pulls courses out of line. That is a different job, set out in why a roof line sags.
None of these shows in a catalogue photograph of a tile, but each leaves a mark: a crack at the tail, a scuffed surface, or a course that runs out of true across the slope. We photograph the marks so the cause is on record beside the repair.
Putting them back: repair, re-cover and the rules
A single tile that is whole goes back with a new fixing, and a cracked one is replaced with a match. Which? puts a repair of between one and six tiles at £75 to £400, excluding VAT, as a typical UK range from its November 2025 survey of Trusted Traders. Our own figure is a written total after the survey.
Where tiles are slipping across a slope, a full re-cover may be the answer, and the English and Welsh rulebooks part company here.
- For England, the Planning Portal's test for re-roofing sets the bar at under 25 per cent of the building envelope together with under 50 per cent of the roof, and a covering that is 15 per cent or more heavier also needs approval.
- For Wales, gov.wales takes a firmer line: it expects Building Regulations approval in most situations, so we first put the question to the council's building control service or a registered building control approver.
The pitched roofing page lays out the whole range of work.
