Published figures
Which? gives a new ridge tile at £80 to £300, excluding VAT. MyJobQuote gives an average of £225 to £550 for ridge tile replacement. Checkatrade gives ridge tile repairs at £50 to £70 per metre, excluding VAT. They measure different things, so they cannot be set against each other. What changes the price on your roof is the length of the ridge, the access, whether the old tiles are sound and how the new ones are fixed. We quote one written total after a survey.
What rebedding a ridge actually involves
Capping tiles run in a row across the top of a pitched roof, along the crest where both slopes end, and together they are called the ridge. Traditionally each tile rests in a mortar bed, and that bed cracks over the years as the roof moves, weathers and gets soaked and dried. Once the bed has gone, the tiles rock, and a gust can lift one clean away.
Rebedding means lifting the ridge tiles, clearing out the old mortar and setting the tiles again, with the ends closed off where the ridge meets a verge or a chimney. It is a job done on the skyline, which is where we start every survey.
Fixing methods have moved on since mortar was the whole story. Marley says the 2015 amendments to BS 5534 made it clear that mortar "could no longer be relied upon as the only means of securing the roof covering". Mortar is not banned. But a rebed today normally adds a mechanical fixing, and a dry-fix ridge system under BS 8612 is a different route altogether, set out in our answer on whether a dry ridge uses mortar.
Three published figures, three units
These are typical UK ranges from named guides, never our own prices, and none was worked out for Herefordshire.
Which? collected figures from its Trusted Traders survey in November 2025, with labour and materials counted but VAT left out. Its number for a new ridge tile along the roof's apex is £80 to £300, which is a figure for a single tile.
MyJobQuote, on a page dated 1 October 2026, gives an average of £225 to £550 for ridge tile replacement. That is a job-level range, and the page states no VAT basis.
Checkatrade's June 2026 repair guide gives ridge tile repairs at £50 to £70 per metre, excluding VAT, which makes it a rate for each metre of ridge and not a total, and it is not multiplied up into a total for any roof here.
Why they do not add up
One number cannot answer a question about three bases. A long detached ridge and a short terrace ridge will fall at opposite ends of any of them.
Points on a real ridge that change the figure
The survey photographs settle most of what follows. Each point changes the work, and so the price you are given.
- Length of the ridge, and whether hips run down to the eaves, each with its own run of capping
- Height and access, since a tall gable end or a roof beside a boundary may need a tower or scaffold
- Whether the old ridge tiles are sound enough to reuse, or cracked and in need of matching ones
- Fixing method: mortar plus a mechanical fixing, or a dry-fix system with its own fittings
- The condition of the verge and chimney ends, which are tied into the same piece of work
Scaffold sits inside the written total we give, so ask of any other quote you hold whether it counts VAT and scaffold. A ridge price that leaves them out is not the sum you will pay.
Where the work stretches into the edges of the roof, ridge and verge repairs explains the wider job, and a ridge that has shifted with the timbers beneath it is a survey question, not a bedding one.
Is a rebed a re-roof? The rules on each side
A rebed touches a narrow strip of the covering, not the whole roof, and that matters when the re-roofing rules are read.
For England, the Planning Portal puts a re-roof through two tests: less than 25 per cent of the total building envelope, and less than 50 per cent of the roof. If both are met, no application is normally needed, and a ridge is a thin line against either measure.
In Wales the Welsh Government's guidance begins by stating that re-roofing will need Building Regulations approval in most situations. That page concerns replacing a roof covering, so before we start we ask the council's building control service or a registered building control approver whether a ridge-only job is caught.
A listed house changes the picture. For an English house the Planning (Listed Buildings and Conservation Areas) Act 1990 section 7 covers works that affect its character, while for a Welsh one the Historic Environment (Wales) Act 2023 sections 88 and 89 do the same, so consent is checked before any ridge is lifted. The pitched roofing hub has the wider picture.
