01432 610152 Get a quote Call 01432 610152

Roofers in Tenbury Wells

Tiled and slated roofs, listed fronts and a Grade II* church in Tenbury Wells.

A survey here goes slope by slope, with photographs of every fault, and closes with one total price on paper.

Get a free quoteCall 01432 610152

Three Tenbury roofs, three different questions

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Tiled and slated roofsWhether a slope is tile or slate decides its pitch limits and its fixings.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Half-timber housesA timber frame moves, so the verge and flashings beside it need watching.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Listed fronts and railingsA listed frontage needs consent settled before any roof work starts.

Tenbury Wells and nearby villages

Tenbury Wells on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Tenbury Wells roofs, slope to church

Tile, timber and a listed church: reading a Tenbury Wells roof

The survey runs from the pitched slopes of tile and slate, through the half-timber houses the 1924 county history records, to the listed church and the conservation area that govern how any repair is made.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Slopes; 2 Half-timber; 3 Church wall.

Fig. 1 Three numbered details drawn on a roof: slope, frame and wall.

Callout 1 of 3

Tiled and slated slopes in Tenbury Wells

Our survey of a Tenbury Wells roof starts on the open slope. The Victoria County History of 1924 describes the town's houses as built of brick, a few of them half-timber, with "tiled or slated roofs". Tile and slate are laid and fixed in different ways, so the first job is to identify which one you have. Tiles hang from timber battens by a nib on each tile, and some are also nailed or clipped. We note the batten size and spacing as well, because they set how the covering is fixed. A slate is a thin sheet of stone that overlaps the course below it, and it is held by nails or by hooks.

The conditions for slate are exact. Cupa, a slate supplier, reports that BS 5534:2014+A2:2018 puts the floor for natural slate at a 20 degree pitch, given moderate exposure, a 500 mm slate and a 115 mm overlap. Cupa also says to keep hook fixings off any slope below 25 degrees. A shallow slope on an extension may therefore need a different answer from the main roof, and we measure the pitch during the survey and do not judge it by eye.

On a slope we look for slipped or cracked units, for slates that have lost their nails and are held only by their neighbours, and for moss that is holding water against the covering. HomeBuilding gives Welsh slate "100+ years" and Spanish slate "75-100 years", and SPAB says the life of a well-slated roof is "likely to be more than 100 years". For concrete tile, Marley says around 60 years and HomeBuilding says 40 to 50 years. These are typical ranges from third parties and not promises, and the real life of your roof depends on how it was laid and looked after.

Replacing a lone slipped slate counts as a repair. When nails have given up all over a slope, the decision is larger, and we say which of the two the photographs show. Re-slating or re-tiling a full slope raises the Building Regulations question too. The Planning Portal's tests for England are less than 25 per cent of the building envelope together with less than 50 per cent of the roof. Keep inside both and an application is normally not needed. Moss comes off by hand here; Marley's guidance puts high-powered jet washes in its not-recommended column. A heavier covering is a separate matter, which is why we note the existing one at the start. Our slate roofing page covers repair and re-slating, and roof replacement covers full re-roofs.

What the slope survey records

Covering
Tile or slate, and how each unit is fixed
Pitch
Measured, because slate has pitch and fixing limits
Fixings
Nails, clips or hooks, and whether any are missing
Surface
Moss, cracks and slipped units, each photographed

Loose slates one at a time make a repair; failing nails across a slope make a decision.

Fig. 2 The slopes, drawn close

Callout 2 of 3

Half-timber walls and the roofs they carry

The second callout is the gable of a half-timbered house. The 1924 account counts only some few houses in the town as half-timber, which makes each one a roof with its own history. At a gable, three parts have to work together: the frame, the verge (the strip where the covering overhangs the end wall) and the bedding that seals the two. When the frame shifts, the bedding can crack. We look for open joints, for crumbled bedding and for dark marks on the wood beneath the verge. Each one is photographed close up, so the report shows the gap and not only our description of it.

Inside the roof space we turn to the Tenbury wall plate, the timber laid on top of each wall that carries the rafter feet. Soft or darkened wood there means moisture has been arriving for some time, and it may not yet show on a bedroom ceiling. Ventilation matters around old timber. Marley's cold-roof guidance for HR underlay (not vapour-permeable) asks for 25 mm of eaves ventilation at pitches up to 15 degrees and 10 mm above that, and an air-permeable underlay may depend on 3 mm of fortuitous ventilation if its certification terms are satisfied. We identify the underlay before a covering goes back.

Tenbury Wells has listed houses of its own. The Oak House is Grade II (list entry 1301807, first listed 16 December 1971), and 24-30 Berrington Road is Grade II as well (list entry 1082459). Section 7 of the 1990 Act on listed buildings and conservation areas means that work affecting a listed house's special character needs listed building consent from Malvern Hills District Council. Listing does not remove a dwelling's permitted development rights, yet consent is also required, which is why we agree the covering, fixings and technique with the council before work begins.

The repair follows the timber. We open a failed joint and re-bed it in the material the house already uses, and a lead flashing is cut and dressed to allow for movement. Sealant over a gap covers the symptom and leaves the cause where it was. Our listed and heritage roofing page covers protected houses, from first photograph to final dressing.

Looked at on a timber-framed gable

  • Gaps between the frame and the covering
  • Verge bedding that has dropped out
  • Staining on the timbers below the verge
  • The wall plate, seen from the loft
  • Rafter feet, for softness or damp

Soft wood at the wall plate means moisture has been arriving for a while.

Fig. 3 Timber frames, drawn close

Callout 3 of 3

St Mary's, the railings and the conservation area

At callout three the roof gives way to a wall. St Mary's church holds a Grade II* listing (list entry 1082426, first listed 18 April 1966). Anglican worship puts it inside the faculty system, which stands in for council consent while the building is in use. Nos 5 and 6 and Adjoining Railings to Front also holds Grade II* (list entry 1180022, first listed 6 October 1952). It is not an exempt church, so for that one the council's consent is what applies.

Malvern Hills District Council's conservation area list includes Tenbury Wells. Check the boundary against your own street before you plan anything that alters the street view of a roof, because inside a conservation area a roofline is judged differently for planning purposes. According to the council, no Article 4(2) Directions are currently in force across its district, so nothing of that kind adds a restriction here. Roof windows and dormers get their own explanation in our roof window planning guide.

Tenbury Wells is covered by South Worcestershire Building Control, which Malvern Hills District Council operates together with Worcester City Council and Wychavon District Council. You may appoint a registered building control approver instead. Section 169 of the Highways Act 1980 requires a licence whenever poles or boards sit over a public way, and Worcestershire County Council issues those. Scaffold hire is inside the one total we quote.

Chimneys on older town houses bring two more rules. On chimney breasts, the Planning Portal is clear that approval under building regulations always applies to their removal. Where the breast belongs to both houses, the Party Wall etc. Act 1996 applies, and it is the owner commissioning the work who opens the process by serving notice on the neighbour. A wall is also where a roof meets masonry, and that is where lead flashing does its work. MyJobQuote says correctly installed lead flashing "can last for over 80 years", which makes a sound flashing worth keeping and a lifted one worth dressing back before a new covering is even discussed.

Where the roof meets a masonry wall

SoundFlashing tucked into the joint, pointing sound and tight
Needs workPointing open, flashing lifted, damp marks on the wall below

Tenbury Wells roofs: slate, timber and listings

Which fixings suit a slate roof in Tenbury Wells?

That depends on the pitch of each slope. Cupa advises keeping hook fixings off any pitch below 25 degrees, and its 20 degree minimum for natural slate is given for moderate exposure with a 500 mm slate and a 115 mm overlap. We measure the pitch during the survey, choose nails or hooks to suit, and the written report explains the choice and shows each fixing we found on your roof.

Is a different roof covering allowed on a half-timbered Tenbury Wells house?

A change of covering is something to agree before anything is priced. A frame carries load differently under a lighter or heavier covering, and in England a covering that is 15 per cent or more heavier needs Building Regulations approval and a structural check. If the house is listed, Malvern Hills District Council must also agree the material through listed building consent before work starts.

Does a roof repair on the Oak House or Berrington Road need listed building consent?

Both are Grade II, under list entries 1301807 and 1082459. Repairs that would affect a listed building's character need consent from Malvern Hills District Council, and even a repair in matching materials is best raised with the council ahead of booking a contractor. Please give the entry number and describe the tiles or slates, how they are held on and how much of the roof is involved, so the council can reply quickly.

Whose consent is needed for roof work on St Mary's, Tenbury Wells?

St Mary's appears on the national list as Grade II*, under entry 1082426, and is an Anglican church. While services go on there, works follow the faculty system, and council listed building consent is not the route. A chapel nearby that has shut, and any Unitarian or Quaker meeting house, needs the council's consent, so ask the building's own governing body first.

What happens about scaffolding licences on a Tenbury Wells job?

A licence applies only when scaffolding occupies the highway, under section 169 of the Highways Act 1980. Worcestershire County Council's wording is that the engaged contractor is "required to apply", and the charge is £85 per week and £65 for subsequent weeks. Everything to do with the scaffold sits in the one total we quote. Worcestershire looks at applications on weekdays only, so we settle the date when we survey.

Will the Tenbury Wells conservation area affect a new roof window?

Not on its own under English rules: it is a dormer that the conservation area weighs on, and a Tenbury roof window has conditions of its own. Malvern Hills District Council's list includes Tenbury Wells as a conservation area, and the council reports no Article 4(2) Directions in force across its district. Our planning guide sets out those conditions; read it ahead of ordering a window, a frame or any item with a lead time.

Book a slope-by-slope Tenbury Wells survey

Say which roof worries you and what shows from the pavement, and we will arrange the visit.

10-year workmanship guarantee, in writing