Callout 1 of 3
Eaves and gutters on Little Hereford's older roofs
The eaves form the lowest edge of a roof: the covering projects past the wall there, and the gutter is fixed beneath it. Under the heading "Hereford, Little", the Royal Commission on Historical Monuments listed monuments 5 to 14 in its 1934 volume. Unless an entry said otherwise, it found them built in the 1600s, of two storeys, with timber frames under tile or slate. That is the commissioners' record, not a description of your house. What matters for the survey is what your own eaves show today.
A gutter has one job, and it needs a fall to do it. Brett Martin, who make gutter systems, put the fall at "1mm for every 600mm". We sight along each run for sagging brackets, open joints and standing water, and we count the brackets against the length of the run. A leaking joint wets the wall head and the rafter feet (the lower ends of the rafters), and in a timber-framed house that wet can travel on to the wall plate beneath. A roofer who looks only at the covering misses the cause.
Behind the gutter sit the fascia, which carries it, and the soffit, the board that shuts off the overhang from below. We probe timber boards with a blade for softness, starting at the top edge where a leak has run, and we look for daylight where a board has parted from the wall. Plastic boards are checked for warp and for joints that have opened. If a board is sound, it stays; if it has gone, the report says so and shows the photograph.
Where each downpipe ends we check where the water goes. A gully that is blocked, or a pipe that empties against a wall, undoes good work higher up, and the photographs follow the water from the roof edge to the ground so you can see the whole path. Where the roof drains onto a stone plinth or a footing, that spot is the first to be inspected after a wet spell.
Where the eaves are out of reach of a ladder, the written quote already contains the access. Our guttering, soffits and fascias hub describes the systems we fit and how each run is set out.
One question about the gutter line
Can a leaking gutter be repaired, or must the whole run go?
A loose bracket or a single open joint can be mended. A run that sags along its length, or has split from end to end, is the better buy replaced than patched again, and the report tells you which case you have.
The gutter beneath the last course of tiles keeps the roof edge dry.















