Callout 1 of 3
Flat roofs: fall, membrane and ageing
A flat roof is flat in name only. It needs a fall, a slight slope, so that water leaves instead of standing, and a Burford survey starts there. BS 6229:2025 is the current standard for flat roofs whose waterproofing is a flexible membrane laid on continuous support, and the 2018 edition has been withdrawn. NFRC reports that it sets "a minimum 1:80 finished fall for general roof areas and internal gutters", while IKO, a membrane maker, advises that to reach 1:80 the roof "should be designed for a fall of 1:40". The standard concerns membranes; lead is dealt with under other documents.
Ponding, water left standing after rain, shows where a fall has failed. We press the surface for blisters and soft decking, check the seams and the upstands (the upturned edge at a flat roof's junction with a wall) and look closely at every outlet. Gutters and outlets at the edge are cleared and checked as well, since a blocked outlet makes ponding worse. Coverings age at different rates, and the published sources disagree, so both figures are given. HomeBuilding puts EPDM at "25-30 years" and Less puts it at "30 to 50 years". GRP is "25-30 years" with HomeBuilding and "25 to 40 years" with Less, and torch-on felt is "10-15 years" with HomeBuilding and "10 to 20 years" with Less. Read them as ranges, not forecasts for your roof.
England treats a new waterproof layer as renovation. AD L 2021 lists "Replacing the waterproof membrane on a flat roof" under renovation, so Table 4.3 applies, with a threshold of 0.35 and an improved figure of 0.16. Paragraph 4.13 lets the figure fall short where 0.16 is not feasible or the payback would run past 15 years. AD L 2026 Table 3.3 takes over from 24 March 2027. A conservatory roof is a separate case, and the Planning Portal says that a new one "must comply with building regulations", so building control is asked first. A new covering over timber decking also means a look at the deck itself, because boards that have gone soft will not hold a new membrane. Our flat roofing page sets out the coverings we lay and why a repair is sometimes the better buy. If seams have opened in one corner and the rest holds, a localised repair makes better sense, and the report says where the line falls; a full re-cover is offered when the membrane has failed across the roof.
A flat roof surface
Water that stands on a flat roof tells you where the fall has gone.















