01432 610152 Get a quote Call 01432 610152

Roofers in Staunton, near Newent

Roof repairs and new roofs for Staunton, 23.5 road miles east of Hereford.

We open with the ridge and the gable ends, photograph whatever is wrong, and give you one written total to decide on.

Get a free quoteCall 01432 610152

A conservation area, gables and a loft question

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Gabled houses and cottagesEach gable puts a verge beside the ridge, and both are read early.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    The Staunton/Corse Conservation AreaVisible roof changes call for a word with the council first.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Loft rooms under old raftersConverting a loft raises escape, insulation and roof window questions together.

Staunton and its neighbours

Staunton, near Newent on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Staunton roofs, ridge to loft room

A Staunton roof surveyed from the ridge to the loft room and the shared wall

The ridge and gable ends come first, then the loft room and its windows in the rafters, then the listed houses and the walls they share with neighbours.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Ridge line; 2 Loft room; 3 Shared wall.

Fig. 1 Gabled house in section, with the ridge, the roof window and the shared wall numbered.

Callout 1 of 3

A gabled Staunton roof begins at the ridge

Staunton's listed houses, Jeanicia and Belle Vue among them, stand beside newer homes, and no two roofs here are read the same way. A gable gives a roof two triangular ends, and each end hands us two lines to read: the ridge across the top and the verge running down the slope. The ridge comes first because it holds the top course together, and a failure up there lets weather reach every course beneath it.

Ridge capping is the row of shaped tiles along the apex, set in mortar, fixed dry with clips and screws, or both. Marley states that "Installing to BS 5534 isn't required by law", and that since the 2015 amendments mortar "could no longer be relied upon as the only means of securing the roof covering". BS 8612 covers dry-fix systems. On an older house we choose methods that suit the old masonry, and sound bedding is left alone. Each capping tile is tried by hand: one that moves has lost its bed or its clip, and the report names it.

A gable end needs a second look. Wind lifts the edge before it troubles the middle of the slope, and underlay at the edge can curl out where it has been exposed, so we test the last two tiles beside each gable and check whether rain has run down the wall face below. The wall tells a story the roof cannot: dark streaks under a verge show where water has been leaving the slope for some time, and they are photographed beside the tile that caused them.

A tired ridge is not always a tired roof. Marley puts the expected life of its concrete roof tiles at around 60 years, while HomeBuilding gives 40 to 50 years for plain concrete tiles. The BRE determined a minimum life expectancy of 60 years for clay tiles only. Lifespans are ranges that frame the choice between a rebedded ridge and something larger, never a promise about your own roof. Our pitched roofing page describes the wider work.

Ridge points tested in turn at Staunton

  • Capping tiles that move under the hand
  • Bedding mortar that has cracked or gone
  • Clips or screws missing from dry-fix runs
  • The last tiles beside each gable
  • The wall face below the verge

Dark streaks beneath a verge show where the slope has been shedding water for some time.

Fig. 2 The ridge, drawn close

Callout 2 of 3

Loft rooms, roof windows and the Staunton/Corse Conservation Area

The Staunton/Corse Conservation Area appears on Forest of Dean District Council's list and takes in ground near the middle of Staunton. The council's own guidance for conservation areas says "Special attention should be given to the design, scale and use of materials", so that the existing character is not damaged. On the English side, ask the council about any dormer there. The guide to roof windows and planning permission that we publish works through each kind of opening. Article 4 is a second matter to raise with the council, since an Article 4 direction can withdraw some of the rights a householder normally has.

Converting a loft adds fire rules. The edition in force for England is AD B 2019, incorporating the 2020, 2022, 2025 and 2026 amendments. Where a conversion puts a storey more than 4.5 m above the ground, paragraph 2.5 permits a protected stairway, or else the alternative of fire-resisting construction around the top storey which then needs a separate escape route running to a final exit. Paragraph 2.23 also lets a sprinkler system serve as the option in open-plan layouts. Which one suits depends on the layout, so the plan is settled before the price is.

Escape windows are covered by paragraph 2.10, and it deals with storeys not more than 4.5 m up. The loft itself has to meet the energy rules, and the structure beneath it has to carry a floor. A ceiling joist is not automatically a floor joist, so the survey photographs the existing timbers, and the report lists what a designer would need to check before drawings are commissioned. Insulation between and over the rafters changes how the roof dries out, so the gap at the eaves is checked as well: Marley gives 25mm for pitches of 15° or less and 10mm above that where a cold roof has HR underlay, a type that is not vapour-permeable.

Building control for a Staunton address sits with Forest of Dean District Council Building Control, and a registered building control approver is the other option. Roof windows set into an existing slope are described on our skylights page. A new opening means cutting a rafter, trimming the gap with new timbers, and weaving the flashing into the tiles around it, so the loft side of the job is photographed as carefully as the roof side.

A loft question

How big must an escape window be in a room within 4.5 m of the ground?

AD B paragraph 2.10 wants an unobstructed openable area of at least 0.33m2, with 450mm as the minimum height and width, and the lowest edge of the opening no higher than 1100mm above the floor.

Fig. 3 Roof windows, drawn close

Callout 3 of 3

Jeanicia, Belle Vue and a neighbour's wall

Grade II entries in the Historic England list for Staunton include these. 5, Ledbury Road Crescent is Grade II (list entry 1302674, first listed 6 December 1976), and so is Jeanicia (list entry 1078508, first listed 6 December 1976). Belle Vue is Grade II too (list entry 1341984). A listing does not freeze a roof. It means the work has to be authorised first, under section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990, and for a house that authorisation is listed building consent, which Forest of Dean District Council grants. Permitted development rights stay, with consent added, and the application rests on photographs showing the roof in its present state.

Some roofs abut a wall that next door owns. Where our flashing has to be chased into next door's brickwork, section 2(2)(j) of the Party Wall etc. Act 1996 supplies the right, once you as building owner have served notice, and under section 3 the neighbour must receive that notice with at least two months to spare before cutting begins. The neighbour may agree in writing under section 3(3)(a). Silence is not agreement: if 14 days pass without a reply, the neighbour counts as dissenting and surveyors are appointed. Disputes are for party wall surveyors, and building control does not handle them.

That is why we look closely at the abutment before pricing, from the roof and from the neighbour's side where access is agreed. Where a roof meets a neighbour's wall, the flashing is lead dressed over the tiles and tucked into the joint. We photograph the joint and the stained wall face beside it, so any notice can describe real work and not guesswork. If the wall belongs wholly to you, none of this applies, and the flashing is chased into your own masonry without any notice at all.

Poles that stand on the highway require a section 169 licence, under the Highways Act 1980. In Staunton the licensing body is Gloucestershire County Council, and we arrange the licence with our scaffolder. Our listed and heritage roofing page explains what a protected house requires before work starts, and how the consent and the photographs fit together.

The flashing where a roof meets a wall

SoundLead tucked into a sound joint, wall face dry
Needs workOpen joint, stained wall face, flashing standing proud

Staunton roofs: conservation area, lofts and shared walls

What does the Staunton/Corse Conservation Area mean for roof work?

Forest of Dean District Council's guidance asks for special attention to design, scale and materials inside a conservation area. A repair that matches what is already there raises fewer questions than a roof window or a different covering, which our planning guide covers. Forest of Dean District Council keeps the conservation area list, and a question to it will settle whether an Article 4 direction reaches your address. Ask both in writing before accepting a quote, and keep the replies with the survey photographs for later.

Can a Staunton loft become a bedroom without a protected stairway?

Possibly. AD B paragraph 2.5, for a conversion that creates a storey more than 4.5 m above the ground, accepts a protected stairway, with the alternative escape route taking the form of a separated top storey that reaches a final exit by its own route. Under paragraph 2.23, sprinklers are a further option for open-plan layouts. Forest of Dean District Council Building Control, or a registered building control approver, confirms the route.

What do I owe a neighbour before work on a wall we share?

You serve the notice yourself, as building owner, giving at least two months before anyone cuts into a party wall to insert a flashing. A neighbour can consent in writing. If 14 days pass without a reply, they are treated as dissenting, and surveyors are appointed. Disputes belong to party wall surveyors, not to building control, and the notice itself is a letter you sign.

How many years can a tile roof give in Staunton?

The sources differ, so we name both. Marley puts its concrete roof tiles at around 60 years, while HomeBuilding gives 40 to 50 years for plain concrete tiles. The BRE determined a minimum life expectancy of 60 years for clay tiles, a figure belonging to clay alone. All are typical ranges and not promises, so the survey reads the actual battens, nails and tiles on your roof.

What do published guides say a new ridge costs?

MyJobQuote gives £225 to £550 as the 2026 average for ridge tile replacement, and Which? reported from its November 2025 survey, before VAT, £80 to £300 for a new ridge tile. They measure different jobs, so the figures cannot be compared. Neither is our price. On a Staunton roof the written total depends on length, access and whether the dry-fix system or the mortar bed is being renewed.

How does scaffold on the road work for a Staunton roof job?

Gloucestershire County Council's scaffolding and hoarding licence (prices from 1 April 2025) costs £145 for a minimum of 28 days, with extensions at £36 per 7 days, and needs at least 12 calendar days' notice. Dates are fixed once you accept the quote, and we arrange the licence with our scaffolder. National Highways looks after motorways and trunk roads. The survey tells you whether your roof needs a licence at all, and any scaffold sits inside the written total.

Arrange a ridge and loft survey in Staunton

Describe the problem, attach a picture of the gable or the loft, and we will book the visit.

10-year workmanship guarantee, in writing