01432 610152 Get a quote Call 01432 610152

Roofers in Severn Stoke

Roof repairs and re-roofs in Severn Stoke, a village whose church was retiled after a flood.

Our survey reads every slope and gutter from the lane, photographs what is wrong, and ends in one total on paper.

Get a free quoteCall 01432 610152

Severn Stoke roofs, from slope to downpipe

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Tiles, battens and underlayA re-tile rests on the timber and membrane beneath it.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Gutters, downpipes and gulliesWater that cannot leave the roofline soaks the wall below the eaves.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Grade II* church, pub and housesListed status for church, pub and houses means consent questions come first.

Roads into Severn Stoke

Severn Stoke on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Severn Stoke roofs, slope to listed wall

A re-tiled church, gutters and listed walls: a Severn Stoke survey

The survey follows a record of retiling in the parish: first the slopes and what lies under the tiles, then the gutters that carry water away, then the listed church, pub and houses.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Slopes; 2 Gutters; 3 Listed walls.

Fig. 1 Slope, gutter and listed wall, marked on a Severn Stoke section.

Callout 1 of 3

Slopes, tiles and what sits beneath them

Severn Stoke has a roofing story on paper. The Victoria County History of 1924 records that after a flood in 1886, when the water rose to nearly 3 ft above the floor of the church of St Denys, the building was restored in 1890, and that the work included "the roofs retiled". It adds that the church's roofs, apart from the aisle with its flat-pitched leaded lean-to, "are covered with red tiles overhanging at the eaves". The record also points to something general: a roof re-covered in tile depends on the timber and membrane under it for its soundness, and those are what a survey reads next.

Under the tiles lie the battens, the narrow timber strips each course hangs from, and under those the underlay, a membrane laid over the rafters. Underlay comes in two families. The first, HR (high resistance), cannot pass water vapour and needs ventilation at the eaves, as Marley's cold roof guidance explains. The second, air-permeable underlay, may depend on ordinary eaves construction for its ventilation, but only where Marley's stated conditions are met. Which kind sits on a Severn Stoke roof decides what the loft needs, which is why the loft gets a visit alongside the ladder.

Pitch matters too. In Marley's pitch table the plain concrete tile needs 35 degrees at the least, while the Mendip is listed at 15 degrees (smooth), and its data sheet settles the question. A replacement tile is chosen against the pitch of the slope it is going on, never against a catalogue picture. Slate carries its own limits. Cupa says BS 5534 indicates 20 degrees as the minimum for a 500 mm slate with a 115 mm overlap in moderate exposure, and slate hooks are ruled out below 25 degrees.

We then decide whether the slope wants repair or re-covering. A few cracked tiles on sound battens need only replacing. Battens that split at the nail holes, and underlay that has gone brittle, call for a strip. Our roof replacement hub covers the larger job, and the photographs we take of the battens show whether it is needed. We also note the lap of each course and whether any tile is a different make from its neighbours, since a patchwork of past repairs tells its own history.

Terms for a Severn Stoke re-tile

Batten
A narrow timber strip that each course of tiles hangs from
Underlay
The membrane laid over the rafters beneath the battens
HR underlay
High resistance underlay, which cannot pass water vapour
Pitch
The angle of a slope, which sets which tiles may be used
Course
One horizontal row of tiles running along the slope

A re-tile is judged by what is under the tiles as much as by the tiles.

Fig. 2 The slopes, drawn close

Callout 2 of 3

Gutters, downpipes and the gully at the foot

The second callout follows the water off the roof. A gutter collects what the slope sheds, a downpipe carries it down the wall, and a gully at the foot passes it to the drain. A fault anywhere along that chain sends water to the wrong place, and the wall below the eaves is where it tends to land. A village that kept a record of its church standing in a flood is a fair reminder that moving water away from a building is the point of the whole system.

On a gutter we look first at the fall. Brett Martin, the guttering maker, recommends 1mm for every 600mm of run, so a section that holds standing water has sagged out of true. Loose brackets are one cause, because brackets that have pulled from the fascia let the run drop. Joints that weep leave green or dark staining on the wall, and a gutter full of leaves and moss spills over its front lip in a downpour rather than draining to the pipe. Where an overflowing gutter has soaked a wall for some time, we note the stain and the height of the damp, and photograph the wall as well as the gutter so that cause and effect are both on record.

The downpipe is checked from top to bottom for cracks, loose clips and a blocked bend. At the foot, a gully choked with silt backs water up against the base of the wall, where damp can climb into brick or stone. We lift the grating and look. Cast iron is checked for cracks and rust, while plastic is checked for brittle joints and sag, because each material fails in its own way. Seamless gutters, formed on site from a single length, remove the joints that weep, though the fall and the brackets matter just as much.

The fascia behind the gutter is probed for rot at its ends, and the soffit above is inspected for asbestos before anyone touches it, because a building built or refurbished before 2000 should be treated as containing some until a survey says otherwise. Our guttering, soffits and fascias hub covers full replacement runs.

A Severn Stoke rainwater run

Gutter
Falls to the outlet with no standing water
Brackets
Fixed firmly to sound fascia timber
Downpipe
Clear from top to bend to foot
Gully
Grating lifted and silt cleared
Fascia
Probed at the ends and corners for rot
Fig. 3 Gutters and downpipes, drawn close

Callout 3 of 3

St Denys, the Rose and Crown, and Church House

The wall is callout three, and Severn Stoke's listings give it plenty to show. The Church of St Denys is Grade II* (list entry 1178488, first listed 25 March 1968). Church House (list entry 1099064) and Broadacre, Severn Hill and Bankside (list entry 1349120) are Grade II and were first listed on 14 June 1985, and The Rose and Crown Public House is Grade II as well (list entry 1178493). The same 1924 account lists the work done in 1890: plaster scraped from the walls, stucco taken from the tower and the floor relaid in concrete. At the 2021 Census the ONS counted 583 usual residents in the parish. The village is 29.6 road miles away, east of Hereford's centre, a drive of about 49 minutes.

Listed building consent, under section 7 of the 1990 Act, is needed before works that alter a listed building's character. A listed building keeps permitted development rights, with the consent as an additional step. St Denys holds Church of England worship, and as long as that carries on, repairs to the church roof are a faculty matter for the diocese rather than a listed building consent case. The Rose and Crown is listed as a public house, and our commercial roofing hub covers work on business premises.

Which conservation area, if any, covers your address is for Malvern Hills District Council to say, because it keeps the list. At present, the council says, no Article 4(2) Directions are in force. Our planning guide for roof windows covers new openings and dormers in England.

South Worcestershire Building Control, a service that Malvern Hills District Council, Worcester City Council and Wychavon District Council share, handles building control here; a registered approver is the other route. Section 169 of the Highways Act 1980 puts a licence between scaffolding and the highway, and the licence itself comes from Worcestershire County Council. Photographs from a first visit to a listed building cover each slope, the lead, the ridge and the fixings, and they go to the council with any consent application.

A listed roof at Severn Stoke

SoundCovering matched, lead dressed, consent agreed before work
Needs workMismatched tiles, patched lead, consent not yet asked

Severn Stoke roofs: re-tiles, gutters and listed walls

Is a re-tile or a repair the better choice for a Severn Stoke roof with failing battens?

Battens that split at the nail holes, or underlay that has gone brittle, call for a strip and a re-tile, since a repair would only cover the problem. A handful of cracked tiles over sound battens is a repair. The survey photographs the battens from the loft and from the eaves, and the written price follows whichever the photographs show, so you see the evidence before you decide. Either way the price is a single written total.

How far should a gutter fall on a Severn Stoke house, and who checks it?

Brett Martin recommends 1mm for every 600mm of gutter, so a run 6 m long should drop by 10 mm towards its outlet. We sight along each run with a level and look for standing water, which shows that a section has sagged. Loose brackets are one cause, and the fascia timber behind them is probed for rot. If the fall is wrong along only one stretch, that stretch is re-set and the rest left alone.

Does the Rose and Crown's Grade II listing change how its roof is repaired?

It can. Listed building consent is required under section 7 of the 1990 Act for work that alters a listed building's character, and Malvern Hills District Council decides whether a given repair does. A pub roof is also commercial work, so access and any fragile areas are planned into the survey. We photograph the covering first, with any lead and the ridge, and the written report is laid out so it can go straight to the council.

Do I need a party wall notice to remove a chimney breast in Severn Stoke?

When the breast sits against a wall that belongs partly to next door, The Party Wall etc. Act 1996 makes the building owner the one who serves notice, and a projecting breast may be cut away only after at least two months' warning. Written consent from the neighbour avoids appointing surveyors, and silence for 14 days is treated as dissent. The Planning Portal says Building Regulations approval comes into play whenever a chimney breast is removed.

How much does Worcestershire County Council charge to put scaffold on a Severn Stoke lane?

Worcestershire County Council charges £85 per week for a scaffolding licence, then £65 for subsequent weeks, and adds a £25 urgency surcharge where an application is needed within 2 days. Worcestershire County Council's page names the company you hire for the job as the one "required to apply". Scaffold and licence both sit inside the single written price, so nothing is added after the survey.

Does a heavier tile on a Severn Stoke roof need approval?

It can. A covering that makes the roof 15 per cent or more heavier triggers Building Regulations approval, in the Planning Portal's words, and Approved Document A, paragraph 4.4, defines a significant change as an increase of more than 15%. A structural check follows. The survey compares the old covering with the proposed one before any tile is ordered, so the question is settled early, and you never learn about the weight problem after the tiles are on the pallet.

Arrange a survey of every Severn Stoke slope

Describe what the roof shows to a passer-by on the lane and attach a photo. We will fix a visit.

10-year workmanship guarantee, in writing