Callout 1 of 3
Lead and slate on a Pontrilas roof
The first callout is the lead. A 1931 inventory of Herefordshire's historical monuments describes Kentchurch Court, in Kentchurch parish, as roofed with "slates and lead". That is one house and not a rule for the district, but slate with lead is a pairing worth understanding on any roof that has both. Lead does the work in the awkward places: in valley gutters, behind chimney stacks, along the foot of a parapet and in the small sheets, called soakers, that tuck under each course of slates beside a wall or a window. Slate covers the open slope.
Lead is sold by thickness, and Royston Lead's table attaches a code to each. Code 3 is "Recommended for lead soakers only". Code 4 is listed for four uses, among them flashings and pitched valley gutters, and Codes 5 and 6 add parapet and box gutters. Too thin a code can make a lead job fail early, because thin sheet used in a wide gutter will crease and split as it heats and cools. We choose the code for the position and dress the sheet so that it can move. Lead swells in summer and shrinks in winter, so a long run is broken into sections that can slide a little without tearing, and a gutter built as one unbroken sheet is a fault waiting to appear.
How long lead lasts depends on how it was laid. HomeBuilding gives lead flat roofs as "60-100 years", and MyJobQuote's line on lead flashing is that, installed correctly, it "can last for over 80 years". Neither figure is a promise about your sheet, which may be older, thinner or patched. On the survey we look for splits along folds, for the sheet creeping down a slope, for gaps where lead meets masonry, and for sealant smeared over a crack that should have been replaced. HomeBuilding puts Welsh slate at "100+ years", so sound slates beside tired lead are worth keeping.
Where a repair is the more sensible purchase, the report states that plainly and shows the lead in photographs. When a section needs replacing, we cut out the bad sheet and leave the good one. Our lead roofing page describes how the sheet is cut, dressed and fixed, and our slate roofing page does the same for the slates that sit beside it.
Lead codes by use, as Royston prints them
- Code 3
- Recommended for lead soakers only
- Code 4
- Soakers, flashings, pitched valley gutters, dormers
- Code 5
- Flashings, valley gutters, parapets, box gutters
- Code 6
- Same uses as Code 5, in a heavier sheet















