01432 610152 Get a quote Call 01432 610152

Roofers in Penperlleni

Slate, tile and lead roof work for homes in Penperlleni, a Monmouthshire village.

From Hereford it is 29.9 road miles to Penperlleni, south-west, about 44 minutes by road. Photographs of each fault come first.

Get a free quoteCall 01432 610152

What to check on a Penperlleni slate roof

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Slate on a listed farmhouseGoytre House Farmhouse, Grade II, is recorded with Welsh slate roofs.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Wings and valleysWhere a rear wing joins the main house, the valley gutter carries both roofs.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Near the Park boundaryPart of the area round the village lies inside the National Park.

Penperlleni on our coverage map

Penperlleni on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Penperlleni roofs, slate to lead

Slate slope, wing valley and Park edge: three callouts for Penperlleni

Our Penperlleni survey begins with the slate slope, moves to the valley where a rear wing meets the main house, and finishes at the roof window, where the National Park edge and a listed farmhouse decide who has to be asked.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Slate slope; 2 Wing valleys; 3 Park edge.

Fig. 1 Section through a Penperlleni roof, callouts numbered from the slate to the window.

Callout 1 of 3

Welsh slate on a Penperlleni slope

Cadw's listing for Goytre House Farmhouse, a Grade II house in Penperlleni (record 25576, designated 18 July 2001), puts it this way: "The original portion of the house is wholly rendered and painted over local rubble stone, the rear wing is red brick, Welsh slate roofs". It describes one house, and it opens the slope callout well: how a slate roof is made, how it fails and what a survey of one looks for.

Slates hang from battens, the timber strips nailed across the rafters, each slate held by nails through two holes. SPAB describes the lapping on Welsh slate and stone roofs as "predominantly double-lapped", each course overlapping the courses below it. A slate slips when its nail rusts through or the slate itself cracks. From the ground a slipped slate is a small gap in the pattern; from the loft it can be a damp patch on a rafter. We count slipped and cracked slates course by course and photograph each cluster for you. A tingle, a thin lead or copper strip that holds a single slate in place, counts as a stop-gap, and the report names it as one.

Slate is long-lived. HomeBuilding puts Welsh slate at "100+ years", Spanish slate at "75-100 years" and reclaimed Welsh slate at "50-80 years", while SPAB judges a roof that has been properly slated "likely to be more than 100 years". Those are typical ranges and no promise about a particular roof, since a covering of sound slates can sit on worn fixings. Where the slates themselves are sound and the nails have let go, stripping, sorting and refixing can be the better buy than a new covering, and the report says so. On new work, Cupa says BS 5534 "indicates that the minimum roof pitch for natural slate is 20 degrees" for a 500mm slate with a 115mm overlap in moderate exposure, and it rules out hook fixings anywhere under 25 degrees.

A full re-cover in Wales is a Building Regulations matter, so the survey notes the rafters, the battens and the underlay as well as the slates. Our slate roofing page explains stripping and refixing, and our roof repairs page covers a handful of slipped slates.

Checked across a Penperlleni slate slope

  • Slipped or cracked slates, course by course
  • Nails that have rusted through at the head
  • The overlap between each course and the next
  • Sealant smeared over a cracked slate
  • Hip and ridge slates at the top

A slipped slate looks like a small gap from the lane and a damp rafter from the loft.

Fig. 2 The slopes, drawn close

Callout 2 of 3

Where the wing meets the house: valley lead

The same Cadw description places a red-brick wing at the back of the house, behind a front of rendered rubble stone. Where a wing joins a main block, the two roofs meet at an internal angle called a valley, and the run-off from both slopes drains down it. A valley therefore carries more water than any single slope, and one that clogs with moss or debris pushes water up under the slates along its edges.

Valleys are built in one of three ways: a lead lining, purpose-made tiles, or slates cut to meet in a swept curve. A lead lining is a gutter set in the angle. Royston Lead prints its sheet by code, and its table lists Codes 4 to 8 against the pitched valley gutter use, whereas Code 3 is "Recommended for lead soakers only". The code follows the job: the length of the run, the width of the gutter and the load it must carry. The sheet is fixed so that it can swell in summer and shrink in winter. The slates either side must overlap the lead far enough to throw water across it, so a valley repair can mean lifting a few courses beside the lead and relaying them afterwards.

Lead splits where it is laid too thin for its width or where the sheet cannot slide. From the loft, brown staining on the rafters below the valley is the clue; from outside, ripples and cracks along the folds. Sealant over a split hides it without curing the cause, so we cut out the damaged length and join sound lead beside it. Indoors, we trace any stain upward to the valley, because a stain on a ceiling may lie some way from the fault. MyJobQuote says correctly installed lead flashing "can last for over 80 years", a hedged figure for flashings, not a promise about any one valley.

The wing has its own junctions too. Where its slope butts against the main wall, the flashing steps down the wall in line with its courses, and we check the pointing that holds it. Where the stepped flashing has worked loose, it is wedged back and repointed, and if the lead has split it is renewed. Our lead roofing page goes further into lead work.

A split in valley lead

Can sealant mend a split in a valley?

Sealant hides a split without curing its cause, which can be sheet laid too thin for its width or unable to slide. We cut out the damaged length and join sound lead on either side.

Fig. 3 The valley, drawn close

Callout 3 of 3

Roof windows, the Park edge and a listed farmhouse

Last comes the roof window, which raises the question of who must be asked. The area round Penperlleni touches the edge of the Bannau Brycheiniog National Park: part of it lies inside, though Monmouthshire County Council decides planning matters for the village itself. For an address inside the Park, the National Park Authority is the body to approach, so work out which side of the line yours falls on before planning any change of look. Building control stays with Monmouthshire County Council's own service at County Hall, Usk, and a registered building control approver is the alternative.

The planning rule is the one that bites. Wales removes dormers and fresh roof windows from permitted development on article 1(5) land, which takes in National Parks, areas of outstanding natural beauty and conservation areas. Our planning guide for roof windows sets out the conditions. For a first answer on whether you need planning permission, the council's Duty Planning Officer is on 01633 644831, from 10am to 2pm, Monday to Friday.

Goytre House Farmhouse is listed Grade II, so on a roof like that, work that would alter its character needs listed building consent first. Since 4 November 2024, sections 88 and 89 of the Historic Environment (Wales) Act 2023 have said that works affecting a listed building's character must be authorised by that consent. Look up your own address on Cadw's list too, because a plain-looking house can still be listed. A listed house keeps its permitted development rights; the consent requirement sits beside them.

Conservation areas and Article 4 directions need the same care. Look up your street in Monmouthshire County Council's own conservation area list, and ask the council whether an Article 4 direction applies. Inside either, a roof you thought was routine can need permission first, and a short call before the scaffold is booked saves a delay afterwards.

At the Park edge, the first job is working out which authority answers for your address.

Planning words for a Penperlleni roof

Article 1(5) land
Welsh land in a National Park, AONB or conservation area
Listed building consent
Permission to alter a listed building, required by the 2023 Act
Article 4 direction
An order removing some permitted development rights in a defined area
Trimmer
A short timber framing the opening cut for a roof window
Registered building control approver
A private firm registered with the Building Safety Regulator

Penperlleni roofs: slate, lead and the Park edge

Is a slate roof in Penperlleni worth repairing or replacing?

If the Penperlleni slates still ring true and it is only their nails that have rusted, a repair makes more sense. HomeBuilding, on 30 September 2025, put a Welsh slate roof on a 65 m² semi at "might reach £18,000", against £10,000 to £15,000 in plain concrete tiles. Those are typical UK figures and not our prices. The survey photographs the slates and the nails, so you see the case for either route before you decide, with scaffold and tidy-up covered in the total.

Does the National Park edge affect a Penperlleni roof job?

It can. Monmouthshire County Council decides planning matters for the village, but part of the area round it lies inside the Bannau Brycheiniog National Park, and addresses inside the Park go to the National Park Authority. Check which authority covers yours. The difference matters most for any added roof window or dormer, since permitted development does not reach either on article 1(5) land, and a wrong guess costs time.

Do I need Building Regulations approval to re-roof in Penperlleni?

In most situations, yes, according to the Welsh Government. The Welsh Government's roof page says repairing or re-covering "less than 25 per cent of the area of a pitch or flat roof" will not normally need an application. Ask Monmouthshire County Council Building Control, or a registered building control approver, before work starts. A repair to a few slates is a smaller question than re-covering a whole slope, and the survey tells you which one you have.

How does a scaffold licence get arranged for a road in Penperlleni?

We arrange the licence with our scaffolder, because putting scaffold on a footway or carriageway requires a licence under section 169 of the Highways Act 1980. The licence form from Monmouthshire County Council shows £108 as an administration fee, £27 for each extra week, and at least 5 working days of notice. A tower kept within the garden, clear of the footway, falls outside that licence, and the survey settles which you need.

Can a listed Penperlleni house stay in Welsh slate?

The conversation begins there, with listed building consent agreed first. Sound slates can be stripped, sorted and refixed, and any new slate is chosen to sit beside the old in size and colour. SPAB advises that "Claims of unavailability or long delivery times should always be checked with the quarries", and we make that check before suggesting any change of material.

What insulation standard applies when a Penperlleni roof is re-covered?

The Welsh Approved Document L puts a new roof going onto a house that already stands at 0.13 W/m²K (Table 4.1). For a renovated roof, Table 11.1 asks for 0.16, and no worse than 0.35 where 0.16 is not feasible, once the renovated part passes 50% of the element, with a 15-year payback test. The next Welsh edition arrives on 4 March 2027, so the figures are worth checking again after that date.

A slate-roof survey in Penperlleni

Mention the slates, the valley or the window that worries you. A visit follows, then a written total once we have surveyed it.

10-year workmanship guarantee, in writing