Callout 1 of 3
Valleys where two Lugwardine slopes meet
The valley is the junction where a pair of slopes join in an inside corner, and run-off from each slope passes through it. On a Lugwardine house with an extension, a dormer or an L-shaped plan you will find at least one. Some are lined with lead and some are formed from specially cut tiles or slates, and the two behave differently. The lead lining sits in a channel with its edges dressed up under the covering on each side. A cut-tile valley has no lining to inspect, so everything depends on how neatly the tiles have been trimmed and bedded.
The Royal Commission on Historical Monuments, in its 1932 inventory of Herefordshire, looked at the monuments numbered 8 to 31 in Lugwardine parish and recorded timber-framed walls under roofs of tile or slate. Either covering can meet a valley, and cut slates and cut tiles fail in different ways: a slate splits along its grain at the cut, while a tile chips at the edge. We lift one course on each side if the edge needs to be seen.
A valley is cleared before it is judged, because debris can hide the fault underneath.
Lead for a valley is chosen from the maker's table, and Royston Lead lists Codes 4, 5, 6, 7 and 8 against pitched valley gutters, while Code 3 is "Recommended for lead soakers only". The code decides how well the sheet copes with a long run, so we match it to the length of the valley. Debris collects along the floor of a valley and keeps water pressed against the lead's edges, which is why clearing it comes first in any repair.
From the loft we look along the underside of the valley boards for dark staining and for daylight. Photographs follow of the valley from above, of the lead's edges and of anything we find under a lifted course. A split in the lead is a patch or a new length, depending on where it sits and how long the run is. Where a valley sits beside a chimney or a dormer cheek, we also check the lead that turns the corner, because the joins there are the hardest to dress neatly.
Our lead roofing page sets out the work from the first measurements through to the last dressing of the lead.
Valley lead or cut tiles?
Can a Lugwardine valley be mended without taking the slopes off?
The answer can be found by lifting a single course either side. Where the lead is sound and just the edges have lifted, we re-dress it. If the sheet has split along its length, we replace that length and relay the covering beside it, then show you each stage in photographs.
Looked at in every valley
- Lead edges lying flat under the covering
- Splits, pinholes or patched sealant
- Cut slates or tiles chipped at the edge
- Moss, leaves and grit in the channel
- Staining on the boards from the loft















