Callout 1 of 3
Timber walls under tile, slate and thatch
The first callout is the frame. Volume 2 of the Royal Commission's Herefordshire inventory (1932) covers Fownhope parish and, for monuments 3 to 29, describes timber-framed walls under roofs of tiles, slates or thatch. That is three coverings over one kind of wall, and each is a trade of its own. Tile and slate are our work. Thatch belongs with a specialist thatcher, and if your house has a thatch, or the survey finds one under a later covering, we will say so at the first visit and leave that part to the right trade.
Under a tile or slate covering, the layers beneath do as much as the surface. We lift a few units at a sound spot and look at the battens, the underlay and the first courses at the eaves. With a high-resistance (HR) underlay, which does not let vapour through, Marley says a cold roof needs a ventilation gap along the eaves: 25mm for pitches of 15 degrees or less, and 10mm for pitches over 15 degrees. A framed house has old timbers in the roof as well as the wall, and a roof that cannot breathe puts them at risk. So the ventilation gap is measured, not assumed.
Where a framed gable is involved we also look at the verge and at the joint with the wall, and photograph both. A tile that has slipped beside a timber can be a sign that the timber has moved, and the report records which fault came first, so the repair is aimed at the cause as well as the symptom.
Lifespans are ranges and never promises. Marley says the BRE set a minimum life expectancy of 60 years for clay roof tiles, and the figure belongs to clay alone. HomeBuilding gives clay tiles "60-80 years", Welsh slate "100+ years" and reclaimed Welsh slate "50-80 years". Where a covering is near the end of that range, the report says how much sound stock can be reused and what the replacement would be.
A heavier covering changes the load on the frame. Weight is tested too. Should a new covering be 15 per cent or more heavier than what it replaces, the Planning Portal says Building Regulations approval is brought in, so the frame and rafters get a structural check before anything is ordered. Tile and slate choices, with the fixings each one takes, are laid out on our pitched roofing page.
Checked under a Fownhope covering
- Batten spacing and condition
- Underlay type and the state of its laps
- The ventilation gap along the eaves
- Rafters and wall plate from the loft
- Any older covering left in place beneath
Under the covering, the battens, the underlay and the eaves gap tell us more than the tiles do.















