01432 610152 Get a quote Call 01432 610152

Roofers in Gilwern

Slate roofs, roof lights and flat roofs for Gilwern homes inside the National Park.

From Hereford, Gilwern is 28.3 road miles south-west and takes about 42 minutes. Each survey is photographed and ends in one written total.

Get a free quoteCall 01432 610152

Slate, roof lights and the Park rules

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Slate roofs on Rock CottageCadw's listing for this Grade II cottage records slate roofs.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Roof lights inside the ParkNew roof lights need planning permission from the National Park Authority.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Flat roofs on extensionsFalls, membranes and edges decide how a flat extension roof lasts.

Where Gilwern sits

Gilwern on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Gilwern roofs under the Park

Slate cottages, roof lights and flat roofs: three callouts on a Gilwern house

We begin under the slates, where underlay and ventilation do their work, move to the roof windows that the National Park rules restrict, and end with the flat roofs and extensions that need a fall and a membrane.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Slate and underlay; 2 Roof windows; 3 Flat roofs.

Fig. 1 A Gilwern house in section, with slope, roof window and flat roof numbered.

Callout 1 of 3

Slate roofs, underlay and the air beneath them

Cadw's listing for Rock Cottage, Grade II (record 23829, listed on 27 July 2000), records only "Slate roofs". It is a useful reminder that a slate roof is more than its slates. Under them lie the underlay, a membrane that backs up the covering, and the battens, the timber strips the slates hang from. We read both from the loft and from the slope, because daylight through the boards and stained timber show a fault that the slates hide. Up in the loft, the underside of the underlay is checked for damp marks, and the battens for soft or darkened timber, with every mark photographed and located.

The air beneath matters too. Marley sets out the eaves gap for a cold roof under HR underlay: "25mm along the length of the eaves for pitches of 15° or less; 10mm along the length of the eaves for pitches of more than 15°." HR stands for high resistance, and Marley states plainly that such an underlay will not pass vapour, which leaves the gap to do the job. An air-permeable LR underlay beneath a tightly sealed ceiling can depend on "fortuitous ventilation at the eaves via normal eaves construction (3mm)", but only where the third-party certification requirements are met. A blocked eaves gap is therefore something we look for when a Gilwern loft feels damp.

Welsh rules govern any re-cover. The Welsh Government's page on re-roofing is blunt: "In most situations, this work will need Building Regulations approval." Inside the Bannau Brycheiniog National Park, the National Park Authority is the planning authority and Monmouthshire County Council keeps building control, so a re-cover can involve two bodies. We find out which questions apply to your address before the quote is written. A re-cover also raises the insulation question, because the Welsh Government says that "the work to re-cover a roof should also include for improving the thermal insulation properties of the roof."

Repair pays when the slates are sound and just a few have slipped. Fixed well, natural slate lasts: HomeBuilding lists Welsh slate at "100+ years", and SPAB says a well-slated roof is "likely to be more than 100 years". Our pitched roofing page explains how slopes, underlay and eaves work as one system.

The gap at the eaves

What is the gap at the eaves for?

In a cold roof with HR underlay, Marley gives 25mm along the eaves for pitches of 15 degrees or less and 10mm above 15 degrees, so air can move through the roof space and carry moisture out.

Daylight through the boards tells you what the slates are hiding.

Fig. 2 The slopes, drawn close

Callout 2 of 3

Roof windows and the National Park

Next comes the roof window, glazing set into a sloping roof. Gilwern lies inside the Bannau Brycheiniog National Park, designated in 1955, and the Authority decides planning applications for Gilwern. In Wales, land in a National Park is article 1(5) land, so permitted development gives no cover there for adding a roof light or building a dormer: planning permission is needed. Our planning guide for roof windows sets out the rules, and the Authority is the body to ask before a design is drawn. Bring photographs of the slope and a sketch of where the window would sit, so the question is a concrete one.

Planning is one question and Building Regulations are another. The Welsh Government says that "Approval under the Building Regulations will generally be needed for the installation of a new rooflight", and building control for a Gilwern address stays with Monmouthshire County Council or a registered building control approver. The Welsh Approved Document L sets the glazing standards. Table 4.1 sets 2.2 for a rooflight and 1.4 or WER Band B for any window or roof window put into an existing dwelling, with 0.13 W/m²K for the roof itself. Where an old window stays, Table 10.1 gives threshold values of 3.3 for windows and 3.8 for rooflights.

Swapping one window for the same again is a smaller job than cutting a new opening, because the framing and the flashing seat are already there. Even so, we look at the old window with care. From the loft we check the framing round the opening and the lining. From outside we check the flashing apron beneath the glass and the tiles or slates that overlap its sides, because water stains from a roof window can appear at that junction before a ceiling is marked.

The window is replaced by one that suits the roof, not the other way round, and the photographs show the opening before the new unit goes in. Our Velux and skylight page explains what a swap and a new opening involve.

Welsh U-values for glazing and roofs

New roof, existing dwelling
0.13 W/m²K, Table 4.1
Window or roof window
1.4 or WER Band B
Rooflight
2.2
Renovated roof
0.16, no worse than 0.35, Table 11.1
Fig. 3 Roof windows, drawn close

Callout 3 of 3

Flat roofs on extensions, porches and garages

If a Gilwern house has a flat roof over an extension, porch or garage, that roof is judged on three things: its fall, its covering and its edges. BS 6229:2025, the current standard, covers roofs finished in a membrane laid continuously over a support, and it does not cover lead. NFRC reads it as setting "a minimum 1:80 finished fall for general roof areas and internal gutters", while IKO advises designing for 1:40 to reach 1:80 once the roof is built. Ponding after rain is a sign that the fall has been lost. The edge matters as much as the middle: the trim at the lower edge sends water into a gutter, and Brett Martin gives "1mm for every 600mm" as the gutter's own fall to its outlet.

Published life figures for flat coverings disagree. HomeBuilding gives EPDM "25-30 years" and Less gives it "30 to 50 years". HomeBuilding gives GRP "25-30 years" where Less says "25 to 40 years", and for felt HomeBuilding has "10-15 years" where Less has "10 to 20 years". We quote both for each covering, because neither describes a particular roof, and the survey, with photographs of seams, upstands and edges, tells you what is left in yours.

Welsh rules treat a flat roof as a thermal element. The Welsh Government accepts that some flat roof repairs need no application, yet writes that "if the roof with integral insulation is to be replaced then you may be required to upgrade this 'thermal element'". Paragraph 11.16 of the Welsh Approved Document L counts "replacing the waterproof membrane of a flat roof" as replacing an existing layer, which is why an upgrade can follow a new membrane. Table 11.1 gives 0.16 for the renovated element, and no worse than 0.35 where 0.16 is not feasible.

Our flat roofing page describes repairs and replacements. Where the flat roof abuts a slate slope, a lead flashing joins the two, in a thickness chosen from Royston Lead's table, where Codes 4, 5 and 6 are listed for flashings. At a wall, the upstand, the flashing and the edge trim are photographed first, since that junction is where the covering ends and the stone or brick begins.

Flat roof words in plain terms

Finished fall
The slope of the roof once everything is laid
Membrane
The waterproof sheet that forms the covering
Upstand
The vertical edge where the membrane turns up a wall
Thermal element
A wall, floor or roof counted for insulation

Gilwern roofs: slate, roof lights and the Park

Is a Gilwern slate roof worth repairing rather than replacing?

Repair is the answer if the slates are sound and only a few have slipped. Checkatrade's June 2026 repair rates (before VAT, for jobs up to 3 m²) put natural slate at £150 to £220 per m². HomeBuilding gives Welsh slate "100+ years" and reclaimed Welsh slate "50-80 years". The survey photographs the nails, the laps and the battens, and the report says which route is the better buy. That rate is per square metre, so it is not a figure to multiply by the size of a roof.

Which list tells me whether my Gilwern house is in a conservation area?

Ask Bannau Brycheiniog National Park Authority, which is the planning authority for Gilwern, and check its own conservation area list against your address. We do the same check before we quote, so the price already allows for any consent that is needed. Conservation areas are designated under Part 4 of the Historic Environment (Wales) Act 2023. Check whether an Article 4 direction applies with the Authority as well, because the Welsh Government notes that permitted development rights may have been removed by an Article 4 direction.

What do published guides say a roof window swap costs?

MyJobQuote says Velux window replacement costs "around £100 less for a straightforward swap, as the opening is already in place", and gives a small FK04 centre pivot as around £330, which is the product price. Checkatrade lists rooflight replacement "from £1,000", and the word "from" matters, because it is a starting point and not a price. These are third-party figures, so ours is one written total, set after we have seen the opening from inside and out.

What do the cost guides say about a flat roof on a Gilwern garage?

Which?, in its November 2025 survey before VAT, puts a felt flat roof on a typical single garage, 6m by 3m, at £1,400 to £3,500. MyJobQuote gives the 2026 average flat roof replacement as £1,500 to £6,000. Those are national ranges, quoted from two different guides. The price for your garage comes from the survey, which reads the fall, the edges and the covering, and the report says whether a repair or a new covering is the better buy for the roof you have.

Can spray foam under a Gilwern slate roof cause problems?

It can. The Energy Saving Trust says closed-cell foam's main drawback is that it is not vapour permeable, and that the risk to roof timbers "should be much lower with an open-cell foam". RICS wrote on 3 March 2023 that "there has been concern within specific sectors of the lending market, such as equity release mortgages", so check with your mortgage provider before foam goes in.

What changed in Welsh building control from 1 July 2026?

The Welsh Government says new building regulations came into force on 1 July 2026, introducing reform of building control processes, particularly for higher-risk building work. For non-higher-risk work it replaced depositing plans with applications for building control, and building control approval now lapses automatically after three years. Monmouthshire County Council Building Control or a registered building control approver handles a Gilwern roof, and we confirm which applies to your address before the quote is written.

Have your Gilwern roof looked at from underneath

Describe the roof and what is wrong, with a photo if you have one. The survey comes before any price.

10-year workmanship guarantee, in writing