01432 610152 Get a quote Call 01432 610152

Roofers in Fernhill Heath

Roof repairs, flat-roof extensions and roof windows for Fernhill Heath homes.

Gable edges first, then the flat extension, then any loft window: photographs of each, and one written total after the survey.

Get a free quoteCall 01432 610152

Verges, flat roofs and windows in Fernhill Heath

  • Older cottages with weathered clay tile roofs and brick chimneys behind a flint wall
    Verges that have dropped their mortarLoose verge tiles let wind lift the roof edge and rain reach the gable.
  • Slate roofs and chimney stacks along a red brick Victorian terrace
    Flat-roof extensions at the backA flat roof with a poor fall leaves standing water on the covering.
  • Newer homes with grey concrete tile roofs along a curving estate road
    Loft conversions and roof windowsA roof window brings Building Regulations and planning questions of its own.

Close to Fernhill Heath

Fernhill Heath on a street map, with a dashed circle around the town and the nearest towns we cover. Tiles © Esri; map data © Esri, HERE, Garmin, OpenStreetMap contributors.

Fernhill Heath roofs, verge to window

Verge, flat roof and roof window: three checks at Fernhill Heath

The survey starts at the gable verge, moves to any flat-roofed extension and its fall, and ends at the roof windows and loft conversions where planning, Part L and the conservation area nearby all come into play.

A drawn cut-away section through a Herefordshire border house: the front of the main roof is cut open to show the rafters, underlay, battens and slates, beside a black-and-white timber-framed gable. Numbered, from the ridge down: 1 Verge edge; 2 Flat extension; 3 Roof windows.

Fig. 1 A Fernhill Heath roof in section: verge, flat extension and roof window.

Callout 1 of 3

Gable edges on Fernhill Heath houses

A pitched roof finishes at a gable wall in a sloping edge called the verge. Tiles at that edge overhang the masonry slightly and are closed off with bedded mortar or with clip-on dry-fix units. Wind meets this edge before anything else on the house. Once the bedding loosens, a gust can lift the end tiles, and rain then reaches the gable wall behind. At every gable we sight along the verge for gaps, cracked bedding and tiles that no longer lie in line, and we press the end tiles by hand. Cut tiles at the edge, where a tile has been trimmed to fit, get the closest look, because a cut edge is where cracks start. A second look goes to the corner where verge meets eaves, since two edges are joined there.

BS 8612 sets the standard for dry-fix fittings at ridge and verge, and BS 5534:2014+A2:2018 covers slating and tiling practice. Marley adds that mortar alone can no longer be relied on to hold a covering in place. So a dry verge is one choice and a bedded verge with mechanical fixings is another. Which one suits a Fernhill Heath house depends on the existing tiles, the gable and the way the wall is finished.

Behind the verge sits the wall plate, with the first rafter beside it. Up in the loft, our check is for tide marks and damp timber at the gable end, because a stain there means the verge has been admitting moisture for some while. Photographs go in from both sides, so you can match the cause outside to the damage inside, and the written price covers the repair that fits what was found.

A gable takes wind and rain from whichever side it faces, whatever the age of the house behind it, and a verge that has held for years can fail after a single hard season. Edge repairs belong with pitched roofing, which covers tiled and slated slopes, and the same visit also looks at the ridge, the hips and the valleys.

What we look at along a gable edge

  • Verge tiles that lift or sit out of line
  • Bedding that has cracked or dropped away
  • The gable wall for wet patches
  • Fixings on each edge tile
  • Tide marks in the loft at the gable

A verge tile that lifts in a gust was loose long before it moved.

Fig. 2 The verge, drawn close

Callout 2 of 3

Flat extension roofs and the fall that drains them

No flat roof is truly level. It is laid to a slight slope, the fall, so water runs to a gutter or outlet. NFRC, working from BS 6229:2025, gives a "minimum 1:80 finished fall", and IKO advises designing for 1:40. The standard deals with membranes only, never lead. On a Fernhill Heath extension we look first for ponding, where water lies after rain, and then for splits, blisters and laps that have started to open.

What the covering is made of sets the likely lifespan, and published figures differ. For EPDM, a rubber membrane, HomeBuilding gives 25-30 years and Less gives 30 to 50. For GRP, glass-reinforced plastic, HomeBuilding gives 25-30 and Less gives 25 to 40. For felt, HomeBuilding gives 10-15 and Less gives 10 to 20. Read each as a typical range, never a promise; a poor fall or a blocked outlet shortens any of them.

Part L reaches a flat-roof re-cover too, because AD L 2021 counts a replacement waterproof membrane as renovation. For renovation, Table 4.3 sets a roof threshold of 0.35 and an improved figure of 0.16, and paragraph 4.13 allows a relaxation where 0.16 would not pay back within 15 years. From 24 March 2027 AD L 2026 takes over, with the tables renumbered 3.2 and 3.3. South Worcestershire Building Control, or a registered building control approver, is the place to ask before the work is planned.

At the edges, a flat roof needs an upstand where it meets a wall, a flashing over that upstand, and a drip trim where it meets the gutter. Those details fail before the middle of the deck does, so they are photographed one by one. Outlets are checked for leaves and silt, and any guard fitted over them is lifted to look underneath. When the job ends the deck is swept and the old covering goes with us. Our flat roofing page describes the coverings we fit, and a repair is quoted as a repair whenever the deck underneath is sound.

A flat roof's fall, drawn close

SoundRain drains off to the outlet and the deck dries
Needs workWater stands after rain and the laps start to lift

Ponding on a flat deck is the fall talking, and the survey listens to it first.

Callout 3 of 3

Roof windows and the nearby Martin Hussingtree conservation area

The last callout is a roof window, the point at which a loft becomes a room. A roof window takes the place of a patch of covering and sits in line with the tiles around it, and its flashings are the weak spot if they are cut or lapped badly. Larger frames mean longer flashings and more rafters trimmed, so the opening is marked out from inside before any tile is lifted. The old tiles are stacked for reuse around the frame where they are sound. Before anything is cut, we check the rafter spacing, the trimming the opening will need, and the underlay around it. The planning and Building Regulations questions follow from there, and our planning guide for roof windows sets out the planning side in full.

On Part L, AD L 2021 Table 4.2 gives a roof window "1.4 or Window Energy Rating Band B minimum" and a rooflight 2.2. Where the existing roof around the opening is touched, Table 4.3 applies to it, and from 24 March 2027 AD L 2026 takes over in England with its own table numbers. A loft conversion also raises the matter of escape from the new room. AD B paragraph 2.5 allows a protected stairway or an alternative escape route for that, and building control confirms on your behalf which one the new room needs.

The Martin Hussingtree conservation area lies close to Fernhill Heath. Wychavon District Council holds it and is the authority to ask whether your address falls inside, and whether an Article 4 direction applies. In the village itself, the wall and gate piers in front of Fernhill Heath House are listed Grade II (list entry 1081170, first listed 21 March 1985), and under LBCA 1990 s7 work touching its listed character needs listed building consent.

Opening up a roof can disturb bats. Disturbing a bat in its roost, or blocking its way in, intentionally or recklessly, is an offence under section 9(4) of the Wildlife and Countryside Act 1981, whereas reg 43 of the Habitats Regulations needs no intent where a resting place or breeding site of a bat is damaged. Natural England issues the licences in England, and a roost found mid-job stops the work. Our skylights page covers how a roof window is fitted, flashed and finished.

A roof window is a hole cut in a sound slope, and the flashings decide whether it stays dry.

Price drivers for a Fernhill Heath roof window

Window size
Larger openings need more trimming and more flashing
Glazing
The Part L figure the window must meet
Roof covering
Slate, clay or concrete changes the flashing used
Structure
Rafter trimming around the opening
Access
Scaffold and internal protection while the opening is cut

One written total price, never itemised.

Fernhill Heath roofs: flat decks, verges and windows

How should a flat extension roof at Fernhill Heath be laid to drain?

With a fall to an outlet. NFRC, citing BS 6229:2025, gives a minimum 1:80 finished fall, and IKO advises designing for 1:40. The standard covers membranes only. We look for ponding after rain, since water standing on a deck shortens the life of the covering and points to a fall that has been lost over the years.

Is a roof window possible in a Fernhill Heath loft?

Possibly. Planning and Building Regulations both apply, and the planning guide covers the planning side in full. On Part L, AD L 2021 Table 4.2 gives a roof window 1.4 or Window Energy Rating Band B minimum, and a rooflight 2.2. Ask South Worcestershire Building Control or a registered building control approver before you order the window. Glazing figures and the escape route from a loft room both need settling first, and the answer goes on the survey report.

Is Fernhill Heath near a conservation area?

The Martin Hussingtree conservation area lies close to the village. Wychavon District Council holds that area, so ask the council where your house sits in relation to it. Ask the council whether an Article 4 direction applies as well. A plain re-cover is a different question from a new window or dormer, which the planning guide deals with, and the survey report notes what the council tells you.

How long does a flat roof covering last on a Fernhill Heath extension?

Published figures differ. For EPDM, HomeBuilding gives 25-30 years and Less gives 30 to 50. For GRP, HomeBuilding gives 25-30 and Less gives 25 to 40. For felt, HomeBuilding's range is 10-15 years against Less at 10 to 20. Treat them as ranges, not promises; a poor fall or a blocked outlet cuts any covering short, which is why the survey checks the outlets first.

Will a new flat-roof covering at Fernhill Heath need Building Regulations sign-off?

In AD L 2021, stripping a flat roof's worn waterproof membrane and laying a replacement counts as renovation, so Part L applies to it. Table 4.3 gives a threshold of 0.35 and an improved figure of 0.16. Ask South Worcestershire Building Control, or a registered building control approver, how that applies to your roof before the work is planned, and keep their answer with the quote.

What if bats are found in a Fernhill Heath loft during roof work?

Work stops in that area until advice is taken. Section 9(4) of the Wildlife and Countryside Act 1981 makes it an offence to disturb a roosting bat or obstruct the way into its roost, intentionally or recklessly, while reg 43 of the Habitats Regulations needs no intent where a resting place or breeding site of a bat is damaged. Natural England issues licences in England, and the area is photographed without being disturbed. Bat advice comes before any quote for that part of the roof.

Fernhill Heath verge, flat roof or loft window?

Tell us which part of the roof worries you, or send a photo, and the survey is booked, with the price written down after it.

10-year workmanship guarantee, in writing