Callout 1 of 3
Hipped roofs and the lines where they meet
A Bransford survey begins where the roof's lines meet. The Victoria County History of 1924 describes Bransford's chapel of St John the Baptist as a building "of stone with red tiled roof", with "a wooden bell-turret at the west end with pyramidal slated roof". A pyramid roof is all hips, four sloping corners rising to a point. A hip is the sloping outside corner where two roof slopes meet, so a hipped end has no gable wall and no verge: the slope turns the corner instead. That adds a line of tiles to look after. The ridge runs along the top, a hip tile runs down each corner, and the point where they meet is a joint that takes weather from three directions. Water from both slopes runs toward a shared corner, which is why we look there first.
Hip tiles are bedded in mortar or held with clips. We check the bed for gaps, the hip tiles for slip and the foot of each hip, where it meets the eaves and the gutter. A slipped hip tile leaves the mortar under it open to the rain, so a hip is repaired tile by tile before more mortar is lost.
A red tile may be clay or concrete, so we identify it first. HomeBuilding lists clay tiles at "60-80 years", and Marley, quoting the BRE, puts the minimum life of clay roof tiles at 60 years. Pitch counts as well: Marley's clay tiles carry minimum pitches of 30 degrees for the Hawkins and the Acme Single Camber, 35 for the Ashdowne and 40 for the Canterbury. What we measure against is the manufacturer's sheet for whichever tile is on your roof, and the photographs show you what we saw.
Inside the roof space we examine the hip rafters and the timbers either side of them for staining that points to a failed hip bed. Ridge and hips come together inside the roof space at one joint, and daylight showing around it means the covering outside has opened in the same place. That view also tells us whether a ceiling patch comes from the hip or from somewhere else entirely.
If a re-cover is the answer, weight needs checking. Approved Document A, paragraph 4.4, defines a significant change in roof loading as an increase of "more than 15%", and the Planning Portal puts the same point as 15 per cent or more. Either way it is a Building Regulations matter, and the rafters come under review before a heavier covering goes on. Our pitched roofing page covers re-covering a hipped roof.
A hip on a Bransford roof
A hip turns the corner where a gable would stop, and the corner needs its own tiles.















