01432 610152 Get a quote Call 01432 610152

Slate tingles

What is a tingle, and when is it the right slate repair?

A tingle is a narrow metal strip that holds the bottom edge of a slate in place. It suits a whole slate that has slipped, not one that has broken.

In brief

A tingle is a short strip of lead or copper, tacked to the batten through the joint between two slates and turned up around the slate's lower edge. It lets a slate whose nails have failed be slid back into its course and held there without lifting a patch around it. It is right for a whole, sound slate on a roof that is otherwise in order. A slate that is cracked or flaking needs replacing, not holding.

What a tingle is and how it is fitted

A slate normally hangs by nails driven through it near the top, under the course above. Once those nails fail, the slate cannot be nailed again without lifting a wide patch of slates around it, because the nail holes sit under the overlapping courses. A tingle does the job from below.

The steps are short:

  1. Slide the slipped slate back into its course.
  2. Pass the strip up through the gap between the two slates below.
  3. Tack the foot of the strip to the batten behind.
  4. Turn the free end up around the lower edge of the slate and press it flat.

The result is a small band of metal showing across the bottom edge of one slate. Lead and copper are chosen because they bend easily and do not rust. The strip carries the weight the nails used to carry, so it has to be fixed to a sound batten and bent without cracking the slate.

From the street a sharp eye can pick one out, which matters on a front slope. It does the job it is fitted for, and no more. Where the front of the house is on show, the choice of strip and its finish is discussed before work starts, and the strip can be dressed so it sits as close to the slate as possible.

When a tingle is the right repair

A tingle fits when the slate itself is sound and the fault is its fixing. On the survey we look for:

  • a whole slate, without a crack, a lost corner or a split at the nail holes
  • a small number of slipped slates, in no pattern
  • sound battens behind them, to take the foot of the strip
  • a pitch where the alternative, a slate hook, is ruled out

That last point matters. Cupa, the slate producer, rules hooks out on slopes under 25 degrees, so on a shallower slope the tingle is the way of holding a refixed slate. Cupa also gives 20 degrees as the floor pitch for natural slate, for a 500 mm slate in moderate exposure with a 115 mm overlap, which leaves a band of low slopes where hooks are out and tingles remain.

Where slates are slipping in lines, or across a whole slope, the nails behind the rest are the same age, and a tingle on each would only postpone a re-slate. The answer on nail sickness explains how to tell the two cases apart.

Tingle, hook or new slate: choosing between them

Three repairs compete here, and the slate in your hand decides which one fits.

Choosing a slate repair
RepairSuitsLimit
TingleA whole slate, any pitch where the roof is soundShows as a strip of metal
Slate hookA whole slate on a steeper slopeNot below 25 degrees
New slateA cracked, flaking or lost slateMust match size, thickness and colour

A replacement is cut to the size and thickness of its neighbours. HomeBuilding puts Welsh slate at 100+ years and reclaimed Welsh slate at 50 to 80 years, as typical ranges, so the source matters as well as the look. The guide to nails or hooks for slates sets out the fixing choice in more depth.

A closing photograph shows the repaired slate level with those around it, so the course can be judged without a ladder.

Length matters whichever repair is chosen. A tingle holds a slate by its tail, and the slate must lap correctly over the course below, so a replacement cut short will not sit right whatever holds it.

What a tingle repair costs, and the rules that apply

Guides price slate repairs by area, not by fixing. Checkatrade's June 2026 guide gives natural slate repairs at £150 to £220 per m², excluding VAT, with its rate set for no more than 3 m². That is a rate for a patch of slope. It is never multiplied by a roof area, and it does not describe a single slate. MyJobQuote's average roof repair, around £650, spans every kind of job, so it cannot stand in for a tingle either.

The rules stay light for a few slates, though they differ across the border.

  • England: a few tingles sit far below the Planning Portal's thresholds of under 25 per cent of the building envelope and under 50 per cent of the roof.
  • Wales: past 25 per cent of the roof area, the Welsh Government's roof page expects better insulation to come with the work, and a handful of slates is nowhere near that.

The slate roofing page covers the wider range of jobs. The quote that follows a visit gives a single total.

Related questions

Will a tingle be noticeable on my roof?

It shows as a short band of metal across the bottom edge of the repaired slate. From the street it is easy to miss, and it is far less obvious than a patch of mismatched slates. On a front slope we can talk through the options before choosing between a tingle and a hook.

How long will a tingle repair last?

A tingle holds one slate, so the survey checks the slates around it as well. It holds a sound slate for as long as the batten behind it stays sound and the strip stays whole. If the roof is shedding slates across a slope, a re-slate is the lasting answer, and we explain why with photographs.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing