01432 610152 Get a quote Call 01432 610152

Double-lapped slate

Are Welsh slate and stone roofs Double-Lapped?

Predominantly, yes. SPAB's guidance covers this region, and the double lap explains how a slate or stone tile sheds water and stays in place.

In brief

Predominantly, yes, and that is SPAB's own word. In its technical note on Welsh and border roofs in slate and stone, SPAB calls them "predominantly double-lapped": each slate is covered at its head by the course above and covers the head of the course below, so two layers protect the whole slope. SPAB's wording allows for exceptions, which is why we read the laps on your roof at the survey.

How a double lap works on a slope

A slate or stone tile never lies flat against the batten alone. The batten is a narrow timber lath running across the rafters, and each course hangs from it. In a double-lapped roof every course reaches down over the one beneath by a margin, so a drop of water that gets past one layer meets a second layer straight away.

That margin is the headlap: the amount by which a slate's lower end overhangs the upper end of the slate two courses down. A deeper headlap gives more cover and costs more material, and a roof at a low pitch needs a deeper one than a steep roof.

Each course is also shifted half a slate along from the one beneath, so every joint sits over the middle of a slate below it. Single-lap is the other pattern, where a tile has an interlocking edge and overlaps only at the side and the head. Slates and traditional stone slabs depend on the layers instead.

One result of the layers is that a broken slate leaves a hole in only one of them, and the damage behind it can stay hidden for a while. That is part of why we look under and around a gap, not only at it.

What SPAB says about this region

SPAB wrote for Wales, west Gloucestershire, Herefordshire, Worcestershire and Shropshire, so its note speaks to roofs on both sides of our border. It points out that purple stone slates turn up in Herefordshire, in a region where grey and brown are the usual shades, and that "Welsh slate" is now a name for slate from the north-west of Wales.

SPAB regrets that many old stone coverings have been swapped for other stones, for slate or for artificial stone. On supply, it tells readers to test any claim of shortage or lengthy waits with the quarries.

The roofs of old Herefordshire buildings in stone are covered with tilestones cut from local sandstone. Among the sources the building stone atlas for Herefordshire lists, the St Maughans Formation comes first, with permissions still live across the Golden Valley area. Longtown's older cottages are still flagstoned, as are Kington's, from a different mudstone. We ask a quarry before suggesting anything but like for like, and we keep the original covering wherever it can be kept.

The rules when a double-lapped roof is re-covered

Re-covering involves rules as well as skill, and they differ across the border. Each row belongs to its own country.

Slate and stone re-covering, England and Wales
QuestionEnglandWales
ApprovalNone normally, by the Planning Portal test of 25 and 50 per centWelsh Government: in most situations, Building Regulations approval
Heavier coveringPlanning Portal: 15 per cent or more needs approvalWelsh Approved Document A: more than 15%
Different materialClass C has no matching conditionClass C.2(a): match so far as practicable

The English test is less than 25 per cent of the building envelope and less than 50 per cent of the roof affected. Welsh Government guidance names slate to tiles as a different-material case. A change of covering also changes the weight on the roof timbers. A structural check and Building Regulations approval come with a new covering that adds 15 per cent or more in England, or more than 15% in Wales, and you should hear about that before the work is booked. A listed house keeps Class C on each side of the border but needs consent too, and conservation areas work differently in England and Wales, so ask the council about your address.

Pitch, headlap and what we measure on site

Cupa, the slate producer, cites BS 5534:2014+A2:2018 for a 20 degree minimum pitch on natural slate, but only at moderate exposure with a 500mm slate and a 115mm overlap. Cupa's view is that hook fixings suit no pitch below 25 degrees. For stone tiles, pitch and lap are judged from the existing roof and from what the quarry advises.

At the survey we check:

  • the pitch of each slope, measured with a level
  • the number of courses and the size of the slates or stones
  • the headlap, where the roof allows it to be seen
  • how each piece is held, by nail, peg or hook
  • the state of the battens and the underlay behind the gaps, and any rot at the eaves

We photograph worn edges and fixings so you see what we see, and then say whether a patch or a full re-slate is the better buy.

Related pages are stone roof tiles in Herefordshire, slate pitch and headlap and nails or hooks for slates. The hub is slate roofing.

Related questions

Are Herefordshire stone tile roofs double-lapped too?

SPAB's note covers Herefordshire along with Wales and the borders, and treats Welsh slate and stone roofs together as predominantly double-lapped. The pattern is therefore expected on the stone roofs of the region, though an individual roof can differ, which is why the survey reads the actual laps.

Does re-slating a border house need approval?

In Wales, gov.wales says re-roofing will in most situations need Building Regulations approval. In England, the Planning Portal test is less than 25 per cent of the building envelope and less than 50 per cent of the roof affected, below which no application is normally needed. Ask building control either way.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing