01432 610152 Get a quote Call 01432 610152

Chimneys in a re-roof

Should the chimney be repaired during a Re-Roof?

It makes sense: the flashings come off with the covering anyway, and the scaffold is up. Altering or removing a stack is a separate matter.

In brief

Yes, where the stack needs work. A stack is where new covering meets old masonry, and the lead that seals the join is lifted when the slopes are stripped. With the scaffold up, the pots, the flaunching (the sloping mortar cap on top of the stack) and the flashings can be checked and renewed without paying for access twice. Taking a stack down or altering it is a different question, with planning, Building Regulations and party wall points that differ between England and Wales.

Why the stack is dealt with in the same visit

A re-roof cannot simply leave the chimney alone. The lead where a stack meets the slope is tucked into the brickwork or stonework, so stripping the covering disturbs it, whether or not it was failing. New covering beside old flashings joins two ages of work together, and a join like that is where a leak is most likely to begin.

Access is the other reason. MyJobQuote prices full chimney leadwork at £350 to £920, with the scaffold the main swing factor in that spread. When a scaffold already stands for the re-roof, much of that cost is carried by the larger job.

On the first visit we therefore look at the stack with the whole roof in mind: how it sits on the ridge or slope, what is built into it, and what the flashings are made of. You receive the photographs, and the choice of what to renew is made with them in front of you, before the price is written. A stack is also one of the first things we look at on any roof, because ridge, verge and chimney are where the roof meets the sky.

What gets checked on the stack, and the lead

With the slopes bare, parts of a stack that are hidden from the ground come into view:

  • the pots, and whether each one is bedded firmly
  • the flaunching, which sheds water off the top and cracks with age
  • the pointing, and any open joints between courses
  • the lead flashings, soakers and any back gutter behind the stack
  • any lean or movement in the stack as a whole

For the lead, Royston Lead's cast-lead table is the reference. It marks Code 4 and Code 5 for flashings, and describes Code 3 as recommended for lead soakers only. MyJobQuote says correctly installed chimney lead flashing can last for over 80 years. The wording is a hedge, not a guarantee of any one flashing. A flashing that is sound stays; one that is torn, lifting or thin is renewed while the access is there.

The pages on chimney flashing leaks and flaunching on top of the stack cover each part in detail. Pointing is priced once the stack has been looked at closely.

Changing a stack: the rules on each side

Repairing a stack is one thing and changing it is another. The planning and approval points are not the same either side of the border.

Chimney changes in England and Wales
PointIn EnglandIn Wales
PlanningClass C of the 2015 Order leaves out a new or replaced chimneyClass C.1(c) of the 1995 Order leaves out the same, and removal on article 1(5) land
Breast removalThe Planning Portal says Building Regulations approval will always applyAsk the council's building control first

A shared stack brings in the Party Wall etc. Act 1996. Notice is the building owner's job. Taking a projecting breast off a party wall is work to that wall, and under sections 2(2)(g) and 3(2)(a) the owner serves at least two months' notice on the neighbour first. Written agreement from the neighbour is enough to proceed. If they dissent, or say nothing for 14 days, each side then appoints a surveyor or both share one. Section 2(2)(j) also lets an owner cut into the adjoining wall to fit a flashing. A listed house also needs listed building consent, so raise it with the council before drawing up any change.

Guide costs, and how we use them

The figures here come from third-party guides, not from us. For a chimney lead flashing, MyJobQuote gives around £200 for a patch repair, and around £570 as the average for a full replacement. For chimney breast removal it gives around £2,500, in a range of £1,200 to £3,500, while a stack removed together with its breast averages £3,000 to £3,500 in the same guide.

On your own house, four things move the number: how tall the stack is, how sound the masonry is, how much lead is involved and whether the scaffold is already up for the re-roof. A shared wall adds the notice period and possibly a surveyor.

Our quote is written after the survey and gives one total. Where a stack is leaning or the brickwork is crumbling, you see the photographs before anything is agreed. Chimney repairs covers the whole range of stack work, from pots and caps to a full rebuild above the roofline. For the roof itself, read roof replacement, and the job stage by stage shows where the stack falls in the order of work.

Related questions

Can I leave an old chimney alone if I re-roof around it?

You can, but the flashings still have to be lifted and re-made, so the stack is disturbed either way. The better question is what condition it is in. If the pointing, flaunching and lead are sound, they stay. If not, renewing them now costs less than putting scaffold up for them later, and the roof is already open.

Who tells the neighbour if the stack is shared?

The owner of the building where the work is done serves written notice, at least two months ahead, before a projecting chimney breast is cut away. Surveyors are appointed only if the neighbour objects, or 14 days pass with no reply. Questions on the notice go to a party wall surveyor and not to building control.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing