01432 610152 Get a quote Call 01432 610152

Blown ridge tile

A ridge tile has blown off: what now?

A ridge tile that has blown off leaves the top of the roof open. Keep off the roof, photograph the gap from the ground and get the whole line checked.

In brief

Stay on the ground. Photograph the gap and any tile that fell, watch the loft and ceilings for drips, and give your insurer a call, and wait for its reply before permanent work goes ahead. The ridge is the line at the top where the slopes meet, finished with capping tiles that are set in mortar or clipped down with dry-fix fittings. A refit only holds if the tiles beside it are sound, so the whole run is checked, not just the gap.

What has failed when a ridge tile comes off

Ridge tiles cap the apex of the roof, over the point where two slopes meet. On an older roof they sit in a strip of mortar, which weathers and cracks as the years pass. A newer roof may carry dry-fix fittings instead, a clip-and-screw system covered by BS 8612.

Wind reaches the ridge before anything else, because it stands highest on the house, with nothing above it for shelter. A tile comes away when the mortar underneath has already let go, or when a fixing has worked loose. The tile you find on the path may have been sitting on a failed bed for a while.

Marley, the tile maker, says that since the 2015 amendments to BS 5534, a mortar bed cannot be the only thing holding a covering in place. Marley adds that fixing to BS 5534 is not a legal requirement, and mortar has not been outlawed. Even so, a ridge refitted in mortar alone is the weaker choice, so we add a mechanical fixing where the roof allows one and match the new tile to its neighbours.

What to do today, and what to leave alone

A ridge sits at the very top, which is the worst place to be on a wet or windy day. Leave the climbing to a roofer who brings the right access. Plenty can be done while standing on the ground or in the loft:

  • photograph the gap, the ridge tiles either side of it and the fallen tile if it landed in the garden
  • check the ceilings and the loft for drips, damp insulation or a stain that is spreading
  • put a bucket or towels under any drip and move belongings clear
  • tell the insurer what has happened, hold off on permanent work until it has replied, and keep the receipts
  • stop children and pets from using the area under the ridge until the debris has been picked up

Our page on photos of roof damage for an insurer lists the shots to take. A storm need not mean a gale: the Financial Ombudsman Service treats rain, hail or snow arriving without strong wind as capable of being a storm, so the damage is not only a high-wind matter. The first thing we do on arrival is look along the whole ridge, since one lost tile can point to a weakened bed.

How we mend the line, and what the figures say

On the survey we walk the whole ridge, not just the gap, and photograph what we find. Each tile along the run is tested for movement under the hand. The missing tile is replaced to match, and any loose neighbour is rebedded or fixed mechanically as well. The hip ends and the verge end of the ridge get a look too, because a gap there lets the wind under the first tile of the slope.

The price depends on how much of the line has to be rebedded, whether the tile can be matched, and how the roof is reached. Checkatrade's June 2026 guide gives ridge tile repairs at £50 to £70 per metre, excluding VAT. Please do not turn a per-metre rate into a total for your own ridge. The other published guides below show where typical bands sit, and none is our price:

Published UK ridge repair figures
JobRangeSource
New ridge tile£80 to £300Which?, November 2025, excluding VAT
Ridge tile replacementan average of £225 to £550MyJobQuote, 2026

The sources fix the unit of each figure, and the quote that comes after our survey is a single total.

How the rules differ across the border

A ridge repair is small work and sits well inside the limits for re-roofing approval. England uses the Planning Portal's pair of limits: under 25 per cent of the building envelope and under 50 per cent of the roof. A repair inside both normally goes ahead without an application. In Wales, the Welsh Government says work on more than 25 per cent of the roof area brings approval in.

A listed house is a separate question: ask the council before any work, even a like-for-like repair. In England, listed building consent comes under section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990. In Wales it comes under sections 88 and 89 of the Historic Environment (Wales) Act 2023.

If the ridge is part of a wider fault, the repair may become a larger job, and our page on ridge and verge repairs explains how that is judged. For a leak that shows only when the wind blows, see why a roof leaks only in the wind. Everything for repairs sits under roof repairs.

Related questions

Should I cover the gap with a tarpaulin myself?

Not from the roof. Fixing a sheet at ridge height means climbing a pitched roof, and a badly fixed sheet blows off and does more harm. Use buckets and towels inside, photograph the gap, and have someone with proper access cover it. Our page on how long a tarpaulin can stay on explains the limits.

Is one blown ridge tile worth telling my insurer about?

It can be. The sensible order is to photograph the damage, let the insurer know before permanent work is arranged, and keep your receipts. Whether the policy responds is the insurer's decision, and the Financial Ombudsman Service weighs the earlier condition of the roof, so older pictures of the ridge help too.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing