01432 610152 Get a quote Call 01432 610152

Leak tracing

Finding a roof leak: how we trace water from the ceiling to the roof

Finding a roof leak means working back from the mark on the ceiling to the gap on the roof. This guide sets out the order we follow: loft first, then the skyline, then the slopes.

Horizon Roofing Hereford 10 min read

Finding a roof leak starts with treating the wet patch on the ceiling as a clue rather than an answer. Rain that gets past a tile or slate lands on the underlay, the sheet or felt laid under the battens, and runs downhill along it. It can follow a rafter, drip off a batten nail or soak along a timber before it ever reaches plaster. By the time it shows as a brown ring in a bedroom, it may have travelled some distance from the gap that let it in.

So we work in a fixed order. We ask when the water appears, we look in the loft with a torch, and then we go up and check the roof from the top down: the ridge, the verges, the chimney and the valleys before the open slopes, the eaves and the gutters. Each fault we find is photographed and shown to you, on your own roof, before anything is agreed.

The sections below follow that order. They also cover what you can safely check yourself, what changes on each side of the border once a repair grows into something larger, and what to do if water is coming through right now. For the full range of repair work, see our roof repairs page.

Start with when the water shows, not where

Before anyone climbs a ladder, the timing of a leak narrows the search. A drip that appears in any shower points to an open gap: a cracked tile, a slipped slate or a split in a flat roof. A drip that appears only when rain is driven hard against one side of the house points to that side's verge, chimney or flashing, where wind can push water sideways under a lap. A stain that grows after a long wet spell, with nothing during short showers, can mean water soaking slowly through old mortar or porous stone.

Some marks are not leaks at all. Damp that shows on cold mornings, on the underside of the covering or around the loft hatch, with no rain involved, can be condensation from warm air rising out of the house. Our guide to telling condensation from a roof leak deals with that question in full.

If you can, keep a short note for a week or two before we visit:

  • the date and time the drip or stain appeared
  • whether it was steady rain, a gusty storm, melting snow or a dry day
  • which way the wind was blowing, if you know
  • whether the mark grew, dried out or moved along the ceiling
  • photos of the ceiling, with a coin or ruler in shot for scale

That note can shorten the survey, because it tells us which part of the roof to reach first and which conditions to look for when we get there.

Inside the loft with a torch

The loft is where the route of the water is easiest to read. We go up with a strong torch and step only on the joists or on boarded areas, never on the bare plasterboard between them. From the hatch we work towards the part of the roof above the stain, then keep going uphill, because water runs down the slope and the gap that let it in sits higher than the point where it dripped.

What we look for up there:

  • tide marks, the dark rings left on rafters and battens as wet timber dries
  • damp or stained underlay, or old felt that has torn and sagged between rafters
  • daylight showing through, which marks an open gap in the covering
  • wet or flattened insulation directly under a drip
  • rusted nails, or rust on metal straps around a chimney breast
  • wall plate timber, the length lying across the head of the wall beneath the rafters, that has gone soft or dark

Some older houses around Hereford have no underlay at all. From the loft you see the underside of the tiles or stone directly, sometimes with torching, a lime mortar pointing between the battens. With nothing in the way, a wet mark on a batten sits close to the fault, which makes tracing simpler.

We photograph each mark and count the rafters from the nearest gable wall or chimney, so the same spot can be found again from outside on the roof.

Up at the skyline: ridge, verge, chimney and valleys

Outside, the survey starts along the roof's top line and moves down. The ridge runs along the apex under its capping tiles, and the verge finishes the roof where a gable wall rises beside it. A valley is the internal gutter formed by two slopes meeting, and it is lined with lead, GRP or tiles. Around a chimney, lead flashings and soakers (small folded lead pieces under each tile course) seal the joint, and the flaunching is the mortar collar holding the pots on top of the stack.

These are the places where one material meets another, so they hold the joints a leak can use. Ridges and verges set only in mortar deserve a close look: Marley notes that since the 2015 amendments to BS 5534, mortar "could no longer be relied upon as the only means of securing the roof covering". On the black-and-white timber-framed houses, the county's building stone atlas describes the large external stacks as "commonly of local sandstone", and the joint where that stone meets the roof needs checking along its full length.

Where the water shows, and where we look first
Where it shows insideWhat we check on the roof
Chimney breast, upstairsFlashings, soakers, flaunching and pointing
Top of a gable wallVerge mortar or dry verge caps
High on a ceiling, mid-roofRidge tiles and their bedding
Where two roofs joinThe valley lining and its cut tiles

Where a lower roof runs into a house wall, the abutment flashing takes the place of a valley. Our guide to leaks where a roof meets a wall covers those joints.

Down the slopes to the eaves, gutters and flat roofs

With the skyline checked, we move down the open slopes. On a tiled roof we look for cracked, slipped or missing tiles, and for tiles lifting where a nail has corroded through or where a nib, the lug on the back that hooks over the batten, has snapped. On slate we look for slates slid out of line, cracked across, or held by a tingle, a lead or copper clip, that has since opened. Local sandstone tilestones cover Herefordshire's traditional stone roofs, and SPAB observes that on Welsh slate and stone roofs the courses "are predominantly double-lapped", so one displaced stone can open a path that is hard to spot from the garden.

Down at the eaves, water running down the underlay should drop into the gutter. If the underlay has rotted back or the gutter is blocked, it can run onto the wall top and show as damp high on an outside wall or above a window. Gutters need a fall to drain, and Brett Martin gives "1mm for every 600mm". An overflowing gutter can look like a roof leak from inside.

Flat roofs over extensions, garages and dormers get their own check:

  • splits, blisters or open seams in felt, EPDM rubber or GRP fibreglass
  • standing water after rain; NFRC says BS 6229:2025 sets "a minimum 1:80 finished fall"
  • the upstand, the point where the membrane rises against a wall, and the flashing over it
  • the edge trims, and the outlet or gutter the roof drains into

From the ground, with binoculars if you have them, you can look for slipped pieces, mortar in the gutter or lead that has lifted, without going up a ladder.

Proving the cause before anything is fixed

When a fault is plain, such as a slate on the lawn and a matching gap on the roof, the photograph of it is the proof. When it is not, we test. We run water gently over one small area at a time, starting low on the slope and working upwards, while someone watches the loft or the ceiling. When the drip starts, the last area wetted is the one to open up. A hose on a gentle setting is enough, and Marley rules out high powered jet washes on slates or tiles, calling them "not recommended".

You then see the photos of what we found and where it sits, and the repair comes as one written total price. When a repair is the right buy, that is what we recommend. When the covering is failing across a whole slope, we show you the evidence and explain why patching would not last.

If a repair turns into re-covering, which country the house stands in decides the rules:

  • In England, the Planning Portal says no Building Regulations application is normally needed where "Less than 25 per cent of the total 'building envelope'" and "Less than 50 per cent of the roof" is affected.
  • In England, the Planning Portal says approval is needed for a new covering that adds weight "by 15 per cent or more".
  • In Wales, the Welsh Government says of re-roofing: "In most situations, this work will need Building Regulations approval."

Before work of that size starts, we check with building control on the correct side of the border, either the council or a registered building control approver.

If water is coming through right now

A leak during a storm is a different job from a slow stain, and the first steps are yours to take safely from inside:

  1. Move belongings, and put a bucket under the drip. If a ceiling is bulging with water, keep people out of that room and switch off the lighting circuit for it at the consumer unit.
  2. Take photos of the ceiling, the loft and anything visible outside before anything is moved. The Financial Ombudsman Service says that it usually looks at expert reports, along with photos showing a property's condition.
  3. Let your insurer know before permanent repairs are arranged, and keep receipts for any temporary work.
  4. Keep clear of the roof and of ladders. Our guide to making a roof safe after damage explains tarpaulins and temporary covers.

On the weather itself, the Financial Ombudsman Service says "a storm usually involves violent winds, usually with rain, hail or snow", and that "Rain, hail or snowfall by itself can constitute a storm". Whether a claim is covered is for your insurer and your policy to settle.

As a rough guide to cost, Which? (November 2025 survey, ex VAT) puts the job of replacing from one up to six standard tiles that are broken or missing at £75 to £400. MyJobQuote gives an average roof repair of around £650 in 2026, and an emergency call-out at £150 to £300.

On cancelling: when the contract is signed at home following the survey, the cancellation period is 14 days, and you can ask in writing for work to start sooner. Where you ask for an urgent repair visit, there is no cancellation right, under regulation 28(1)(e) of the Consumer Contracts Regulations 2013.

Tracing a leak: your questions

Can a roof leak show up some way from the actual fault?

Yes. Water that gets past the covering lands on the underlay or the timbers and runs downhill before it drips, so the stain can sit well below or to one side of the gap. That is why we follow the marks uphill in the loft first, then check the matching part of the roof from outside.

Is it safe to look in my own loft while it is raining?

It can be, if you take care. Use a torch, step only on joists or boards, and keep clear of wiring and any sagging, wet plasterboard. Look and photograph rather than touch. If water is pooling on a ceiling below, leave the loft, keep people out of that room and call us.

Will one survey visit find where the leak is coming from?

Where the fault is visible, such as a slipped slate or lifted flashing, yes. Where it hides under a lap or behind a joint, we may need a water test or to lift a few tiles, which we explain and agree with you first. Either way you see the photos and get one written total price.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing