01432 610152 Get a quote Call 01432 610152

Roof washing risks

Pressure washing a roof: why Marley does not recommend it

A high-powered jet looks like the quick way to clear moss, yet Marley, a roof tile maker, advises against it. This guide explains the risk and what to ask a roofer for instead.

Horizon Roofing Hereford 9 min read

A pressure washer clears green growth from a patio in minutes, so it is natural to wonder about the roof, but the roof is not a patio. Its tiles and slates are thin, they overlap, and each one has a face that has been weathering since the day it was fixed. Marley is plain about high powered jet washes: they are "not recommended", because the face of a slate or tile can be harmed and its expected life cut "considerably". That last word describes a shorter life for the covering, a larger matter than a mark that rinses away.

Cost guides still list pressure washing among cleaning methods, although Marley does not recommend it, so you may meet it in a quote. This guide sets out what the damage means for a covering you expect to keep for decades, why a roof that looks clean can have lost something, which other risks sit on the same roof, and how a roof is cleaned without a jet. When a rule changes at the border, the sentence names the side.

The wider picture is on our roof cleaning and moss removal page. The sections below follow the order we would work in: the covering, the cost, the creatures and the water, then what to ask for.

What a jet does to a weathered tile or slate

A concrete tile, a clay tile and a natural slate each carry a surface that has spent years in the open, and Marley's concern is that surface. It does not say a washed roof will fail next winter, and nothing here claims that. Its point is narrower: a high powered jet can mark the face of the slate or tile, and the expected life of the covering suffers as a result. Because the harm is to the surface and not to the structure, a roof can look cleaner on the afternoon of the wash and still have a shorter future ahead of it, which is why the method is worth settling before the work begins.

Covering lifespans are typical ranges and never promises, but they show what is at stake when a method takes years off them:

Typical lifespans as published, and who gives them
CoveringTypical lifespanPublished by
Concrete tileAround 60 yearsMarley
Plain concrete tile40 to 50 yearsHomeBuilding
Clay tileA minimum life expectancy of 60 years, set by the BREMarley, for clay only
Welsh slate100+ yearsHomeBuilding
A well-slated roof"likely to be more than 100 years"SPAB

Each figure describes a covering that is intact and looked after. A method that damages the surface cuts into it from the first wash. None of this means a roof has to stay green. It means the choice of method matters more than the speed of the job, and the usual alternative is explained in our guide to what soft washing a roof means.

Why a quick, cheap-looking clean can cost more later

Cleaning prices are published per square metre, and they vary with the method. For roof cleaning in the UK, Checkatrade's April 2026 guide gives £8.50 to £14 per m², and its hand removal and biocide treatment line is around £11.50 per m². These are rates per m², so they say nothing about the total for any one house, and nobody should turn them into a total by guessing at the area. The same guide lists pressure washing among its methods, the very method Marley does not recommend on slates and tiles.

Now look at the far end of the scale. Which? (November 2025 survey, ex VAT) prices a handful of replacement tiles, from one to six, at £75 to £400, while a complete new roof on their average three-bedroom house comes to £7,000 to £21,000. HomeBuilding (30 September 2025) puts the plain concrete tile version at £10,000 to £15,000 for a 65 m² semi and says Welsh slate could take the figure to £18,000. MyJobQuote's page of 3 November 2026 offers an average of around £5,250 for a new roof. Treat every one of these as background, since only a survey of your roof produces a price.

Marley's word for the lost life is "considerably", and a method that shortens it brings the day of the re-roof closer. A quote should therefore name the method, so that two quotes can be compared on the same footing. Ours comes after a survey as one written total price, and it states the cleaning method.

Fragile roofs, nests and roosts

Some roofs should not be blasted or walked on, whatever the covering looks like. HSE (guidance A14) classes every asbestos cement roof as fragile, and its advice for any property dating from before 2000, or refurbished before then, is to assume that asbestos is present. A cement sheet roof from that period has to be identified before any cleaning method is chosen, and our guide to moss on an asbestos cement roof covers that route.

Roofs also have residents. The two statutes below cover both countries, and only the licensing body changes at the border:

  • Section 1 of the Wildlife and Countryside Act 1981 covers a nest in use or being built, whenever someone intentionally damages it.
  • For bats, regulation 43 of the Habitats Regulations 2017 goes wider, because a roost can be harmed without any intent.
  • Whoever licenses work near bats depends on the border: Natural England in England, Natural Resources Wales in Wales.

The gaps at the eaves, ridge and verge are places where a nest or a roost can sit, and any method that sprays or lifts material at those gaps can reach it. If bats are known or suspected, stop before any cleaning begins and put the question to Natural England (England) or Natural Resources Wales (Wales).

Nothing on the roof announces a roost from the ground, so the question about one belongs in the survey and not in the middle of the job.

Where the water and the loosened growth end up

A jet throws water in every direction and carries the loosened moss, lichen and grit with it. The debris lands on paths, windows and cars, in the beds below, and above all in the gutters and downpipes. A gutter has only a slight fall to carry things away; Brett Martin gives "1mm for every 600mm", so a gutter loaded with flushed moss has little slope to help it clear. Valleys take the same load. A valley is the sunken channel between two slopes, lined with lead, GRP or tiles, and a clean that sends moss into it has to end with the valley being cleared. Our guide to moss in gutters and valleys explains the blockages that follow.

Before any method is agreed, a clean needs a plan for the material it removes. These are the points we put in writing:

  • where the moss will land, and who collects it
  • how gutters, downpipes and valleys are cleared at the end
  • how plants, windows, cars and a neighbour's boundary are protected
  • what happens to the rinse water and to anything applied to the roof
  • photographs of the roof before and after, taken from the same positions

A plan of this kind slows the job a little. It also stops a roof clean from turning into a gutter repair a few weeks later, which is a poor trade for anyone who paid for the first.

If a firm cannot say where the debris goes, the plan has not been made yet, and it is better to hear that before the day than during it.

What to ask for instead of a jet

The usual alternatives start with the hand. Moss and lichen are lifted off the covering with brushes and scrapers, then a treatment is applied to slow regrowth. Checkatrade lists "hand-removal and biocide treatment" as a method in its own right. A biocide is a product that kills living growth, and the choice of one depends on the covering, the position of the roof and the plants and water around the house. Soft washing applies the treatment with low-pressure water rather than a jet. It has a guide of its own, linked above, with the detail of how it is done.

The method follows the roof. A worn clay tile, a thin old slate, a sandstone tilestone and a cement sheet each call for a different decision, which is why the method is chosen after a survey and not before one. At the survey we photograph slipped, cracked or lifted pieces so that repairs can be agreed ahead of the clean, and you are shown the pictures taken on your own roof.

If another firm proposes anything that involves pressure, ask for four things to be written into the quote:

  1. the pressure, the nozzle and the working distance
  2. the covering it will be used on, and why it suits that covering
  3. what is done about loose or cracked pieces before any water is applied
  4. who clears the gutters and the valleys afterwards

A firm that is comfortable with a jet on your roof will have answers to all four. A firm that is not will say so, and the quote tells you which one you are dealing with.

When cleaning shows that the roof needs more

Cleaning sometimes shows that the covering underneath has failed in places, and a repair can then grow into a larger re-cover. Here the two sides of the border part company:

  • In England, the Planning Portal gives a two-part re-roofing test. A job that touches "Less than 25 per cent of the total 'building envelope'" and "Less than 50 per cent of the roof" normally requires no application. It also asks for approval when a replacement covering adds weight "by 15 per cent or more".
  • In Wales, the Welsh Government says of re-roofing: "In most situations, this work will need Building Regulations approval."

For a repair on that scale we confirm with building control, meaning the council's service or a registered building control approver, which of the two rules governs your address before the first tile is lifted.

On the paperwork, signing at home straight after a survey still leaves you 14 days to cancel under the Consumer Contracts Regulations 2013, and work can start sooner only on a written request from you. No cancellation right applies to an urgent repair visit that you request, under regulation 28(1)(e). If a contract goes wrong, the Citizens Advice consumer helpline is 0808 223 1133, and for Welsh-language help it runs 0808 223 1144.

A repair is the right buy when the covering is sound and only a few pieces have failed. Replacement is offered only when the evidence on your roof points that way.

Roof washing: your questions

Does a lower pressure setting make a roof wash safe?

Marley's advice is not to use high powered jet washes on a roof of slate or tile. If a firm proposes anything that uses pressure, ask for the pressure, nozzle and working distance to be written into the quote. If it cannot say, ask for hand removal and a low-pressure treatment instead, and compare the two on one written total price.

Who do I ask if bats may be in the loft before a clean?

Bat licences come from Natural England for an address in England and from Natural Resources Wales for an address in Wales, so ask the matching body before any cleaning starts. A bird's nest in use or being built is covered too, by the Wildlife and Countryside Act 1981, so mention any you have seen at the eaves.

How do I compare a quote that uses a jet with a hand-clean quote?

Compare the stated method, the plan for the gutters and the debris, and the total price in writing. A published rate per m² is background, not a quote for your roof, and should never be multiplied by a guessed area. A quote that names no method has left out the part that decides the result.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing