Green moss and grey lichen on corrugated sheeting look like a job for a stiff brush. On an asbestos cement roof, that instinct is the one to resist. Garages, sheds, porches and farm buildings from the last century were roofed in sheets made from cement and asbestos fibre, and the HSE's guidance note A14 puts the position in four words: "AC roofs are always fragile". A sheet may look sound and still give way underfoot, and moss hides the cracks that would warn you.
So we start from the survey rather than from a cleaning method. We look at what the sheets are, how weathered they are, whether any are cracked or broken, and how anyone could reach them without standing on them. Only then do we say whether cleaning is sensible, whether the roof should be left alone and watched, or whether the straight answer is to replace the covering.
This page follows that order and flags where England and Wales part company. It sits under our roof cleaning and moss removal service, and it deals only with sheet roofs, not tiles or slate.
Why a mossy sheet roof is a different job
On a tiled roof, moss is a plant sitting on a hard, sound covering, and the choice of cleaning method is about protecting the tile surface. On a roof of asbestos cement sheets, the covering itself is the hazard. The HSE's advice for a building built or refurbished before 2000 is to presume asbestos is present. A garage, lean-to, workshop or barn from that period, roofed in grey corrugated sheet, belongs in that category until a survey shows otherwise.
Two things follow from that. The first is that moss and lichen on such a roof are a reason to look carefully, not a reason to scrub. A green sheet has been out in the weather for a long time, and weathering is the very condition the HSE addresses when it describes asbestos cement "which is weathered but not otherwise substantially damaged".
The second is the fragility. Moss grows over the sheet laps, the bolt heads and the lines of the purlins, the timber or steel rails the sheets rest on. Those are the places a sheet is weakest, and the moss hides them. A mossy roof can look uniform and solid from the ground while concealing a hairline crack beside a fixing.
The first question we ask about a mossy sheet roof is therefore not how to clean it. It is what the sheets are, what condition they are in, and how the surface can be reached without anyone putting a foot on it.
How the HSE sorts the work
The HSE sorts asbestos work into categories, and the category depends on the condition of the material and on what is done to it. Its page on non-licensed work lists asbestos cement products, "eg roof sheeting and rainwater goods", "provided the material is carefully handled/removed without breaking up". The same page lists maintenance work on asbestos cement products on roof sheeting, tiles and rainwater goods.
The notifiable category covers the rougher end of the same material. The HSE's page on notifiable non-licensed work names asbestos cement "where the material has been substantially damaged or broken up (eg as a result of fire or flood damage)", and removal that "will mean that the material will be substantially broken up, creating significant quantities of dust and debris (eg 'dropping' an asbestos cement roof)".
| Condition or task | HSE category |
|---|---|
| Weathered sheets, handled whole | Non-licensed work |
| Sheets substantially damaged or broken up | Notifiable non-licensed work |
| Dropping a roof so it shatters | Notifiable non-licensed work |
| Soffits of white insulating board at the eaves | Licensed work in most cases |
For a mossy roof this means how the work is done counts for as much as the outcome. Anything that chips, cracks or crumbles a sheet while taking moss off can push the job from the first row towards the second. Where the roofline carries insulating board soffits, removal is licensed work in most cases, and a licensed firm takes on the soffit work.
Reaching the sheets without standing on them
Because the HSE calls these roofs fragile, access is planned before the method is. A person kneeling on a sheet, or stepping from one purlin line to the next with moss underfoot, is the risk the guidance is written about. Moss also makes the surface slippery after rain, which adds a second hazard to the first.
At a survey on a sheet roof we work from the ground and from safe positions, and we photograph what can be seen:
- sheets that are cracked, holed or sagging between the purlins
- sheet edges and laps where moss has built up thickly
- bolt and screw heads, and whether any have rusted or pulled through
- rooflights in the same plane, because a rooflight panel can be weaker than the sheet beside it
- gutters and downpipes, which may themselves be made of asbestos cement
Our guide to safe access for roof cleaning sets out the general options for reaching a roof, from ladders to platforms. On a sheet roof, the sensible choice is the one that keeps weight off the covering altogether. If no such option exists on a particular building, that finding is itself the result of the survey, and the next step is a conversation about what to do with the roof, not about how to get a brush onto it.
A roof of sheets that has gone green on the north slope and stayed clean on the south is telling you where water lingers. We note it, and we leave the moss exactly where it is until the decision is made. A photograph taken from the ground with a zoom can show more than a close look would, because the whole pattern of staining appears at once.
What the survey decides: leave, treat or replace
With the sheets photographed and their condition recorded, the choice can be one of three, and we put it to you in writing with one total price for whichever you pick.
- Leave it and monitor. If the sheets are whole and the moss is thin, doing nothing to the surface can be the right answer. Moss on a sound sheet is an appearance question, and a repeat look in a year costs less than a clean that cracks a sheet.
- Treat from a safe position. Where the building allows access without loading the sheets, a surface treatment can be applied and left to work. This is a decision to make with the survey photographs in hand, and the method is agreed before anyone starts.
- Replace the covering. Where sheets are cracked, sagging or breaking, the choice is to take them off whole and fit a new covering. That is removal, not cleaning, and it brings in the waste rules below.
None of these is chosen to create work. A new covering is proposed only when the sheets leave no better choice, and the photographs of your own roof are how you judge that for yourself.
Moss is not the only reason for a sheet roof to be failing. Old fixings, thermal movement and age all matter, and a sheet that is sound but covered in lichen is a very different case from one that is split along a rib. The survey tells those apart, which a brush cannot.
Whichever route you choose, the written price names the method, says what happens to the waste and shows whether the sum covers VAT and any scaffold.
Waste, skips and the line between England and Wales
If sheets come off, the waste is hazardous and its route is regulated. HSE guidance on skips is plain that asbestos belongs in a lockable skip, and that "It is not good enough to throw sheeting over a standard skip". An open skip is never the answer.
Paperwork for the waste changes once you cross the border. In England, GOV.UK guidance exempts moving domestic hazardous waste "(other than asbestos waste)" from a household, so asbestos sits outside that exemption. In Wales, Natural Resources Wales says "contractors moving asbestos from a domestic property will need to use consignment notes", and the NRW fee for registering a new upper tier carrier is £184.
Householders taking a small amount themselves have council routes, and these are not the same on each side:
- In England, Herefordshire residents can book a slot at the Hereford or Leominster recycling centre, provided the asbestos is sealed inside two bags or plastic sheeting.
- In Wales, Monmouthshire residents can book a slot at Five Lanes or Llanfoist for small householder amounts. Mitchel Troy is not an option for asbestos.
- In Powys, ask the council which centre accepts asbestos before you load anything.
When a contractor lifts the sheets, the waste is classed as trade waste and must be accompanied by a consignment note, which is a different route from the householder one. Ask any firm that quotes for removal how the sheets will leave your site and where they will go.
Costs and the order to make decisions in
Published cost guides separate removal from cleaning, and for sheet roofs it is removal that gets a figure. MyJobQuote gives asbestos roof removal as "around £2,750" for the UK, and a 20 m² garage roof, with survey and removal, as "around £1,200". Those are MyJobQuote's typical ranges, not our prices, and neither is specific to Hereford. The area, the access, the number of broken sheets, the route for the waste and the new covering decide the figure on a real building.
The order we suggest is simple. Treat the building as one that contains asbestos if it was built or refurbished before 2000. Have the sheets surveyed and photographed from safe positions. Decide whether to leave, treat or replace. Only then ask for a written price, and check that it names how the waste leaves site and shows whether the sum covers VAT and any scaffold.
If you are weighing a clean against a replacement, the answer can depend on the sheets rather than the moss. For comparison with other coverings, our guide to jet washing a roof explains why it is not suited to tile or slate, and suits fragile sheets even less. Our guide to roof cleaning and bats covers roosts, which can sit under any covering, sheets included. Natural England handles bat licences in England, and Natural Resources Wales does so in Wales.
The HSE's words on fragility are plain, so the survey is where a sheet-roof job starts and, for some roofs, where it ends.
