Any green or dark patch on a roof tends to get called moss. The three growths are different living things, and they behave differently on a tile, a slate or a stone slab. Moss is a plant with tiny stems and leaves. Algae is a thin film of single-celled organisms that stains the surface. Lichen is a partnership between a fungus and an alga, and it forms a crust that grips the covering. Telling them apart matters, because the method that suits one can be wrong for another.
It also matters because the growth is a clue about the roof. A moss mat on a shaded slope points to a damp spot. A streak of algae below a ridge can mark where water runs. A crust of lichen on an old stone slab may be a harmless part of the roof's character. We read those clues at a survey before we suggest any treatment.
This guide belongs to our roof cleaning and moss removal service. It covers identification, causes and effects, then the rules about nests and bats that apply in England and in Wales before any of it is disturbed.
Three living things, one roof
Moss grows as a cushion or a carpet. It is green to brown, soft to the touch, and it holds a surprising amount of water after rain. It roots shallowly into the tiny crevices of a surface and into the dust and leaf litter that settles in the gaps between courses of tiles.
Algae shows as black, dark green or brown streaks that run down a slope in the line of water flow. It has no thickness you can lift, and it is a stain rather than a mat. It does not hold water the way a moss cushion does.
Lichen is the grey, white, yellow or orange crust, round or leafy, that sits tight to the surface. It grows slowly. Because a fungus is part of it, it anchors itself into the face of the covering, and removing it forcibly can take some of the surface with it.
- Moss: raised, soft, holds water, roots into debris
- Algae: flat, dark, stains the surface, spreads along damp lines
- Lichen: crusty, slow, grips the face of the covering
A single tile can carry all three: a lichen crust at its centre, algae streaking from its lower edge, and a moss tuft packed into the gap below. Each deserves its own look rather than a single spray across the slope. Looking at the same slope from the same spot at the same time of day, month after month, is the quickest way to learn which of the three is spreading and which is holding still.
Our guide to whether lichen should be removed look at the dark staining and the crust in more detail.
How to tell them apart from the ground
You can tell a lot from the garden with a pair of binoculars and a dry afternoon. The table below sets out what to look for, and the right-hand column says what it suggests about the roof.
| Growth | What you see | What it can suggest |
|---|---|---|
| Moss | Raised green or brown cushions | A damp, shaded or debris-holding spot |
| Algae | Flat black or dark green streaks | Water running down that line |
| Lichen | Grey, white or orange crust, tight to the surface | A slow-growing patch on a covering that has stood a long time |
Where you find moss in thick cushions, ask what is holding the water. The usual answers are an overhanging tree, a chimney that shades the slope, a valley that is slow to drain, or a gutter that spills onto the roof edge. Where you find streaks, look above them for the source, because a leaking gutter joint or a ridge that sheds water onto one line will leave a stripe.
None of this is a diagnosis. It narrows the questions for the survey. Our guide to why moss grows on the north side goes into the effect of aspect and sun on a roof.
If a patch looks like a stain but feels raised, or a crust comes away in flakes of the covering itself, stop and have the roof looked at. That is the covering failing, not the growth. Ask for the survey photographs before agreeing to any treatment, so that you can see which of the three you are paying to deal with.
Why each one takes hold
All three need damp and a surface that will keep a little of it. What differs is the pattern, and the pattern tells you where to act.
- Shade from trees, a neighbouring building or a tall chimney keeps a slope wet for longer, which favours moss and algae.
- Leaf litter and grit in the gaps between tiles hold water and give moss somewhere to root.
- A rough, porous surface, which an old roof can have, holds growth more easily than a smooth one.
- Slow drainage, from a low pitch, a flat spot or a blocked valley, leaves water standing on the covering.
- Run-off from a defective gutter or flashing paints a stripe of damp down the same line every rain.
Lichen is slower and tolerates dry spells better than moss. On an old roof it can settle in the places that stay stable for years. Algae spreads wherever there is a film of moisture and a little organic dust.
The point of reading these causes is that cleaning on its own does not remove them. Growth that returns after a clean has a cause that was left in place, such as an overhanging branch or a gutter that overflows. Our guide to whether moss will grow back deals with that directly.
We list the likely causes in the survey notes, with photographs, so that the quote reflects what is causing the growth, not only how it looks. A branch that can be cut back, a gutter joint that can be resealed or a valley that can be cleared costs less than cleaning the same roof every few seasons.
What the growth does to the covering
The effect depends on the covering and on the growth. We describe what we look for on your roof, and the survey says in plain words whether the growth there is doing harm.
Moss is the one we watch most closely. A thick cushion holds water against the covering, blocks the gap between courses, and can lift a tile or slate at its edge as it grows. In a valley or against a chimney it can send water sideways, away from where the roof was designed to shed it.
Algae is mainly a staining issue on a sound covering. It darkens the roof and signals damp, but it does not build up in layers. The bigger risk to the surface comes from the removal method rather than the algae, so the method is picked at the survey.
Lichen on a sound covering is a slow cosmetic matter. On a worn face, the crust can be holding together surface that would otherwise flake, so pulling it off is not a neutral act.
What we check beneath it
What we do at a survey is check three things beneath the growth: whether the covering is cracked or porous, whether the fixings are sound, and whether moss has begun to lift any edge. Photographs go to you, taken on your own roof. Our guide to whether moss damages roof tiles covers that last question.
Older roofs and local materials
Stone roofing in Herefordshire draws on local sandstone, and for tilestones the atlas credits the St Maughans sandstones. SPAB's technical note for the region calls such roofs "predominantly double-lapped", which means each slab or slate overlaps the courses below it.
A stone or slate roof of that kind needs a gentler approach than a modern concrete tile, for two reasons:
- stone slabs can be thick, heavy and brittle at the edges, and a sweep or a boot can crack one
- the growth on them may have been there a long time, and lifting it can take some of the stone's weathered face
Clay plain tiles on older houses raise the same questions, and our own guide to cleaning old clay tiles goes into them. We make no assumption about what a street or village carries, so each roof is looked at as it is. We read each roof, record the covering, and choose the method to suit it.
For a listed house the consent route depends on the country. In England, listed building control rests on section 7 of the Planning (Listed Buildings and Conservation Areas) Act 1990. In Wales, it is the Historic Environment (Wales) Act 2023, sections 88 and 89. Ask the council before work on either side, and describe the method you have in mind.
Conservation areas and National Parks add planning questions of their own if a clean leads to different materials going back on. Check with the local planning authority before work starts.
Nests and bats: what the law asks of you
Moss mats and the gaps they fill can hold nests, and bats can use gaps under tiles and in eaves. Before any growth is removed we look for signs of both, and that is a legal matter as well as a courtesy.
Two pieces of law cover this on both sides of the border. Section 1 of the Wildlife and Countryside Act 1981 makes it an offence to intentionally harm a nest that is occupied or still under construction. Section 9(4) of the same Act covers disturbing bats where they shelter when done "intentionally or recklessly". The Habitats Regulations 2017 add that damage to a roost is an offence even without intent (regulation 43).
Licensing is split by country. Natural England is the English body, and GOV.UK names roof repair and replacement among the jobs that may disturb a bat roost. NRW is the Welsh body and expects an application for work touching a protected species. On the day, the rule is simple: where a nest is occupied, that section of roof waits. Our guide to roof cleaning and bats explains the signs to look for and what to do if you find any.
If anything turns up, work in that area stops, we photograph it, and we explain what we saw and who to contact. That record is yours as well as ours, which matters if anyone later asks what was disturbed.
