01432 610152 Get a quote Call 01432 610152

Slate roof cleaning

Cleaning moss off a slate roof without damaging it

A slate roof can last a very long time, and a careless clean can shorten that. This guide covers how to take moss off slate gently, what to check before starting, and what to avoid.

Horizon Roofing Hereford 9 min read

Slate wears well, but each slate is thin and held by only a couple of nails or a hook. That combination is what makes cleaning it a matter of care. A method that suits a hard-wearing surface can chip a slate edge, shift a slate that was already loose or scour the face of a sound one, and a roof built to serve for generations can lose years of its life to a single wash.

This guide takes the job in the order we do it. It starts with why slate asks for a lighter touch, then covers what is checked before any moss is touched, which methods suit the surface, what is kept off it, what follows the clean and what to ask of a firm that offers the work. Where a rule differs between England and Wales, the sentence carries its side.

The aim is a clean slate roof that is still intact. Moss may not be the only thing on the roof that wants attention, so a clean and a check go together. For the wider service, see our roof cleaning and moss removal page.

Why slate needs a lighter touch

A well-kept slate roof is one of the longest-lasting coverings on a house, so protecting it matters more than the speed of a clean. HomeBuilding gives Welsh slate a lifespan of "100+ years", Spanish natural slate "75-100 years" and reclaimed Welsh slate "50-80 years". SPAB, which advises on traditional buildings, says that the life of a well-slated roof is "likely to be more than 100 years". Treat those as typical ranges that assume a roof kept in order, never as promises.

Against that, Marley, a roof tile and slate maker, is blunt about one method. On its technical page the maker marks high powered jets as "not recommended", with surface damage and a much shorter expected life as the reason. Checkatrade, writing about cleaning in general, adds that pressure washing can dislodge tiles, and that moss may return sooner when no treatment follows. It also lists the method among those that suit older or fragile roofs least. Slate is the kind of covering those cautions are aimed at.

What damage looks like on slate:

  • a face that has been scoured, leaving a rough or pale patch
  • chipped or cracked edges at the lower end of a slate
  • slates knocked out of line, which opens a gap in the lap
  • fixings loosened by vibration or by someone stepping on the slope

None of these shows straight away. They show over the following winters, when the roof lets water in at a point that nobody connects with the clean. The safest approach is therefore to treat the first clean as the most careful one.

Checking the slates before anything is cleaned

A moss-covered slate can hide a crack, and moss can be the very thing holding a broken slate in place. Time spent here is cheap, because a defect found now costs less than one found by a wet ceiling. So the first job is a survey, done before any scraping, with photographs of each slope.

We look for:

  • slates that have slipped down from their line
  • cracks across a slate, and corners broken off
  • nail heads or hook fixings that show rust or have let go
  • gaps at the ridge, the verges and around the chimney
  • flashings and valleys that moss has crept into

Fixing matters on slate. Cupa, a slate supplier, rules out hook fixings, where a hook over the batten holds the slate, on any pitch below 25 degrees, so a lower roof is nailed. Of Welsh slate and stone roofs, SPAB observes that they are "predominantly double-lapped", so each slate overlaps the courses beneath it. That layout shelters the joints, and it also means a single slipped slate can expose the course below.

If the survey finds a defect, the repair comes first. Checkatrade's advice is to deal with broken or slipped tiles early, and slates are no exception. Treating or cleaning over an open gap only washes water towards it.

You see the photographs, and the written total covers the clean and any repair in one figure, so nobody asks you to agree extras from halfway up a ladder.

Gentler methods that suit slate

Four cleaning methods are on offer in Checkatrade's list. Two fit a delicate surface better than the others, and a third can be used with care.

Cleaning methods and what is said about them
MethodWhat the description says
Hand removal and biocideGentler on roof tiles than pressure washing; the biocide helps slow regrowth
Soft washingGentler on pressure, with specialist treatments; suits more delicate roofs
Steam cleaningUses heat, not stronger chemicals; can be gentler than pressure washing
Pressure washingCan damage or dislodge tiles; the one to avoid on delicate roofs

On slate, hand removal is where we start. The moss is lifted off by hand tools that are kept flat and light, working with the lap and not against it, so no slate is levered. It is slow, and it is the method that lets the person doing it see and feel each slate as they pass, noticing a loose one before it becomes a fall of slate into the garden.

Soft washing suits a roof where growth is spread thin across a wide area. It keeps the pressure down and relies on the treatment to do the rest. The choice between the two comes down to the amount and thickness of growth, the pitch and the access, and it is made from the survey photographs.

Whichever method is used, the quote should say which, whether a biocide follows, and who clears the gutters afterwards. Our guide to what soft washing means explains the second route in more detail.

What to keep off a slate roof

The list is short, and each item has a reason.

  1. High powered jets. Marley does not recommend them, giving surface damage and a shorter expected life as the reason. The full case against them is set out in a separate guide.
  2. Boots on the slope. Slates are thin and can crack under a foot, so access is by roof ladder, crawling board or platform, which spread the weight and keep feet off the slate.
  3. Hard scrapers and wire brushes: They can scratch or lift the face and edges of the slate. Tools are chosen so they do not dig in.
  4. Strong runoff onto walls and plants. Water from the roof goes into the gutters and downpipes, and the area beneath is covered or cleared first.

A ladder leaned on the lowest slates can break them and bend the gutter, so a stand-off bracket keeps it clear of the roof edge. Where a ladder cannot reach safely, a scaffold or platform goes up. If that scaffold stands on the highway, the Highways Act 1980 section 169 licence applies, and we arrange the licence with our scaffolder.

Checkatrade advises steering clear of harsh methods on delicate roofs, and for slate that is the rule we follow. If a firm proposes anything with a nozzle and high pressure for a slate roof, it is fair to ask for the maker's guidance in writing before agreeing.

After the clean: gutters, nests, bats and the finish

Cleaning shifts debris, and much of it lands in the gutter. Checkatrade points out that the quote may or may not include clearing them. On a slate job the gutter clearing belongs to the work itself, and the waste leaves with us.

Before the work starts, and again as it goes on, we watch for wildlife:

  • Birds: the Wildlife and Countryside Act 1981 section 1 offence turns on someone "intentionally" harming a nest that is in use or being built. An occupied nest holds that stretch of work back.
  • Bats: section 9(4) of the same Act covers acts done "intentionally or recklessly". A licence, if needed, is issued by Natural England for an English house and by Natural Resources Wales for a Welsh one.

Old slate roofs can have gaps beneath the slates where wildlife settles. If anything is seen, work on that area stops while advice is taken.

When the work is done, you get photographs of each slope, taken after the clean, next to the before pictures. Any slate that was replaced is shown, and the new slate is matched for size and colour. Where an exact match is not possible, the repair is set where it will show least.

The photographs also give you a record for next time. A slate roof cleaned with a gentle method and then looked at again in a couple of years is easier to keep in good order than one left until the growth is heavy.

What it costs, and when a clean becomes a repair

In April 2026, Checkatrade put UK roof cleaning at typically "between £8.50 and £14 per m²". It is a spread across methods and materials, neither a Hereford price nor ours, and it is no total: never multiply it by a guessed roof area. The care a slate roof needs can add time to the job.

If the clean shows slates that need replacing, Checkatrade's June 2026 repair rates, ex VAT, for up to 3 m², put natural slate at £150 to £220 per m². Again, that is a per-m² rate, kept in its unit.

What sets the price on a slate roof:

  • the size and pitch of the slopes
  • how thick and how widespread the growth is
  • the method chosen, and whether a treatment follows
  • how the roof is reached, and whether a scaffold is needed
  • whether slates need replacing, and how many

Where the slates are in good order and only the surface needs attention, a clean is the right purchase. Where many are cracked or the fixings have failed across a slope, repair or re-covering is the fairer recommendation, and the photographs make the case.

Should it come to re-covering, the rules differ between the two sides of the border:

  • In England, the Planning Portal sets two limbs, both of which must hold: "Less than 25 per cent of the total 'building envelope'" and "Less than 50 per cent of the roof" affected.
  • In Wales, the Welsh Government says re-roofing "In most situations, this work will need Building Regulations approval."

Before any job on that scale, building control for the property's own side gets asked, whether the council or a registered building control approver.

Cleaning slate: your questions

Can I clean my slate roof myself?

It is not a job we would suggest. Slate can crack underfoot, and working at height without proper access is risky. Checkatrade also warns that a wrong method can damage the roof. From the ground you can look, photograph and arrange a survey, and a gutter clear can be done from a safe position.

Will cleaning remove the green and black staining as well as the moss?

Hand removal takes off the moss itself, and a biocide treatment works on what is left to slow its return. Marks that are in the surface may fade over time and may not clear completely. We tell you what to expect for your roof and show before and after photographs of the same slope.

Why leave high powered jets off slate?

On slate or tile, Marley's line is that high powered jets are not recommended, because the surface can be damaged and the roof's expected life reduced. We keep them off slate. The gentler methods take longer, and they leave the roof sound for the years ahead.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing