01432 610152 Get a quote Call 01432 610152

Gutters and valleys

Moss in gutters and valleys: the blockages it causes

A valley or gutter full of moss stops the roof carrying water away. Here is how the blockage forms, how we check it, and what the rules say about nests and bats.

Horizon Roofing Hereford 9 min read

A roof sheds water in stages. Rain runs down the slopes into valleys, the internal channels where two slopes meet, and along the eaves into the gutters. Both channels carry a great deal of water for their size, and both catch whatever travels with it: moss from the slope above, grit from the tiles, leaves and seeds. Left alone, that debris builds into a mat that holds water in place instead of passing it on.

The result shows up in familiar ways. A gutter spills over the front edge in a heavy shower. A valley overflows onto the tiles beside it. A stain appears on a wall below the eaves, or on the ceiling beside a chimney. The blocked channel can be the cause while the roof covering itself is sound.

This guide sits within our roof cleaning and moss removal service. It takes valleys first, because they are harder to reach and easier to misjudge, then gutters, then the rules and costs that apply on both sides of the border.

How a moss blockage forms in a channel

Moss starts on the slope, where a shaded or slow-draining patch gives it a hold. As it grows it sheds fragments, and each shower washes some of them down into the valley or gutter below. There they meet grit and leaves and settle, because a channel with a gentle fall moves water but not solids.

Once the debris holds moisture, it behaves like soil. Seeds take, moss spreads along the channel, and the mat thickens. The water now has to find a way around the mat, and it takes whichever way is lowest: over the edge of a gutter, or up and under the edge of the tiles that line a valley.

Gutters have one particular requirement that makes a blockage worse. Brett Martin says to fit them with a fall, giving "1mm for every 600mm". That is a small slope, and a mat of moss and silt only a few centimetres deep is enough to cancel it, leaving water to stand in the channel and overflow at the low point.

Valleys have the opposite problem: their fall comes from the roof itself, so they run fast in a storm. A valley that is clear can carry a large volume. One part-blocked by moss can throw water across into the next slope, or back up beneath the tiles that frame it.

  • On a slope: moss and grit start to shed into the channel
  • In a valley: debris packs against the lining and the cut tiles
  • In a gutter: silt cancels the fall and water stands

Whichever channel is involved, we start by photographing it before we touch it, so that you can see what was there.

Valleys: lead, GRP and tile

A valley is lined with one of three things: lead, GRP (glass-reinforced plastic, a fibreglass lining) or tiles cut to form an open or closed channel. What we check depends on the lining.

Lead is the usual choice for a pitched valley gutter on a traditional roof. Royston Lead's cast-lead brochure lists the thicknesses of its sheet by code, with the uses each suits:

Lead codes and their listed uses
UseRoyston lead codes listed
SoakersCode 3 ("Recommended for lead soakers only") and Code 4
FlashingsCodes 4, 5 and 6
Pitched valley gutterCodes 4, 5, 6, 7 and 8

Soakers, the little folded lead pieces that tuck under each course of tiles, are a separate matter from the valley lining itself. MyJobQuote's hedged line on flashings is that lead properly fitted "can last" for over 80 years.

In a valley, we look for four things: lead split along a fold, GRP that has crazed or lifted at its edge, cut tiles that have slipped and left a gap, and moss packed beneath any of these. Moss in a lead valley is not harmless, because it holds water on a metal that is meant to shed it. Our guide to whether moss can cause a roof leak sets out how that happens.

Clearing a valley is slow, careful hand work, because a sharp tool can cut the lining, and a boot on lead can crease it. The work is done kneeling on a board or from a roof ladder, so that weight is spread across the tiles and kept off the lining itself.

Reading the signs from below

You can tell from the ground, or from a bedroom window, that a channel is blocked. The signs are plain once you know what they point to.

  • Water running over the front lip of a gutter in rain, rather than flowing along it to the downpipe
  • Green or black staining on the wall directly below the eaves
  • Plants, such as grass or small weeds, growing along a gutter or in a valley
  • A damp patch on a ceiling or wall near a chimney or where two roofs meet
  • A trickle at a downpipe that runs only after a long delay, or not at all

A stain on an internal wall does not prove the channel is the cause. It may point to a flashing, a slipped tile or a gap in the underlay, and the survey sorts one from another. The leak may start a metre or more from where the damp finally shows.

Overflowing gutters can also mimic a roof leak. Water that runs down the wall behind a gutter can enter the brickwork or timber at the eaves, and show as damp on the inside, high up. We check the gutter and its brackets before we assume the roof has failed.

If you find a blocked channel after a storm, keep off the ladder if it is wet, and photograph the problem from the ground. Tell your insurer before permanent repairs if damage has resulted, and keep receipts for any temporary work. Our guide to gutters during a roof clean sets out what is normally included.

Clearing a gutter or valley without making it worse

The method is simple, and the order matters. We clear from the top downward, because a gutter cleared before the roof above it is cleaned just fills again.

  1. Remove the moss and debris from the slope above by hand, working towards the channel.
  2. Lift the loose material out of the valley or gutter by hand and bag it, rather than flushing it towards the downpipe.
  3. Check the outlet and the first run of the downpipe, because a plug there will back the water up again.
  4. Run water through the channel to confirm it drains, watching for leaks at joints and brackets.
  5. Photograph the cleared channel and any defect found, such as a cracked lining or a sagging gutter.

Bagging the debris matters for a reason beyond tidiness. Moss and silt pushed into a downpipe can block it lower down, where it is harder to find. Our guide to where the moss goes explains what happens to waste from a roof clean.

A pressure lance is not part of this work, since a jet aimed along a lined valley could lift the edges of the very tiles that frame it, and Marley advises against jets on tile and slate in any case.

If the gutter itself has sagged, split or lost its fall, a clean will not fix it. In that case we tell you, show you the evidence, and quote for the repair as part of one written total price.

Once the channels are clear, the last step is a second set of photographs, shot from the spots used for the first, so that you can compare the before and after for yourself.

What published guides say it costs

These are typical UK ranges from other publishers, not our prices, and none is specific to Hereford. Length of gutter, number of valleys, eaves height, access and what the survey finds in the channels are what move the figure on a real house.

  • Which? (November 2025 survey, ex VAT): clearing out every gutter, front and back, costs "£75-£350".
  • MyJobQuote (2026): gutter replacement averages around £1,000 to £1,600 in the UK, and standard uPVC gutter replacement is around £40 to £50 per metre.
  • MyJobQuote (2026): capping fascias and soffits averages around £800.

Nobody should multiply a per-metre figure by the length of your gutters. The written price you receive covers the whole job, and it should say whether VAT and any scaffold are counted in the figure.

When a quote comes in, ask what it says about the valleys and gutters specifically. A price that mentions the slopes but not the channels may leave the part that causes the damage untouched. Ask also how the debris will leave site and whether the quote covers any repair the clearing exposes. A second visit after the first heavy storm is worth asking about too, since a freshly cleared channel shows straight away whether it drains.

On the question of whether a gutter should be repaired or replaced, a lot depends on its material and fall. A sagging uPVC run with failed joints can be a case for replacement, and a sound run with a blocked outlet needs only clearing. The photographs show you which you have.

Nests and roosts in the channels

Gutters, eaves and valleys are places where birds nest and where bats can roost, so the legal position matters before a channel is cleared.

Birds and bats both use these places, and the law protects them in both England and Wales. A nest that is occupied is left alone until the birds have finished with it, and a roost is never disturbed without advice first. Gutters in particular can hold a nest right at the lip or in a gap in the fascia, so we look along the full run before we lift anything. A stained strip of fascia, or droppings on the paving below, are the usual clues. Once a channel has been cleared, any nest material that remains is left where the birds placed it, and the photographs record the position so that nothing is disturbed by accident on a later visit.

Licensing sits with a different body on each side. Natural England deals with bat licences in England. In Wales, Natural Resources Wales handles bat licensing and expects an application where roof work could affect a roost. If a nest is in use in the channel, that section waits until the birds have gone.

If we see droppings, staining or scratch marks around the eaves or the underside of the valley, we stop. We tell you what we have seen, show you the photographs and explain who to speak to. The signs to look for do not change between England and Wales.

Blocked channels: your questions

Why does my gutter overflow when the downpipe looks clear?

A mat of moss and silt lower down the run can cancel the small fall, which Brett Martin gives as 1mm for every 600mm, and leave water standing until it spills at the low point. The outlet may also be partly blocked. The survey checks the whole length, not only the downpipe.

Can moss in a lead valley cause a leak?

It can hold water on a lining meant to shed it, and packed moss can push water sideways beneath the tiles beside the valley. The survey checks the lining for splits, the cut tiles for slips and the moss beneath, then photographs what it finds before any work.

Do I need a licence to clear a nest from a gutter?

The Wildlife and Countryside Act 1981 protects a nest that is occupied or being built against intentional harm, so we leave it alone until the birds have gone. Bats are a licensing matter: Natural England in England, Natural Resources Wales in Wales. Ask before disturbing anything, and tell us what you saw.

Get your free roof quote

Tell us about the roof and we will arrange a survey.

10-year workmanship guarantee, in writing